汽化器加熱 的英文怎麼說

中文拼音 [qìhuàqìjiārè]
汽化器加熱 英文
carburettor heat control
  • 汽 : 名詞1. （由液體或某些固體變成的氣體） vapour2. （水蒸氣） steam
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 汽化 : [物理學] vaporization; evaporation; carburate; boil off; nebulization汽化計 atmidometer; evaporat...
  1. The flow diagram of a lpg bottle paint - drying heating system using heat carrier as heat - medium, which has similar properties as other heat - carrier heating systems, has been improved, which has good effect in avoiding oil - spraying, shortening dehydration time and power - fail protecting etc. after making a series of analysis, calculational methods of expansion tank dimension have been deduced, which takes the moisture boiling - off of heat carrier into account and accords with real conditions

    對與其它熱載體加熱系統具有共性的鋼瓶熱載體加熱系統的流程圖進行了改進和完善，在防止噴油、縮短脫水時間和停電保護等方面取得了良好效果。通過分析，整理出了熱載體加熱系統膨脹器容積的計算方法，該方法考慮了熱載體所含水分汽化而帶來的影響，比原有的計算方法更加符合實際。
  2. The new developments of htm station technique were introduced from the aspects such as changing the htm pipeline type in pet htm station, increasing the switch forms of steam atomization and compressed air atomization, increasing the steam generator, sending stripping tower off - gas to combination and using new material nd steel in air preheater

    摘要從改變聚酯熱媒站的熱媒爐熱媒管線形式、增加蒸汽霧化與壓縮空氣霧化的切換形式、增加蒸汽發生器、汽提塔尾氣送燒、空氣預熱器採用新型材質nd鋼等方面介紹熱媒站技術的新發展。
  3. Oil fired bath water heaters with vaporizing burners

    裝有汽化燃燒器的燒油的洗澡水加熱器
  4. Abstract : the causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    文摘:分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  5. The causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  6. In view of results obtained in the work, the commonly 共同 made assumption 假定 of equality 均等 of heat transfer coefficients for both the bundle and its additional surface may lead to certain 確定 errors 誤差 in heat transfer calculations and discrepancies between the calculated values of heating surfaces area and later operational needs of steam generator

    在工作得到的結果，傳熱系數的做法為捆綁和它附加的表面在熱傳遞演算也許導致某些熱化表面的誤差值和蒸汽發電器之間的錯誤和差誤。
  7. Through the analysis and research of henan input ? output table, i confirm the candidate industrials which can be grow up to the key industrials of henan in the future. the list includes agriculture, metal mine selection, food manufacture and process, chemical industry, mechanic industry, textile industry, the manufacture of electric power stream and hot water, transport equipment manufacture, electric and mechanic equipment manufacture, electrommunication equipment manufacture, instrument manufacture, freight and post

    通過對1992年和1997年河南省投入產出表的分析研究，確定了未來可以作為河南省主導產業的候選產業部門為：農業、金屬礦采選業、食品製造與加丁業、化學工業、機械門k 、紡織業、電力及蒸汽熱水生產、交通運輸設備製造業、電氣機械設備製造業、電子通訊設備製造業、儀器儀表製造業和貨運郵電業。
  8. The paper adopts active measure, reconstructs parts on the equipment, and come up with micro - computer controlling system which will be used on the domestic oil heaters, taking into account the change of users ' needs and the current situation all over the world, based on machanism of emission producing and theorizition of combustion

    本研究採取主動措施，根據污染物的生成機理、傳熱學、燃燒理論等，針對該設備的部分結構進行了合理改進，並按照用戶使用要求的變化以及國外的發展狀況，提出了在國產汽車燃油加熱器上採用微型計算機控制的技術方案。
  9. The dried material is put into the middle of shell, mixing by the rake teeth and the material shaft works back and forth. the indirect heating, equal agitation of rake teeth and grinding of breaking stick makes water in material evaporation. under the effect of vacuum system, the water in the dried material and apparent water are discharged and the vapor water is discharged from outlet of vacuum pump passing dry dust collector, wet dust collector and condenser

    被乾燥物料從殼體上方正中間加入，在不斷正反轉動的耙的攪拌下，物料軸向來回走動，與殼體內壁接觸的表面不斷更新，受到蒸汽的間接加熱，耙的均勻攪拌，粉碎棒的粉碎，使物料內的水份氣化，在真空系統的作用下，使被乾燥物料內部水份和表面水份更有利的排出，氣化的水份經乾式除塵器濕式除塵器冷凝器，從真空泵出口處放空。
  10. Liquid petroleum products - determination of benzene content in liquid fuels for mobile heaters - method by capillary gas chromatography

    液化石油產品.汽車加熱器用液體燃料中苯含量的測定.毛細管氣相色譜法
  11. The testing result of the sample machine proved that design scheme and the control scheme in this study is reasonable and safe, if made products and popularized, it will greatly improve the environment protection performance and economic performance security and reliability of sample machine, so can improve the technical level of homemade bus

    樣機試驗證明本研究所採用的設計方案和控制方案合理、安全，若進一步產品化和推廣使用，將大大改善國產汽車加熱器的性能，提高整機的環保性、經濟性、安全性和可靠性，從而提高國產客車的整車技術水平。
  12. The one of the loss of effectiveness is the friction piece ' s bum of the clutch, there fore, in the designing of priority, the clutch ' s with of friction power is smaller than the permitted value in the reduction of the starting the truck, and it also increases the permitted condition of decreasing cloth ' s friction hot volume

    選擇出摩擦片最佳參數，並保證離合器的機械性能是摩擦片參數優化的目標，本課題中由於失效形式之一是離合器摩擦片燒傷。因此，在優化設計中除保留減少汽車起步過程中離合器的單位面積滑磨功小於其許用值的約束條件外，還增加了降低離合器的滑磨熱容量的約束條件。
  13. In the second part, the reliability research on electronic packaging was concentrated with finite element method ( fem ) on moisture diffusion in plastic materials, die cracking of flip - chip with no - flow underfill and thermal performance of high power electronic components. in the last chapter, the design tool for advanced electronic package was studied. the main conclusions in the second part are as follows

    論文第二部分電子封裝可靠性研究包含對塑封材料中水汽擴散研究、填充不流動膠的倒裝焊晶元可靠性研究以及大功率器件散熱問題研究三方面內容，最後為實現封裝設計標準化和自動化，研究了若干最主要的電子封裝構型的參數化有限元建模、加載和相應的求解方法。
  14. Condenser and evaporator are the main equipments in the refrigerant system. to modeling a heat exchanger to acquaint and grip the working performance of different refrigerant in a aac system can accelerate the equipments choice matching. furthermore which has the important practical meaning for the modernization of aac designs

    冷凝器和蒸發器是汽車空調系統的主要部件，建立一個換熱器動態模擬模型，認識和掌握不同製冷工質在汽車空調系統換熱器內的工作特性，可以加速設計過程中的部件選型和匹配，對實現汽車空調系統設計方法的現代化具有重要的現實意義。
分享友人
分享到 Line

分享到臉書