流量閥 的英文怎麼說

中文拼音 [liúliángfá]
流量閥 英文
flow valve
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 閥 : 名詞1 （指在某方面有支配勢力的人物或家族） established house or power group; a powerful person or...
  • 流量 : rate of flow; flow; runoff; discharge; throughput; （flow） rate; quantity （of flow）; flux
  1. Adjustment is provided in the form of a needle-value or restrictor.

    流量調節採用針閥或限流器。
  2. The argos regulator is an extremely versatile flow control device for gas applications where pressure reduction is required excellent in performance and easy maintenance are beneficial

    Argos減壓閥是一非常多用途的流量控制裝置，對瓦斯氣體要求精確減壓控制與維護簡單的使用尤其具效益。
  3. First, it is compressible and cushiony ; second, it can be transported to a long distance with a little power loss ; the last, its flux and velocity of flow are quite high, so the reaction time of the operators can been considerably shortened. aiming to solve the problems of vibrating machinery such as short life - span, poor cushion and high energy consumption, the writer, on the basis of characteristic of pneumatic mentioned, contrives a set of valve controlled pneumatic vibrator, which has larger output vibrating force and longer life - span with simple structure. then, it is applied to drive a vibrating screen and the result is fairly well

    文中針對氣動技術本身的特性及優點，如：可壓縮，具有緩沖性；能耗損失小，便於遠距離輸送；流量大、流速高，執行元件響應速度快等，以解決振動機械在應用過程中的緩沖、能耗以及使用壽命等問題為目的，設計出一套輸出激振力大、結構簡單、使用可靠的閥控氣動激振器，並將其成功地運用到振動篩上，取得了較好的效果。
  4. The 2300 direct operated reducing valve is designed for deadend water service where the flow is intermittent and changes rapidly, as on domestic water systems

    系列2300直接操作減壓閥適用於室內水系統流量有間歇性變化和變化迅速的終端水應用場合。
  5. This paper supplied a new way through variable frequency variable speed ( vfvs ) to change its output flow rate and adding a constant - pressure - drop valve, which could solve the defects in hydraulic pressure servo control system, such as low efficiency in control system, short life, poor ability in resisting pollution, low efficiency in driving system and flow rate, pressure pulse. and this way was proved to be effective

    本論文針對傳統伺服控制系統效率不高、元件壽命短、抗污染能力差、驅動系統效率低、存在流量及壓力脈動等缺陷，利用先進的交流變頻調速技術改變液壓泵轉速的容積調速新方法，提出了在液壓系統中加一個定差減壓閥的新思路，較好地解決了液壓伺服系統存在的上述問題。
  6. Industrial - process control valves - flow capacity - sizing equations for fluid flow through multistage control valves with interstage recovery

    工業過程式控制制閥.流通能力.通過有段間恢復功能的多段控制閥的流體流量的校準公式
  7. Industrial - process control valves - part 2 - 5 : flow capacity ; sizing equations for fluid flow through multistage control valves with interstage recovery

    工業過程式控制制閥.第2 - 5部分:流通能力.通過有段間恢復能力的多段控制閥門的流體流量的校準公式
  8. Industrial - process control valves - part 2 - 5 : flow capacity - sizing equations for fluid flow through multistage control valves with interstage recovery

    工業過程式控制制閥.第2 - 5部分:流通能力.通過有段間恢復能力的多段控制閥門的流體流量的校準公式
  9. Water feeding framework takes electromagnetism water valve as administration component and is added relief valve for stabilizing hydraulic pressure ; the system has large, middle and small water valve that changes unlock combination of electromagnetically operated valve, which can get seven different water flux ; if it is necessary, it should adopt microseism water feeding that can make water feeding get stepless timing

    3加水機構加水機構採用電磁水閥作為執行元件，加入調壓閥穩定水壓，系統共設大中小三路加水閥，變化電磁閥的開啟組合，可以得出7種不同的加水流量，必要時採用脈動加水法，可使加水達到無級調速。
  10. Note : the elevated tank, rotameter, water drain apparatus, technological valve and pipeline are settled by customers themselves

    注：其中高位槽轉子流量計疏水器工藝閥門管道由用戶自理。
  11. Suction gas pressure goes up as the compressor run at the lower speed in the lower burthen, and this is beneficial to lower systems energy - consume. when the system is controlled by wvf, the discharge change of the evaporator is not linear ; the electronic expansion valve is adopted to regulate the system superheat degree, and the controlled object is parameter time varying, accordingly, the time varying controller should be adopted

    在負荷較小時，壓縮機採用低速運轉，吸氣壓力升高，這對系統降低能耗是有利的；變頻控制時，蒸發器製冷劑流量的變化並非線性；系統中採用電子膨脹閥進行過熱度控制，被控對象具有參數時變的特性，相應地宜採用變結構的控制器。
  12. The goal is to control the water outlet temperature by manipulating the flow rate of the steam and control the water inlet rate by manipulating the height of the water level in the water tank

    本文中，換熱器的控制任務主要有兩個，首先通過控制水箱進口水閥門開度，進而控制水箱水位，進而控制換熱器進口水流量。
  13. When the governing valve was series - connected on the return oil - line in the metering - out control system, under the same flow area and the same adjusted pressure of relief valve, with the incremental quantity of step load, the pressure highly - adjusted capacity of the hydraulic cylinder chamber with piston - rod increased, meanwhile, it ' s time of rise, time to peak and the governing time all increased. at the same time, the pressure highly - adjusted capacity of the hydraulic cylinder chamber without piston - rod increased

    當出口節流調速系統的回油路上串接調速閥時，隨階躍負載的增加，在相同流量閥開度、相同溢流閥調節壓力的情況下，液壓缸有桿腔壓力p _ 2 （ t ）的超調量是增加的，上升時間、峰值時間以及調整時間也是增加的；液壓缸無桿腔壓力p _ 1 （ t ）的超調量是增加的。
  14. The material was change to liquid material after pass through a chute and then flow into the flow valve, which can prevent the flow control parts from forming columnar material

    物料先通過一段小斜槽，使物料流態化，然後再進入流量閥，這樣可避免在流量控制部分形成料柱。
  15. Regarding how to design the valve structure, material choosing, design methods, for instance, how to design the pressure - releasing valve, and how to design the nozzle of the valve

    電站旁路閥，高溫高壓閥，減溫減壓閥，調節閥，最小流量閥等結構，材料，設計方法。如減壓閥的設計，噴嘴的設計。
  16. Accorded to the experimental research, under different flow area of flow valve and different adjusted pressure of relief valve, conclusion that the regulation of the pressure p1, p2 in the two cylinder chambers varied with the change of step load were as follows : when the throttle valve was series - connected on the return oil - line in the metering - out control system, under the same flow area and the same adjusted pressure of relief valve, with the incremental quantity of step load, the pressure highly - adjusted capacity of the hydraulic cylinder chamber with piston - rod decreased, meanwhile, it ' s time of rise, time to peak and the governing time all decreased. while the pressure highly - adjusted capacity of the hydraulic cylinder chamber without piston - rod increased

    通過試驗研究得出系統在不同的流量閥開度、不同溢流閥調節壓力（進口壓力）下，液壓缸兩腔壓力p _ 1 、 p _ 2隨階躍負載變化的規律：當出口節流調速系統的回油路上串接節流閥時，隨階躍負載的增加，在相同流量閥開度、相同溢流閥調節壓力的情況下，液壓缸有桿腔壓力p _ 2 （ t ）的超調量是減小的，上升時間、峰值時間以及調整時間也是減小的；液壓缸無桿腔壓力p _ 1 （ t ）的超調量是增加的。
  17. Line discharge valve design problem research

    線性流量閥的內筒設計問題研究
  18. Numerical simulation of proportional valve with complex channels base on fluent

    的復雜通道比例流量閥的數值模擬
  19. Fine casting full flow stainless ball valve to

    精鑄不銹鋼全流量閥
  20. In order to solve the problems that large energy consumption, temperature variation, high, cost trouble maintenance in current electro - hydraulic servo control system for material testing machine, a new design scheme that electro - hydraulic proportional control system for material testing machine based on extension control strategy is proposed. the design scheme is successful by means of designing new main frame system, hydraulic cylinder system, digital electro - hydraulic micro - fluid proportional valve and electrical control system, and its results lay a foundation for material testing machine industries in our country

    針對國內外材料試驗機主要採用電液伺服控制系統，存在能耗大、溫升、成本高、維護困難等問題，本課題提出了基於可拓控制策略的材料試驗機電比例負載適應控制系統這一新型研究方案，通過開發新型試驗機主機系統、液壓缸系統、數字式微小流量電液比例流量閥及電控系統，實現了材料試驗機電液比例負載適應控制，為我國材料試驗機自動控制系統的產業化打下了基礎。
分享友人
分享到 Line

分享到臉書