檢波電路 的英文怎麼說

中文拼音 [jiǎnbōdiànlù]
檢波電路 英文
detecting circuit
  • 檢 : Ⅰ動詞1 （查） check up; inspect; examine 2 （約束; 檢點） restrain oneself; be careful in one s c...
  • 波 : Ⅰ名詞1 （波浪） wave 2 [物理學] （振動傳播的過程） wave 3 （意外變化） an unexpected turn of even...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. Using ewb to simulate amplitude modulation and detection

    對振幅調制與檢波電路進行模擬
  2. In the blue print of the analog, author utilize the big dynamic vga to realize the if amplifier and use the audion to carry out the 80db agc, through the improvement of the traditional detect circuit, extend the dynamic range of the detector

    在模擬方案中，筆者採用了大動態的vga實現中頻放大;利用三極體檢波實現了80db的agc控制;通過對傳統二極體檢波電路改進，提高了檢波器的動態范圍。
  3. By taking the miniature ceramic rod which is easily to machine high accuracy as sensitive structure, and by printing and polarizing six belt - shaped electrodes above it to constitute three pairs of electrodes, this paper designed package and the phase - sensitive detection circuit in the system so that it effectively reduced the sensitive structure size and improved its processing precision to realize the angular rate gyro microminiaturization

    首先採用易於加工成高精度的微型陶瓷棒作為敏感體，在其上印刷成六個帶狀電極並予以極化構成三副電極對，然後設計了封裝及相敏檢波電路，從而有效地減小了敏感結構的尺寸，提高了其加工精度，實現了角速率陀螺微型化。
  4. Based on the character of ultrasonic spectrum analysis, considering the affection of the circuit responsion of checking system, coupling state, position of checking transducer, this thesis established reasonable ultrasonic spectrum analysis method. using this method, several kinds of linear spectrum ( such as phase amplitude spectrum, phase power spectrum ) were researched and discussed

    本文根據超聲波頻譜分析的特點，綜合考慮了檢測電路響應、耦合狀況、探頭位置等因素的影響，制定出了一套合理的超聲波頻譜分析方法，並用此方法對幾種線性譜（如相位幅度譜、相位功率譜等）進行了研究和探討。
  5. Eddy - current sensor conversion circuit consist amplification circuit, band - pass filter circuit, demodulation circuit, differentiation phase and data sampling circuit. these circuits are used to convert the test signal of eddy - current sensor to discrete signal tend to process. the microprocessor system that formed of dsp chip is used to data fitting of test system, data displaying and data communicating with personal computer, etc. the interference questions of hardware design and the measure of eliminating interference signal in the subject are introduced in the last of this chapter

    硬體電路的設計主要分三大部分來實現：激勵源電路部分，由分頻電路和頻率合成電路組成，產生頻率穩定的激勵信號以確保檢測任務的正常進行；傳感器變換電路部分，由放大電路、濾波電路、檢波電路、鑒相電路和數據採集電路組成，主要將電渦流傳感器檢測線圈檢測到的信號變換成只含有被測信息的離散信號，易於后續電路處理；由dsp晶元構成的微處理系統，主要完成檢測系統的數據擬合、顯示及與主機通信等功能。
  6. The hardware is composed of the selection of sensor, magnifying circuit, filter circuit of multi - plot tracing, shaping circuit, demodulation circuit, peak value holding circuit, and voltage comparing circuit

    硬體部分包括傳感器的選擇、放大電路、多點跟蹤濾波電路、整形電路、檢波電路、峰值保持電路、電壓比較電路。
  7. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流，兩者產生的偏置磁場在控制線圈產生感應信號，檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號，該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號，再由pid控制器轉換為轉子位移的控制信號，最後控制信號輸入功放電路產生控制電流，實現閉環控制。
  8. 7 in order to improvement the performance of the whole system and reduce the cost, a new signal processor is given, which based on the new pulse count method brought forward by the author

    從系統聯調的測試結果可以看出，利用自適應檢波電路，可以大大改善基於脈沖計數新方法的雷達信號處理機的性能，使得雷達系統的測距精度大大提高。
  9. This paper developed a micro angular rate gyro based on micro piezoelectric ceramic rod structure instead of the sensitive double - deck structure as well as piezoelectric ceramic strain foils, and designed a phase - sensitive detection circuit

    摘要研製了基於微型壓電陶瓷棒結構代替雙敏感梁結構及壓電陶瓷片的微型角速率陀螺，並設計了相敏檢波電路。
  10. An adaptive demodulation circuit is also given to reduce the affection of the noise, the interference and the instability of the signal

    目前，採用自適應檢波電路的處理機己經在工業用避碰雷達中獲得應用。
  11. Colour detect circuit

    彩色信號檢波電路
  12. Average detection circuit

    平均檢波電路
  13. The analysis and design of tag detector are presented. the characteristics of the tag are improved and the tag obtained use in practice

    對電子標簽的檢波電路進行分析與設計，有效地改進了電子標簽的性能，並用於工程實際。
  14. It is introduced the structural design, working principles and performance of the four circuits of the module, i. e. synchronous circuit, trigger - transmitter circuit, clipping - amplifying - detection circuit and gain control circuit

    文中主要介紹了構成該電路模塊的同步電路、觸發發射電路、限幅放大檢波電路、模塊增益調節電路等4種電路的結構設計、工作原理及性能特點。
  15. The effect of the hardware system is ensured through the reasonable designation of a band - pass filter coefficient, and several simulations and experiments for this detecting circuit

    通過合理設計帶通濾波器參數，並在對檢測電路的模擬和多次實驗的基礎上，實現了心電信號的有效檢測。
  16. Firstly, the temperature varies in a large range in the place where the gap sensor works, so this paper analyzes the temperature drift of gap sensor, and finds out that the main reasons which result in temperature drift are the resistance of detecting coil and demodulating circuit parameters. to resolve this problem, a practical design of detecting coil is given, and a compensative measure considering the detecting coil and demodulation circuit is proposed to improve the temperature stability of gap sensor

    首先，針對間隙傳感器工作環境溫度變化較大的情況，本文對間隙傳感器溫度漂移現象進行了分析，認為檢測線圈電阻和檢波電路參數變化是造成傳感器溫漂的主要原因，建立了檢測線圈的數學模型，提出了檢測線圈和檢波電路綜合補償方法，解決了間隙傳感器的輸出信號溫度穩定性的問題。
  17. For above problems, i design boole process - based algorithm. for example, hazards finding theory work out a formal method of finding hazards by waveforms computing ; waveforms increasing algorithm settle the defect of boole process in feedback cycle treatment ; false paths discerning algorithm can delete useless nodes in netlist effectively ; inertia conflict eliminating method describes the state of nodes truelier and reduces computing

    其中，冒險檢測定理給出了通過波形運算檢測電路中冒險現象的哈爾濱工程大學碩士學位論文形式化方法;波形遞增演算法解決了boole過程在處理電路中反饋環問題上的缺陷;偽路徑識別演算法能夠有效地去除電路網表中的無用節點;而慣性沖突消除法能使對節點狀態的描述更加真實，並減少了計算量。
  18. The hardware is based on mpu. the circuits can magnify the weighting sensor signals, the - bioelectrical impedance signals, ecg signals and detect the qrs. there are the lcd and interface circuits

    硬體設計以單片機為平臺，設計了壓力傳感信號、生物阻抗信號、心電信號放大電路和qrs波的檢出電路，同時還有液晶顯示電路及單片機的介面電路。
  19. Finally, this paper brings forward to the betterment means for making sensor probe. the circuit of signal procession module are introduced. it expounds the important parts, for example, design of oscillatory, design of demodulation circuit, design of signal filter circuit

    介紹了研製的傳感器信號處理模塊電路，對電路中的重要部分如：高穩振蕩源的設計、檢波電路設計、濾波電路設計等都有詳細說明。
  20. In the design, the diode of agilent ' s hsch - 9161 is used. with the diode circuits in parallel, the millimeter - wave short pulse detector has been designed. it works at the frequency of 37 to 38ghz, and the pulse duration is 400ps

    本文採用agilent公司的hsch - 9161檢波二級管，選取二極體並聯檢波電路形式，完成了工作頻率為37 ~ 38ghz 、脈沖寬度為400ps的毫米波短脈沖檢波器的研製，同時設計了一個毫米波短脈沖調制器。
分享友人
分享到 Line

分享到臉書