橫向進磨 的英文怎麼說
中文拼音 [héngxiàngjìnmó]
橫向進磨
英文
infeed-
Metal & flexible stencil was etched by two positive graphics through two sides and the erodent was done in the direction of horizontal and perpendicularity
金屬模板和柔性金屬模板是使用兩個陽性圖形通過從兩面的化學研磨來蝕刻的。在這個過程中,蝕刻不僅按設計的垂直方向進行,同時在橫向進行。Various anatomical structures were dissected. the distance between these structures and the underlying venous sinus was measured on the cadaveric heads. using 4. 5 loupes magnification, the occipital condyle was dilled to the intracranial end of the hypoglossal canal from posterior laterior margin according to the procedures of far lateral approach, then the length of remainder was measured
對15個10福爾馬林固定的成人屍頭標本進行解剖:測定橫竇、乙狀竇、竇匯顱骨外表面標志,自后外向前內磨除枕髁至顯露舌下神經管內口,測量所需磨除的枕髁范圍。Additional, by comparing with conventional bogie, it is discovered smaller lateral body acceleration, but sticks to one rail trends and high vvorn values because of guided by vvheel flange. it should be referred that these results are only useful to special simulation model of lrv with irws in this paper
此外,通過與常規轉向架進行比較發現,獨立旋轉車輪車輛車體橫向加速度較小,但有貼靠軌道一邊行駛的傾向,且由於靠輪緣導向,使得獨立旋轉車輪轉向架的整車磨耗比傳統輪對轉向架的略大一些。Then, an optimal design to minimize tyre wear is performed, which brings forward the way to reduce tyre wear through optimal choosing and modulating original deposition of double - link independent suspension and optimizing the cut point of track rodin
論文對雙橫臂獨立懸架參數提出以減小輪胎磨損為優化目標,進行了優化設計。提出了通過優選、調整懸架初始位置狀態,以及優化確定轉向橫拉桿斷開點位置的方法,來減小輪胎磨損。分享友人