氣力式調節器 的英文怎麼說

中文拼音 [qìlìshìdiàojiéqì]
氣力式調節器 英文
pneumatic governor
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 節 : 節構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 氣力 : effort; energy; physical strength
  • 調節器 : regulator; adjuster; governor; controller; conditioner; actuator; phaser
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. Long - hole and geometrical proportion type of mixing unit is finally adapted in lpg supply system, and power and torque output of lpg engine are improved by increasing compression ratio, and ignition characteristic is tried to adjusted to satisfy engine performance. meantime emission performance and noise level of lpg engine at full - throttle and other various part - throttle operations are tested and compared with former gasoline engine. ( 3 ) it is verified by engine dyno tests that lpg engine has better synthesized performance at aspects of power and torque, fuel economy, as well as emission than former gasoline engine

    選擇了等比例長孔式混合器控制空燃比；通過提高壓縮比來彌補動力性的損失；以動力性為主控目標，對最大功率點、最大扭矩點、中等轉速、最低轉速點所對應的發動機轉速做了點火特性的調節；通過空燃比的合理控制，直接改善發動機的動力性、經濟和排放指標；作為對缸內燃燒過程的理論分析，進行了燃燒特性的實驗測試；對原汽油機和新開發的液化石油氣發動機，進行了外特性和部分負荷特性以及怠速的排放及噪聲對比性測試。
  2. The structure and operating principle of an air - charged split - type adjustable shock absorber was described, e non - linear parameterized mathematical model of this shock absorber ' s damping characteristics was established according to fluid mechanics theory and the main structural affection factors to shock absorber ' s damping performance, such as the diameter of piston valve orifice, the diameter of adjustable orifice, the initial volume of gas chamber, the diameter of piston rod, the inner diameter of oil pipe and so on, were analyzed by simulations

    摘要通過分析一種分體式充氣可調阻尼減振器的結構和工作原理，運用流體力學理論，建立了該減振器阻尼特性的非線性參數化模型，模擬分析了活塞阻尼閥孔徑、阻尼調節孔徑、氣室初始體積、活塞桿直徑、油管內徑等主要結構參數對減振器阻尼性能的影響，通過試驗測試，得到了減振器樣件的阻尼特性及其可調范圍。
  3. Our portable compressors are equipped with pressure regulators with filter and lubricators to ensure the most effective use of specific tools

    我們的便攜式壓縮機有空氣過濾和自動潤滑裝置，裝有壓力調節器保證最有效的適應工具的使用。
  4. The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced

    論文第二章首先簡單介紹了交流異步電動機變頻調速技術的發展概況，在回顧電梯液壓控制系統節能技術的基礎上，介紹了本課題研製的「採用蓄能器的液壓電梯變頻節能控制系統研究」的基本原理，分析了動力系統在電梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式；詳細地介紹了本課題節能系統液壓動力泵站的結構設計和參數設計，重點研究了液壓動力泵站的結構設計、液壓泵馬達可逆性問題及其選型設計計算、蓄能器迴路泄漏油損失機理的研究及其補償裝置的設計、蓄能器-泵馬達壓力能量轉換裝置的設計、多功能集成控制閥組的設計等內容；最後簡單介紹了本課題矢量控制變頻控制櫃的外部附件電氣接線、計算機控制及數據採集系統的硬體設計等內容。
  5. The technologies, including collecting the secondary fume by electrostatic precipitator on roof, restraining the open fume by dust inhibitor and treating the mobile fume by movable ventilation installation, are emphatically described. the adjustment and control of the gas flow and the pneumatic conveyance of the dust would be widely used in dust collecting system. as to the dust collector, low pressure pulse long bag filter and surface filtering technology would be a new technique in bag filter, and enlarged equipment would be the developing trend

    著重講述了屋頂除塵器、抑塵劑、移動通風槽分別是二次煙塵治理、開放性揚塵抑制、移動塵源控制的新技術措施，風量調節與控制、氣力輸灰技術將在除塵系統中廣泛應用；在除塵設備方面，長袋低壓脈沖袋式除塵技術和「表面過濾」技術成為袋式除塵新技術，設備大型化將成為方向。
  6. Our portable compressors are equipped with pressure regulators with filter and lubricators in order to make the best use of the specific tools of professional applications

    為了能使專業工具得到充分的利用，我們的便攜式壓縮機裝備有空氣過濾器自動潤滑裝置和壓力調節器。
  7. In order to release the pressure wave, the new - type pressure control technology which borrow ideas from airplane ' s cabin pressure control program is analog tested

    模擬試驗系統主要由模擬車廂、進氣系統、車外環境模擬系統、間接式氣動壓力調節器及數據採集系統五個子系統組成。
  8. With pid, air - inlet simulation control software is programmed at the same time, which can control the total temperature and pressure of the air - inlet efficiently. in addition, the parameter calibration of the engine and the experimental database are accomplished

    基於pid控制器開發了溫度、壓力調節控制軟體，能根據試驗要求自動地調節空氣和燃油的流量，實現進氣溫度、壓力模擬和試驗過程式控制制。
分享友人
分享到 Line

分享到臉書