氣流管道 的英文怎麼說

中文拼音 [qìliúguǎndào]
氣流管道 英文
airflow line
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 道 : Ⅰ名詞（道路） road; way; route; path 2 （水流通過的途徑） channel; course 3 （方向; 方法; 道理） ...
  • 氣流 : 1 [氣象學] air current; airflow; wind current; airstream2 [語言學] breath氣流紡紗 open end spinni...
  • 管道 : [工業] pipeline; channel; tunnel; piping; canalis; pipe run; duct; conduit; conduit pipe; ducting...
  1. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力
  2. The non-bleed controller uses air only when exhausting the line to the controlled device.

    無放流式調節器只有在通至調節機構的管道排氣時才消耗空氣。
  3. The paper mainly consider the followings : the performance parameter determination of cryopump, heat load determination and heat transfer of large cryopanel, reasonable distribution of heat load, the condition for construct steady flow in small vertical circle pipeline, balance condition for gas and liquid two - phase flow in the connection pipe between cryopanel and dewar, the safety of cryopump

    文中探討了低溫泵性能參數的確定；大抽速低溫抽氣面的熱負載的確定及合理分配；冷凝面上豎直圓管內受熱建立穩定流動的條件；冷凝面與杜瓦間的連接管道內氣液「雙相流動」的平衡條件；低溫泵系統運行的安全問題。
  4. Abstract : the paper introduced the theory of piping transportation of the 1 500 deadweight ton bulk cement barge, and provided the numeration and selection method of main parameters, such as pipe diameter, wind pressure, flux, etc

    文摘:介紹了1500t散裝水泥運輸船的水泥管道輸送原理，給出了該船上壓縮空氣管、流化空氣管和水泥裝卸管的管徑、風壓、流量參數的計算和選用方法。
  5. Firstly, simulate flow field of rear smoke channel, plot velocity magnitude and ash concentration distribution in section of entry of heat pipe air preheater, compare with data which were measured in guiyang power station, verify simulation to be reasonable and right. secondly, simulate all kinds of factors which affect flow field ' s uniformity such as length, thickness, location of diffluent board, ash concentration, ash diameter, and so on, find the chiefly factors. thirdly, install guide board in curve channel in rear smoke channel, then simulate its " flow field, plot velocity magnitude and ash concentration distribution

    在此基礎上模擬在冬夏兩季不同情況下，不同流速對熱管空氣預熱器壁面溫度的影響；然後對影響整個流場分佈的各種因素：包括分流板長度、厚度、偏離中心流道位置的偏離度、飛灰濃度、飛灰粒徑等因素進行數值模擬；最後提出在分流煙道轉彎處加裝導流板，並模擬加裝導流板后的流場分佈，得到下級空氣預熱器出口、熱管空氣預熱器進口處的斷面速度場分佈、濃度場分佈，以論證加裝導流板能達到流場均勻化的作用。
  6. Heated air is forced into the upper tier of ducts.

    加熱的氣流被送入上面的一排管道。
  7. At the same time, combining the electrostatic measurement principle and the actual working conditions of pneumatic pipelines, the author puts forward the design principle in theory and finishes the devising, executing, debugging, experimenting and analyzing the experiment phenomena and results, testing the feasibility of the electrostatic sensor to be used in the measurement on the mass flow rate of the coal paniculate. furthermore, with the debugging and experimenting of the system, the author improves the electrostatic sensor and its signal collecting system gradually according to the problems, and makes the performance of the system to be enhanced remarkably

    同時，作者結合靜電測量原理以及氣力輸送管道的實際工況，從理論上提出了靜電傳感器的設計依據，完成了靜電傳感器及其信號採集系統的設計、製作、安裝、調試和實驗，分析了實驗現象和結果，驗證了靜電傳感器用於煤粉質量流量測量的可行性，並且通過系統調試和實驗，針對發現的問題對靜電傳感器及其信號採集系統不斷地進行了改進，使其性能有了顯著地提高。
  8. The pressure at every point along the pipeline, the gas - liquid phase flow rate and the law of the liquid holdup in the pipeline chang ing with time in the process of gas storage and supply at the time of peak shaving are simulatively calculated, and based on this, the problem on peak shaving is thoroughly analyzed by combining with the existing pinghu - shanghai gas pipeline in china

    模擬計算了調峰過程中管道儲氣和供氣過程沿線各點的壓力、氣液相流速和管內持液率隨時間的變化規律，據此結合我國已建成現有的平湖一上海的天然氣管線，對調峰問題作了深入地分析。
  9. In this paper, starting from the basic law of fluid me chanics, a mathematical model equation for describing the tran sient flow of the wet gas in the pipeline under peak shaving op eration is established, a simplified treatment for the model equa tion is made and a train of thought for concrete calculation is de signed

    文章從流體力學的基本規律出發，建立了描述濕天然氣管道輸送調峰工況下瞬變流的數學模型方程，並對模型方程作了簡化處理，設計了具體的計算思路。
  10. The state analysis of subsonic gases in gradually reducing pipelines

    漸縮形管道中亞音速氣流的物態分析
  11. Plastics piping systems. fittings, valves and ancillaries. determination of gaseous flow rate pressure drop relationships

    塑料管道系統.配件閥門和輔助設備.氣流率壓降關系的測定
  12. Plastics piping systems - fittings, valves and ancillaries - determination of gaseous flow rate pressure drop relationships

    塑料管道系統.管件閥門和附件.氣體流速與壓降之間關系的測定
  13. Plastics piping systems - fittings, valves and ancillaries - determination of gaseous flow rate pressure drop relationships ; german version en 12117 : 1997

    塑料管道系統.配件閥門和附件.氣流和壓降關系的測
  14. Acoustics - measurement of insertion loss of ducted silencers without flow - laboratory survey method

    聲學.無氣流管道消聲器插入的損耗測量.實驗室調查法
  15. Numerical study of the ribbed - duct anti - erosion efficiency in gas - solid flows

    氣固管道流動中肋條防磨效率的數值研究
  16. This research is to eject some compressed air into the dredging pipe to get tri - phase flow in the pipeline, and research the change about the pipe resistance, at the same time, obtain the more effect adding gas method and realize reduction friction and prolong the dredging distance

    本文研究的目的是在一定的漿體流速和漿體濃度下向輸送管道中加入一定量的氣體，在管道中形成三相流，進而探討加氣后管道流動的變化規律，同時確定出比較有效的加氣方案，從而實現減少阻力延長排距的目的。
  17. Acoustics - determination of insertion loss of ducted silencers without flow - laboratory survey method iso 11691 : 1995 ; german version en iso 11691 : 1995

    聲學.無氣流管道消聲器插入損失測量.實驗室測量法
  18. In order to know the relationship between gas - content and pipeline ' s pressure drop, the thesis deduces the pressure drop calculating equations based on uniform flow pattern and separating flow pattern. the equations show that pressure drop is made up of three parts, that is, friction resistance effect, gas acceleration effect and the gravity effect. and the research has shown that the gas has little effect on pressure drop. in the horizontal pipeline, the resistance effect must be overmatched the acceleration effect

    為探討加入的氣體對管道壓力的影響，本文基於分相流和均相流兩種模型分別推導了三相流管道的壓降公式，表明無論是分相流模型，還是均勻流模型，管道內流體總的壓降是由三項組成的，即摩擦項、加速項和重力項，並得出了加氣對管壓變化不大的結論，所以認為在水平管道中，要獲得有效的減阻，則要使摩擦阻力分量的減小效應大於漿體加氣的加速效應。
  19. Flow - metering devices for connection to terminal units of medical gas pipeline systems ; german version en 13220 : 1998

    與醫用氣體管道系統的終端裝置相連接的流量測量設備
  20. Flow - metering devices for connection to terminal units of medical gas pipeline systems, adoption of iso 15002 as an american national standard with deviations

    與醫療氣體管道系統終端裝置相連的流量測量裝置.採用iso 15002作為美國國家標準
分享友人
分享到 Line

分享到臉書