橫向布置 的英文怎麼說

中文拼音 [héngxiàngzhì]
橫向布置 英文
transversal arrangement
  • : 橫形容詞1. (蠻橫; 兇暴) harsh and unreasonable; perverse 2. (不吉利的; 意外的) unexpected
  • : 動詞1. (擱; 放) place; put; lay 2. (設立; 布置) set up; establish; arrange; fix up 3. (購置) buy; purchase
  • 橫向 : broadwise; infeed; crossrange; abeam;transverse; transverse direction; cross; crosswise; lateral;...
  1. Failure analysis and countermeasure of cutting reducer of coal cutter with lateral arrangement multi - motor

    多電機橫向布置採煤機截割減速器失效分析與對策
  2. 2 ) the structure elements should be laid out symmetrically and uniformly when designing steeve - arch structure, what ' s more, the reasonable selection of section geometric size near the arch foots of first beams is paid attention to and the arrangement difficulties of steel bar due to the big eccentric pressures 2, the analyses of anti - seismic features on transverse direction of the aqueduct l ) the method of adjusting the elements " mass can be harnessed in order to even the layout of seismic loads

    2 )設計吊桿式拱架支承結構時,各部分構件應當均勻對稱。另外,還應注意頭道梁拱腳附近截面的尺寸擬定,克服地震內力造成的大偏心受壓狀態給結構配筋設計增加的困難。 2 、抗震性能分析1 )可利用調整構件質量的方法,使得結構的某些構件的地震荷載分佈均勻一些。
  3. On the basis, the effect of different factors such as the sloping angle of arch ribs, the stiffness of bridge deck system, the effect of non - orientedly conservative loadings of the hanger and tie bar etc is discussed

    此外,採用線彈性方法,就拱的吊桿的非保力效應、橋面系的剛度、形式、拱肋側傾角等因素對該橋整體穩定性的影響展開探討與研究。
  4. The software ansys6. 0 is used to analysis the stability of the state after construction of tongwamen bridge, linear method is used in analyzing the finite element model of the bridge, the coeffient of stability of different state after construction is given. on the basis, the effect of different factors such as the arrangement of lateral brace, the sloping angle of arch ribs, the stiffness of bridge deck system, the effect of non - orientedly conservative loadings of the hanger and tie bar etc is discussed. the different coefficients of stability of changing these factors are given, so the factors that are vital to the lateral stability of x - type arches are found, and the rationality of the methods taken to enhance the lateral stability of tongwamen bridge is evaluated

    本文應用有限元分析商業軟體ansys6 . 0 ,採用線彈性方法,通過對該橋的空間有限元模型進行穩定性分析,得出其成橋運營階段各種工況下的穩定安全系數。在此基礎上,本文還通過有限元模型分析,就拱的矢跨比、吊桿(立柱)的非保力效應、橋面系的剛度、形式、拱肋側傾角等因素對該橋整體穩定性的影響展開探討與研究。文中給出了各因素變化情況下的穩定安全系數,指出了對鋼管混凝土提籃拱穩定性有顯著影響的因素及其合理變化范圍,並對銅瓦門大橋提高穩定性的措施的經濟合理性進行了分析。
  5. He saluted the commander of the escorting partisans and in low, clipped chinese reported that everything was in order for the crossing.

    護送隊長敬了個禮,然後低聲用簡潔的漢語報告越工作都好了。
  6. The article below deals with the mechanism research of this kind of machine, describing the structure and principle ; theoretically analyzing the data to derive formula ; tentatively proposing theory of radial flow between parallel plates for future design ; pores arrangement, i. e., longitudinal pores are equally spaced, horizontal pores bore size is preferred unequal and rows distance can be either equal or not but generally smaller than pores distance, and rows shall be odd numbers and are arranged symmetrical from the center row and bore size reduces gradually from the center row

    本文對氣墊機作了機理研究,描述了氣墊機的結構型式及工作原理,對氣墊機的主參數作了理論分析,根據平行平板間的徑流動理論,建立了計算模型,導出了計算公式,可作為氣墊設計理論的依據;提出了氣孔的原則:縱孔間距相等較好,孔徑不等為佳,孔排距可以相等,也可以不相等,但一般小於孔間距。氣孔排數應為奇數,由中心兩側呈對稱,孔徑由中心兩旁逐漸減小。
  7. Welding position : if the configuration collocation of weld is symmetry and the welding sequence is reasonable, the longitudinal contraction and transverse lateral contraction deformation are usually produced, incontrast, the bending deformation is usually produced

    焊接位:如果焊縫在結構對稱,焊接順序合理時,則主要產生縱收縮和收縮變形,反之,則要發生彎曲變形。
  8. Through the analysis of petrology characteristics and individual well section of sedimentary facies of five core holes, direction of sedimentary source area, the depositional framework and main facies types and its features of penglaizhen formation, baimamiao - songhua area are elaborated on the basis of sedimentary backgroud of region. from this above, in view of the study of the correlation of 3 cross sections of sedimentary facies, it is pointed out that distribution regularities of sedimentary facies and possible places of distribution of sand bodies of iii, iv member of penglaizhen formation are vertically and laterally developed in baimamiao - songhua area. by the analysis and contrast of seven plans of sedimentary facies and nine isopach maps of sandstone, the planar characteristics of distribution of sedimentary facies are summarized, meanwile, macroscopic distribution regularities of sand bodies is studied in iii, iv member, penglaizhen formation of baimamiao - songhua area

    通過5口取心井的巖石學特徵、單井剖面相分析,結合區域沉積背景,闡述了研究區蓬萊鎮組的物源方、沉積格局、主要沉積相類型及其特徵;在此基礎上,通過3條連井剖面的沉積相對比研究,揭示了研究區蓬段、蓬段縱上沉積相的分佈規律及砂體的大體分佈位;通過7張沉積相平面圖、 9張砂巖等厚圖的分析對比,總結了蓬段、蓬段沉積相的平面分佈特徵,宏觀上研究了蓬段、蓬段的砂體展規律。
  9. The kinematic performance of the macpherson suspension on a real vehicle is studied, and the changes of the front wheel alignment and the motion of the front wheel in the longitudinal and the transversal directions are figured. based on the requirements of general layout, a constrained optimization design model is set up with the steering cross rod ball joint position as the optimization variables ( design parameters ), and the sum of steering cross rod length interference while the left front wheel turning and bouncing as the objective function. and the optimization results are worked out by programming on computer

    針對一種實際車型上的麥弗遜式懸架,計算分析了轉輪跳動時前輪定位角和車輪、縱滑移量的變化情況,並根據實際車型上麥弗遜式懸架的空間要求,建立了以轉拉桿斷開點空間位坐標為優化變量,轉拉桿斷開點空間坐標可變化范圍為約束條件,車輪轉和跳動時轉拉桿長度干涉量為目標函數的約束優化設計模型。
  10. Consequently, the precast components don ’ t need any interim falseworks to be supported in the mid - span as bottom forms when the laminated concrete lay is being placed. furthermore, to form two - way slabs, the transverse steels can be arranged through the rectangular cores in the ribs of the precast slabs as needed. it makes the construction of composite two - way slabs easier and more feasible, practical, and suitable to introduce and apply to the building construction on a large area

    由於預制構件具有剛度大和承載力高的特點,施工時以預制構件作為樓板底模無需設跨中臨時支撐;同時還能通過預制構件板肋預留的長方形孔受力鋼筋實現樓板的雙配筋,使預應力雙疊合樓板的施工簡單易行,更適合於大面積的推廣應用,具有較大的工程應用價值。
  11. This paper investigates and presents the design methods for lateral braces between equal spaced columns reducing the effective lengths of the columns to half

    本文探討了一排等間距的承受相同軸力的等截面柱,使柱計算長度減少至0 . 5l時所需水平撐桿的設計問題。
  12. Anilox roller gluses quantificationally and glue evening device after coating, glue circulation system

    高精度網紋輥式塗系統及刮裝,勻膠輥,膠劑循環使用。
  13. In laser beam welding, an appropriate crossjet nozzle should be mounted under the welding head in order to protect the optics from the welding spatter and smoke

    摘要激光焊接過程中,為了保護聚焦鏡和保證焊接質量,通常在聚焦鏡下氣簾噴嘴。
  14. The project mainly solved the problems from the flood control, the morphological diversity of river profile and cross section, and the diversity of habitats in the river through the layout of shoreline and structures, the design of river profile and cross section, the design of riverbank protection, which is one effective engineering practice of eco - hydraulic engineering

    治理工程在岸線、沿河建(構)築物、河流縱斷面設計、岸坡防護設計等方面解決了防洪安全、河流縱形態多樣性、斷面形態多樣性以及河流內棲息地多樣性等問題,是生態水工學理念的一次有效工程實踐。
  15. Based on the analysis of the current status of highway bridge security examination of native and abroad, combing with the construction plan and operation condition of the highway bridges in hubei, this paper discusses the principle and method of highway bridge security examination, especially analyzes the relation of the traffic security with the facts such as the width of lane, transverse arrangement, security devices, environment and the geometrical line type which is formed by the longitudinal transverse technical target of bridges, and then raises the principle, content and program of the highway bridge security examination, in addition, this paper applies the bridge security examination to plan, design, construction and operation

    本文以國內外公路橋梁安全審查現狀分析為基礎,結合湖北省公路橋梁規劃建設與運營狀況,對公路橋梁安全審查的原理和方法進行了探討,重點分析了橋梁平縱技術指標組合構成的幾何線形、行車道寬度及橫向布置、安全設施、環境及其他相關因素等與交通安全的關系,提出了公路橋梁安全審查的原則、內容及程序,並分別對規劃、設計、施工及運營中的橋梁安全審查進行了具體應用。
  16. 4. it is shown from the dynamic test results that the effects are different at the different places with the same load, the impact changes with the different velocity of the truck, which affects the deflection of the bridge. 5

    4 、從此次動載試驗結果可以看出,同一荷載橫向布置不同,對橋梁結構的動力影響不同,不同車速對橋梁沖擊作用不同,會使橋梁結構的動撓度發生變化。
分享友人