比例流量試驗 的英文怎麼說

中文拼音 [bǐlìliúliángshìyàn]
比例流量試驗 英文
scaled flow test
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 比例 : 1. （長度上縮小和放大的倍數） scale; scaling 2. （比率） proportion; ratio; proportionality
  • 流量 : rate of flow; flow; runoff; discharge; throughput; （flow） rate; quantity （of flow）; flux
  • 試驗 : trial; experiment; test
  1. The improvement system is made up of the pressure sensor, flow sensor, displacement sensor, electro - hydraulic proportional flow control valve, power amplifier, data gathering board and computer. the platform can carry out testing the hydraulic parameters, processing the tested data, saving the processed data and drawing, adjusting the pressure automatically

    改造后的測控系統主要由壓力傳感器、流量傳感器、位移傳感器、比例節流閥、功率放大器、數據採集卡和計算機組成。改造后的實驗臺具有自動採集實驗數據、自動處理實驗數據、自動保存實驗數據、自動調節液壓系統負載壓力等功能，大大提高了實驗臺的工作效率、測試精度和智能化水平。
  2. Test methods for electro - hydraulic proportional bypass flow control valves

    電動液壓比例旁通流量控制閥試驗方法
  3. Except for types of stationary phase, components of mobile phase and types of detectors, other prescribed conditions under each type, such as internal radius and length of chromatographic column, brand of stationary phase, carrier granularity, flow speed of mobile phase, as well as proportion, column temperature, volume of incoming samples of different components of mixed mobile phase and sensitivity of detector can be appropriately changed to accommodate different chromatographic system and reach requirements for applicable test of the system

    各品種項下規定的條件除固定相種類、流動相組成、檢測器類型不得任意改變外，其餘如色譜柱內徑、長度、固定相牌號、載體粒度、流動相流速、混合流動相各組成的比例、柱溫、迸樣量、檢測器的靈敏度等，均可適當改變，以適應具體的色譜系統並達到系統適用性試驗的要求。
  4. In the process of the deposition of the pyrolytic graphite grid ’ s rough, experiment which adopts same discharge and proportion of those gases at different temperature has been done, the test which adopts different discharge and proportion of those gases at same temperature to deposit grid ’ s rough has also been done. at same time, the test which adopts different dilute gases at same technological condition to deposit the grid ’ s rough has been done. in order to obtaining the grid ’ s rough which thickness is able to use, the test has been done at different temperature and depositional time

    在研究過程中，試驗了在不同溫度下採用相同的氣體比例和流量沉積熱解石墨柵極毛坯;還試驗了在相同溫度下，採用不同的氣體比例、不同的流量沉積熱解石墨柵極毛坯;同時，試驗了在相同工藝條件下採用不同的稀釋氣體沉積石墨柵極毛坯;為了獲得厚度合適的石墨柵極毛坯，試驗了不同溫度下採用不同的沉積時間來沉積毛坯;對不同溫度下沉積的毛坯進行了x射線衍射分析、密度分析及晶相分析。
  5. Flow pulsation of a specific gear pump is analyzed and the results are given. according to the testing requirement of pump pulsation, the measurement device of the testing flow pulsation, based on iso 10767 - 2 measurement standard, the measurement device of flow pulsation testing is built. high speed dynamic pressure transducer is used to record the pressure pulsation in the pipeline

    然後根據齒輪泵流量脈動的檢測要求，採用iso10767 - 2測試方法，搭建了齒輪泵流量脈動測試裝置，採用動態壓力傳感器，對齒輪泵系統進行了壓力脈動測試，利用壓力脈動與流量脈動的比例關系，對齒輪泵流量脈動分析結果進行了驗證。
  6. Test methods for electro - hydraulic proportional series flow control valves

    電動液壓比例串聯型流量控制閥試驗方法
  7. With the development of test - machine technology, in recent years electro - hydraulic universal material test - machine of the country inside and outside develops three different control modes : electro - hydraulic servo valve ' s control ; adopted the pressure valve ' s control with speed controller ; proportion valve ' s control of wide flux

    隨著試驗機技術的進步，近年來國內外電子液壓萬能試驗機發展了三種不同控制方式：電液伺服閥控制、採用具有速度控制器的壓力閥控制和寬流量范圍的比例閥控制。
  8. And then, a method of load - flow low - pressure measurement was proposed in the light of the hydraulic - resistance theory of servo valve. the validity of the method was proved by the experimental results. therefore, the measurement of the characteristic of load - flow and no - load flow can be realized by using this method

    然後根據電液伺服閥的液橋理論提出了一種負載流量低壓測量方法，在所開發的測試系統上，利用電液比例閥模擬流量測量裝置對所提出的方法進行了試驗驗證，實現了利用低壓流量計和壓力傳感器進行電液伺服閥負載流量特性和空載流量特性的測量。
  9. Test methods for electro - hydraulic proportional directional bypass flow control valves

    電動液壓比例定向旁通流量控制閥試驗方法
  10. In order to solve the problems that large energy consumption, temperature variation, high, cost trouble maintenance in current electro - hydraulic servo control system for material testing machine, a new design scheme that electro - hydraulic proportional control system for material testing machine based on extension control strategy is proposed. the design scheme is successful by means of designing new main frame system, hydraulic cylinder system, digital electro - hydraulic micro - fluid proportional valve and electrical control system, and its results lay a foundation for material testing machine industries in our country

    針對國內外材料試驗機主要採用電液伺服控制系統，存在能耗大、溫升、成本高、維護困難等問題，本課題提出了基於可拓控制策略的材料試驗機電比例負載適應控制系統這一新型研究方案，通過開發新型試驗機主機系統、液壓缸系統、數字式微小流量電液比例流量閥及電控系統，實現了材料試驗機電液比例負載適應控制，為我國材料試驗機自動控制系統的產業化打下了基礎。
分享友人
分享到 Line

分享到臉書