模擬方法 的英文怎麼說

中文拼音 [mónǐfāngfǎ]
模擬方法 英文
analogue method
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 擬 : 動詞1. （設計; 起草） draw up; draft 2. （打算; 想要） intend; plan 3. （模仿） imitate
  • 方 : Ⅰ名詞1 （方形; 方體） square 2 [數學] （乘方） involution; power 3 （方向） direction 4 （方面） ...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 模擬 : imitate; simulate; analog; analogy; imitation; simulation模擬艙 boilerplate; 模擬電路 [電學] circ...
  • 方法 : method; means; way; technique; process; procedure; plan; device; recipe; fashion; tool; maneuver
  1. Study on numerical simulation of laser ablation

    連續激光燒蝕效應數值模擬方法研究
  2. Basic theory of adjoining rock plastic rum and numerical simulation method

    圍巖塑性圈的基本理論及數值模擬方法
  3. Method of simulation on determining bottleneck resource

    確定瓶頸資源的模擬方法研究
  4. The frame structure, work flow and 3 - dimensional model building method of the virtual prototype design of the air compressor are presented in detail

    摘要闡述了空壓機虛擬樣機設計的框架結構、工作流程及其三維模型構建方法，進行了設計與運動學模擬方法研究。
  5. On the basis of expound the theory of building exterior - protected construction energy consumption and the gene of influence the building energy, set up mathematics model, this article discuss the mechanism of dispelling the heat of the buildings " thermal bridge and the complication that influence it, and then synthetic analysis and calculate the influence range of building thermal bridge in exterior - protected construction column thermal bridge to the building outer wall get the conclusion that when the construction column can satisfy the building stress - area, in bulgy construction column dispel less heating than out bulgy construction column. but if the pole stuck out more than 100mm, in bulgy or out bulgy make no difference

    本文在闡述建築圍護結構耗熱原理以及影響建築能耗因子的基礎上，採用數值模擬方法，探討了建築熱橋傳熱的基本機理和影響建築熱橋傳熱的因素，進而對建築熱橋在圍護結構傳熱中的影響范圍進行了綜合分析和計算，研究了構造柱熱橋型式對建築外墻能耗的影響，得出了構造柱在滿足建築受力面積要求的情況下，內凸構造柱較外凸構造柱略能減少散熱量的結論，但是凸出過大（ 100mm ）無論內凸還是外凸對建築耗熱都沒有大的差別。
  6. Comparison of two numerical simulation methods for hard - edged diffracted beams

    兩種硬邊衍射光束計算模擬方法的比較
  7. By means of dynamic simulation of multi - body and finite element methods, the influence of the footwell design parameters to lower extremity injuries of the driver in passenger car frontal impacts was studied

    運用多剛體與有限元結合的動力學模擬方法，本文研究了轎車腳艙設計參數對駕駛員在前碰撞中下肢損傷的影響。
  8. A simulation method of fractional - order control systems

    分數階控制系統的模擬方法
  9. Based on chaos circuit, this paper discusses two application modes, random rectangle wave oscillator and chaotic inflator and introduces intensively methods and their results of computer

    基於混沌電路，論述了兩種應用方式：隨機矩形波發生器和混沌振動器，並詳細介紹了計算機模擬方法和結果。
  10. Chapter 1 deals with the numerical simulation method. chapter 2 deals with the monte carlo methods. the monte carlo integration that the domain of integration is curved or complex connected curved polyhedron and the integrand has singular points is discussed in this chapter

    第二章討論了用montecarlo數值模擬方法求積分區域為曲面體和積分區域為復連通曲面體的情形，且被積函數有奇異點。
  11. The distribution of fire smoke temperature, concentration, and visibility was analyzed ; and the airflow movement organization of the shallow embedded island platform during fire was studied

    針對地鐵淺埋島式站臺列車火災情況，利用數值模擬場模擬方法，研究淺埋島式站點內煙氣橫向流動和不同站層間的煙氣縱向蔓延規律。
  12. A simulation method for jacquard fabric

    經編賈卡織物的一種模擬方法
  13. Multi - body systems ' modeling and simulation method for mechatronics design based on vhdl - ams

    的多剛體系統建模與模擬方法
  14. The forward modeling of mudstone fracture

    泥巖裂隙的正演模擬方法研究
  15. The basic principle and method of 3d stochastic modeling of sedimentary microfacies are discussed according to geological and acoustic impedance data of well - logging constrained seismic inversion, and a case study according to stochastic modeling of fluvial facies reservoir of the minghuazhen formation of neocene in a certain block of bohai bay basin is used to show the general process of this research

    摘要探討了綜合應用地質及測井約束地震反演信息進行三維沈積微相隨機建模的基本原理、思路與方法， ?以渤海灣盆地某區塊新近系明化鎮組河流相儲層?例，說明這一研究過程的基本步驟，包括井眼沉積微相解釋、測井約束地震反演、波阻抗與地質相的概率關系分析、隨機模擬方法選擇、地質統計特徵分析、三維隨機建模、隨機模擬預測的多解性評價。
  16. In this pater, we define a new numerical method called the characteristic mixed finite element method for approximating the solution to two kinds of evolution equation

    本文針對兩類發展方程提出一種新型數值模擬方法? ?特徵混合有限元方法。
  17. It is just the difficulty that the strongly correlated electron systems can not be studied by analytical methods, a variety of simulative numerical methods come out sequentially. there are a few typical methods such as the exact diagonalization ( ed ), the qutum monte carlo ( qmc ), the variation monte carlo ( qmc ), the renormalization group ( rg ), and the density matrix renormalization group ( dmrg ) and so on

    正是強關聯系統遇到了解析研究的困難，各種數值模擬方法才相繼出現，最典型的數值方法有：嚴格對角化（ ed ） ，量子蒙特卡洛（ qmc ）模擬、變分蒙特卡洛模擬（ vmc ） 、數值重整化群（ rg ）以及密度矩陣重整化群（ dmrg ）等。
  18. Fortunately, the modern geodetic measurements such as the global positioning system ( gps ) technique can overcome the shortage of the geological and seismographic methods in the time dimension ; and yet, the coverage of the geodetic survey stations is not sufficient. as a result, it is necessary to employ numerical simulation to investigate the continuous deformation of the crust

    而以全球定位系統（ gps ）等技術為主的大地測量方法彌補了地質和地震學方法在時間維上的不足，但大地測量方法存在測點覆蓋不足及測點地理分佈不均勻的缺點，因此，要得到連續的地殼形變場有必要藉助數值模擬方法。
  19. Numerical simulation has emerged recently as an important aid to process and device developments.

    近年來，數值模擬方法作為工藝和器件發展的重要輔助工具已經嶄露頭角。
  20. Study of simulation method to produce noisy signals with high snr accuracy

    一種生成高精度信噪比加噪信號的模擬方法研究
分享友人
分享到 Line

分享到臉書