汽化式化油器 的英文怎麼說

中文拼音 [huàshìhuàyóu]
汽化式化油器 英文
surface carburetor
  • : 名詞1. (由液體或某些固體變成的氣體) vapour2. (水蒸氣) steam
  • : 名詞1 (樣式) type; style 2 (格式) pattern; form 3 (儀式; 典禮) ceremony; ritual 4 (自然科...
  • : Ⅰ名詞1 (脂肪; 油脂) oil; fat; grease 2 (姓氏) a surname Ⅱ動詞1 (用桐油、油漆等塗抹) apply t...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 汽化 : [物理學] vaporization; evaporation; carburate; boil off; nebulization汽化計 atmidometer; evaporat...
  1. Another reason for banning lead in gasoline is that the lead can ruin the catalytic converter.

    禁止里含鉛的另一個原因,是鉛能損壞催排氣凈
  2. Long - hole and geometrical proportion type of mixing unit is finally adapted in lpg supply system, and power and torque output of lpg engine are improved by increasing compression ratio, and ignition characteristic is tried to adjusted to satisfy engine performance. meantime emission performance and noise level of lpg engine at full - throttle and other various part - throttle operations are tested and compared with former gasoline engine. ( 3 ) it is verified by engine dyno tests that lpg engine has better synthesized performance at aspects of power and torque, fuel economy, as well as emission than former gasoline engine

    選擇了等比例長孔混合控制空燃比;通過提高壓縮比來彌補動力性的損失;以動力性為主控目標,對最大功率點、最大扭矩點、中等轉速、最低轉速點所對應的發動機轉速做了點火特性的調節;通過空燃比的合理控制,直接改善發動機的動力性、經濟和排放指標;作為對缸內燃燒過程的理論分析,進行了燃燒特性的實驗測試;對原機和新開發的液氣發動機,進行了外特性和部分負荷特性以及怠速的排放及噪聲對比性測試。
  3. Cyz - a self - priming centrifugal oil pump according to domestic and international to develop newest pump products that become after digesting, absorbing, improving about technical data by oneself, domestic blank, unique, extensively suitable for the oil depot, service station, oil ship, oil carrier, quay, oil truck, airport, send the petrol, kerosene, diesel oil, boat coal etc

    型自吸離心泵是根據國內外有關技術資料經消、吸收、改進后研製而成的最新泵類產品,國內空白獨一無二,該泵適用於石行業、陸地庫、灌車的理想產品,並適合於作船底泵、消防泵和壓載泵及機冷卻水循環等,分別輸送、煤、柴、航煤等石產品和海水、清水,介質溫度- 20 80 ,加輸送工液體可改用耐腐蝕機械密封。
  4. ( 5 ) " electronic controlled bypassing air + three - way catalytic converter " system used for carburetor petrol engine which " is capable of setting up working condition for three - way catalytic converter and can solve the contradiction between emission control ( controlling hc, co, nox at same time ) and power, torque, fuel consumption having been put forward

    ( 5 )建立了針對車輛的「電控補氣+三效催」系統,通過採用雙迴路電控補氣可以為三效催建立良好的工作條件,較好的解決了機動力性、排放(同時降低hc 、 co和nox )之間的矛盾。
  5. At the same time, we improved a two - stroke fueled engine 1e40fm into the one also using the direct injection of liquid petrol gas. the electronic control system is developed whose core is m68hc11 single - chip computer which is produced by motorola ltd., and matched by other electronically - controlled circuits

    開發了以motorola公司生產的8位增強單片機m68hc11為核心,配以相應的外部電路構成摩托車發動機單片機控制系統,並以一臺二沖程1e40fm型機為對象,將其改造為、電控氣體噴射兩用發動機。
  6. Specification for design of steam - jet vacuum pump for petrochemical

    工蒸噴射抽空設計規范
  7. This product acquires engine crank corresponding phase signal and rotating speed signal, which after ecu treatment, are used together with signals collected from other load sensor ( such as shutter location sensor ) to achieve electronic control over engine ignition timing. compared with mechanical ignition timing control, this is more precise and reliable, resulting in optimized performance of engine in oil consumption, exhaust, output and torque

    Fdw465b型電噴分電總成採集發動機曲軸相位信號及轉速信號,同其它負荷傳感(如節氣門傳感等)採集到的信號,經電控單元ecu計算處理后,實現對發動機點火正時的電子控制,較之機械點火正時控制更加精確、可靠,使車發動機系統的綜合性能得到較大提高,特別是發動機的燃消耗率、排放、輸出功率、扭矩等方面都得到較大優
  8. The explosive mixture of the petrol engine is provided by a carburettor, but in the case of the diesel engine the supply is effected by an injection or jerk pump which forces a shot of fuel into each cylinder in turn according to the correct firing sequence

    翻譯:發動機由一個輸送可燃混合氣體,而柴發動機,由一個噴射泵或柱塞泵實現燃供應,此泵根據正確的點火順序把少量燃依次壓入每個缸。
  9. Of high speed four - stroke turbocharging or getter - ion style engine where oils of performance up to api sf cd are recommended

    適用於要求使用api sf cd規格品的普通發動機和高速四沖程渦輪增壓或自然吸氣發動機。
  10. Suitable for demanding to use generalizing oil device type four stroke turbine pressurization of gasoline engine and high speed or the breathing in type diesel engine naturally of specification oil of api sf cd

    用途適用於要求使用api sf cd規格品的普通發動機和高速四沖程渦輪增壓或自然吸氣發動機。
  11. The result from the theorys and the experiments show that, compared with the carburetor engine, the electronic fuel injection wj1e68fm2 gasoline engine has obviously improve on the fuel economy and exhaust emission. standard. there will make a solid foundation for the survival and development of the wj1e68fm2 gasoline engine

    試驗結果表明,電噴wj1e68fm _ 2型機與機相比,在燃經濟性和排放指標兩方面都有明顯的改善。為wj1e68fm _ 2型機的繼續生存和發展奠定了基礎。
  12. Jingde cmpany has an annual production capacity of 1, 500, 000 carburetors for motorcycles and general - purpose gasoline engine. presently, the company produces plunger - type and vacuum - type carburetors and other kinds in 60 varieties of 15 series. and more environment - foiendly and energy - saving series of products will come to the markdt. all these products can equip all kinds of motorcycle end products, power gasoline engine and general - purpose gasoline engine series. “ jingke ” carburetors have succeeded in equipping many famous and high - quality brands of motorcycles such as jialing, jianshe, longxin, zongshen, lifan of chongqing and tianma, wuyang of guangzhou. the company offers guarantees of repair, replace of refund of its products. on the other hand, through the raise of its reputation in the southeast asia markdt and through market re - radiation, the company has begun expoducts to lndia, north america and middle east in batches

    京科公司年生產摩托車及通用能力150萬臺,目前生產的柱塞和等真空已達15個系列60個品種(並將有更多的環保節能型系列新品面世) ,可與各摩托車成車、動力和通用機系列配套, 「京科牌」已和包括重慶的嘉陵、建設、隆鑫、宗申、力帆,廣州的天馬、五羊等諸多名優車成功配套,並對產品實行三包承諾,同時,經過東南亞市場信譽度的提高和再輻射,已開始大批量出口印度、北美及中東地區。
  13. ( 4 ) by analyzing all kinds of encapsulating n - ethods of catalytic converter and researching the mat expanding characteristic of atalytic converter, " suspending encapsulation " method being put forward, and the method being well capable of solving mechanical reliability of the converter

    ( 4 )通過分析國內外目前的封裝方和對催墊層的特性進行研究,提出了催的「懸浮封裝」技術,採用該技術可以較好的解決機催的機械可靠性問題。
分享友人