泄汽閥 的英文怎麼說

中文拼音 [xiè]
泄汽閥 英文
snifting valve
  • : Ⅰ動詞1 (液體、氣體排出) let out; discharge; release 2 (泄露) let out (a secret); leak (new...
  • : 名詞1. (由液體或某些固體變成的氣體) vapour2. (水蒸氣) steam
  • : 名詞1 (指在某方面有支配勢力的人物或家族) established house or power group; a powerful person or...
  1. Paved secondary containment, waste water collection and biological treatment systems for pollution prevention. pressurised fire water system including dual diesel driven high capacity pumps with automatic tart on demand, and monitors in all operating areas

    時,門打開向火炬放氣體,火炬處設有水封、阻火器和電點火系統,蒸在此系統完全燃燒后達到環保要求的排放標準。
  2. The total area of our company is about 50 thousands sq. m, in which there are four workshops. now we have three series of products and mainly serve for petroleum chemical army aviation municipal and other oil gas storage and transportation industry

    公司生產的產品有:碼頭用輸油臂車,火車鶴管大鶴管零漏導軌門等,產品遍布全國31個省市,並遠銷至斯里蘭卡蘇丹等國,顧客反映良好。
  3. The 3 - way magnet valve ( pos. no. 77 ) is never energized again ( upper frame ), but if the cause of deenergizing is eliminated and the electric circuits of the engine protecting system are reset, the 3 - way magnet valve ( pos. no. 77 ) is energized ( upper frame ), then the control air which has actuated the single - acting cylinder ( pos. no. 21 ) being rapidly blown off through the quick release valve ( pos. no. 41 )

    三通電磁77決不會再次通電上位,但如果斷電的原因被消除而且主機安保系統電氣迴路被復位,三通電磁77被通電上位,作用在單作用缸21的控制空氣已被迅速放出通過快速41 。
  4. There is always frozen water in front of the trap forming water block to avoid steam leaking

    前始終有凝結水,形成水封,無蒸漏。
  5. Through adjustment of the thermal control parameters, the valve stem leakage problem of the main steam valve resulted from insufficient opening in hot state has been eliminated

    通過調整熱控參數,消除了熱態時門開度不足問題,主門桿再未發生蒸漏。
  6. After retrofitting the digital electro - hydraulic ( deh ) control system of the steam turbine unit no. 1 in dezhou power plant, the valve stem leakage has occurred on the highpressure main steam valve, and the causes leading to the said leakage being analysed

    摘要對德州電廠1號輪機組在經過deh控制系統改造后高壓主門桿發生蒸漏的原因進行了分析,認為蒸漏是熱態時門開度不足所致。
分享友人