沸騰狀態 的英文怎麼說

中文拼音 [fèiténgzhuàngtài]
沸騰狀態 英文
boil
  • : Ⅰ動詞(滾開) boil; bubbleⅡ形容詞(滾開的;沸騰) boiling; bubbling
  • : 騰象聲詞(形容猛然動作發出的聲音)
  • : Ⅰ名詞1 (形狀) form; shape 2 (情況) state; condition; situation; circumstances 3 (陳述事件或...
  • : 名詞1. (形狀; 狀態) form; condition; appearance 2. [物理學] (物質結構的狀態或階段) state 3. [語言學] (一種語法范疇) voice
  • 沸騰 : 1 [物理學] (液體氣化) boiling; ebullition; ebullience; elixation 2 (情緒高昂) seethe with exc...
  • 狀態 : status; state; condition; state of affairs: (病的)危險狀態 critical condition; 戰爭狀態 state o...
  1. Adaptive boiling detection based on cusum control charts

    基於累積和控制圖的自適應沸騰狀態檢測
  2. Pour boiled water 3 - 4 inches deep into steamer and cover. keep the water boiling gently over a low heat. if necessary, add water to maintain steam

    往蒸鍋里倒開水,注滿到距鍋底3 ~ 4英寸高的位置即可,然後蓋上蓋。用文火將水保持在慢熱。如果需要的話,可以加一些水,以保持蒸汽不斷。
  3. High voltage blasting lets the used sand to be under boiling state, therefore best cooling effect can be reached

    高壓鼓風使舊砂處于沸騰狀態,達到最佳冷卻效果。
  4. The condition or act of boiling

    煮,或煮的動作
  5. The state or process of boiling

    或過程
  6. Test method for the boiling range distribution of petroleum distillates in the boiling range form 100 to 615 by gas chromatography

    利用氣相色譜法在100至615之間進行石油蒸餾分佈范圍測定的試驗方法
  7. The main results in this paper are as follows : ( 1 ) study on starting up performance of thermosyphon : according to the study on the states before and after starting up of thermosyphon with the various filling amount, it is considered that the phase change heat transfer inside the copper - water thermosyphon with a large ratio of length and diameter is not only influenced by the boiling degree of superheat, but also controlled by evaporation and companied with the boiling of the thin liquid film

    本文的主要研究結果為: ( 1 )熱虹吸管啟動性能的研究:通過對從不同充液量、啟動前、內部汽化核心對啟動的影響所進行的試驗研究,認為大長徑比的銅?水熱虹吸管管內相變不僅僅為,而是以蒸發為主,伴有薄液膜的
  8. The water temperature at the reactor pressure vessel outlet is about 330 degree c whereas the water temperature at the inlet of the vessel is about 290 degree c. the cooling water is in a sub - cooled condition at such high temperature and pressure to prevent it from boiling

    反應堆出水的溫度約為攝氏330度,而入水口的溫度約攝氏290度。在這高溫及高壓下的冷卻水會處于欠熱即冷卻水的溫度與其點有一段距離,因此不會
  9. But the vaporization of magnesium suggested an alternative method : we could seal a piece of magnesium and some powdered boron inside a tantalum vessel, which is inert, and subject them to a temperature high enough to melt but not to boil the magnesium ( say, 950 degrees c )

    不過,鎂的汽化卻也啟發了另一種方法:我們可以將鎂及一些粉的硼密封在鉭瓶中(鉭為惰性元素) ,然後將它們加熱至足夠的溫度(例如950 ) ,使得鎂呈現熔化但尚未
分享友人