浸漬溶液 的英文怎麼說

中文拼音 [jìnzìróngyè]
浸漬溶液 英文
dip solution
  • 浸 : Ⅰ動詞1 （泡在液體里） soak; steep; immerse 2 （液體滲入） soak; saturate; steep Ⅱ副詞[書面語] （...
  • 漬 : Ⅰ名詞1 （地面的積水） floodwater on low lying land 2 [方言] （積在物體上難以除去的油泥等） stain;...
  • 溶 : 動詞（溶化; 溶解） dissolve
  • 液 : 名詞（液體） liquid; fluid; juice
  • 溶液 : solution; liquor; scald; aqua
  1. In order to make clear the regulation of the combustion and the heat - transport process of fire - retardant treated wood, the combustion of untreated, fire - retardant solution soaked, and fire - proof paint coated white pine ( pinus bungeana ) and northeast china ash ( fraxinus mandshurica ) wood as well as the rising process of temperature at different sites in wood were measured in this study, taking a multi - function fire - proof experiment oven to simulate the typical process of fire

    摘要為了弄清楚阻燃處理木材的燃燒及其熱傳導規律，該研究採用多功能耐火實驗爐模擬典型火災的發生過程，測定了未處理、阻燃劑水溶液浸漬處理、塗刷防火塗料白皮松和水曲柳木材的燃燒及木材內不同位置的升溫過程。
  2. Acts as a disinfectant on both bacteria and viruses likely to be encountered in the home 3 ) generally whitens fabrics the bleaching action of sodium hypochlorite is essentially completed in about 5 minutes, even less time in hot water, but slightly longer in cold. the dry version performs like liquid sodium hypochlorite bleach when dissolved in water

    過氧化氫于酸性時安定，但在酸性溶液時會分解產生初生態的氧，在緘性溶液中，具有強烈的漂白力，對纖維沒有很大的脆化作用，但是羊毛蠶絲等，于長時間浸漬時，會產生相當的脆化。
  3. The theoretic cycle capacity of limno2 is 286 mah g - 1, which has attracted a great deal of people to research. aim at the impurity of limno2 which was synthesized by the predecessor and the phase change during the electrochemical process, we try several methods, including wet moist chemical method, liquid state method, solide state method and liquid dipping method. at the same time, we study the synthesis of limnc > 2 in defferent atmosphere, for example air, argon and nitrogen

    Limno _ 2具有286mah ? g ~ （ - 1 ）的理論容量，這種高容量材料深受廣大研究者的關注，針對前人合成出的還有少量雜相和在電化學循環過程中出現相變四川人學碩l :學位論文的問題，我們嘗試了幾種合成方法:濕化學法、液相法、固相法和溶液浸漬法，並在不同氣氛:空氣、氮氣和氫氣中進行limnoz的合成研究。
  4. Standard test method for weight loss mass loss of sheet steel during immersion in sulfuric acid solution

    薄鋼板在硫酸溶液浸漬過程中重量損失
  5. The oxidizing kinetics equations of different dipping time of dipping two kinds of phosphate saturable solution were determined. the influences of dipping time of dipping two kinds of phosphate saturable solution on antioxygen properties of sic kiln furniture were also studied. the effect of dipping two kinds of phosphate saturable solution were compared. both of their best dipping time were determined

    探討浸漬兩種磷酸鹽飽和溶液次數對窯具材料結構和性能的影響，確定浸漬兩種磷酸鹽飽和溶液不同次數的氧化動力學方程，分析其對sic窯具材料抗氧化性的影響，比較兩種磷酸鹽飽和溶液的浸漬效果，並確定各自的最佳浸漬次數。
  6. The investigation presents a new method of dipping sic kiln furniture into 2 saturable solution or into the saturable solution of ca3 ( po4 ) 2 and a1po4 in order to beneficial to its crystalline structure change and its properties, to make it packed and decrease its porosity. it can also hinder the diffusion of oxygen so as to decrease the oxidation rate and lengthen the useful life. the mechanism of dipping two kinds of phosphate saturable solution were studied and proved by the results of scanning electron microscope

    本研究首次採用sic窯具材料浸漬ca _ 3 （ po _ 4 ） _ 2飽和溶液和浸漬ca _ 3 （ po _ 4 ） _ 2與alpo _ 4混合飽和溶液的方法，目的在於有利於窯具材料晶相結構的轉化和性能的優化；能堵塞材料的氣孔，降低透氣率，阻礙o _ 2擴散，降低氧化速度，延長窯具材料的使用壽命。
  7. Aluminium and aluminium alloys - anodizing - part 7 : assessment of quality of sealed anodic oxidation coatings by measurement of the loss of mass after immersion in phosphoric acid chromic acid solution with prior acid treatment

    鋁和鋁合金.陽極化處理.第7部分:通過測量預先經過酸處理的磷酸和鉻酸溶液浸漬后的質量損失評估密封陽極氧化鍍層的質量
  8. The parameters of impregnation are as follows : ph is about 3, the range of temperature is from 20 to 45, and the time is about 2 to 6 hours. after the necessary treatments, zirconia cloths had the optimal strength when the diameters of zirconia fibers were controlled in 4um to 7um, and the sizes of zirconia grains were in 50nm to 100nm. the affec - ting factors were discussed and the liner regression analysis of the cloths was made, from w hich they show that the diameters and grain sizes have the significant influences on zirconia cloths. the obtained zirconia cloths have been accepted for use in nickel - hydrogen batteries by practical use

    研究結果表明：粘膠類纖維布最適合制備氧化鋯纖維布的前軀體；鋯液濃度以飽和溶液為宜；浸漬工藝參數為ph值3左右，溫度20 45 ，時間2 6小時；多餘鋯鹽的去除、浸鋯液后纖維布的整平處理及平燒施應力燒成有利於氧化鋯纖維布的柔軟及平整; 200 600燒成溫度段應緩慢燒成，控制氧化鋯纖維直徑在4 7 m ，氧化鋯晶粒尺寸50 100nm時氧化鋯纖維布的強度最好。
  9. The effect of composition of coating solution, dipping time and other technical parameters for preparation of sensors on sensing behaviour has also been described and discussed

    討論了溶液組成，浸漬時間等元件制備工藝參數對響應特性的影響。發現電極結構對于元件響應特性有一定影響。
  10. Paints and varnishes - corrosion testing by alternate immersion in and removal from a buffered sodium chloride solution

    油漆和清漆.將塗料替換浸漬在緩沖氯化鈉溶液中和從該溶液中去除的腐蝕試驗
  11. X - ray diffraction analysis and mult - peak separation applied software procedure analysis were used to determine the crystal phase and amounts of each sample. the influences of dipping time of dipping two kinds of phosphate saturable solution on the structure and the properties of kiln furniture were studied

    探討浸漬兩種磷酸鹽飽和溶液的浸漬機理，並用掃描電鏡的分析結果加以驗證；採用x -射線粉末衍射分析與多峰分離應用軟體程序分析、確定各試樣的晶相，計算各晶相的含量。
  12. After dipped in amino trimethylene phosphonic acid ( atmp ) solution, anodic oxide films are annealed in pipe stove. the influences of concentration and temperature of atmp solution and annealing temperature on rising time, withstanding voltage and specific capacitance of anodic oxide films are studied. after hydration, anodic oxide films treated with atmp or not are analyzed by ft - ir

    2 .將化成箔在氨基三甲叉膦酸（ atmp ）溶液中浸漬，取出烘乾后再進行熱處理，研究了atmp溶液濃度、浸漬溫度和熱處理溫度對氧化膜升壓時間、比容、耐電壓的影響，找到其最佳耐水合處理工藝;採用ft - ir對水合作用后的atmp處理氧化膜和未經耐水合處理氧化膜進行了分析。
  13. The optimum concentration and temperature of dtpmp solution and optimum annealing temperature are discussed. in addition, hydration resistant effect of anodic oxide films treated with adp, atmp and dtpmp respectively is discussed through ft - ir, xps, afm and i - v characteristics testing

    探討了dtpmp溶液濃度、浸漬溫度和熱處理溫度對氧化膜升壓時間、比容、耐電壓的影響，並找到其最佳耐水合處理工藝;同時採用ft - ir 、 xps 、 afm和i - v特性測試對adp 、 atmp 、 dtpmp三種試劑對氧化膜的耐水合處理效果進行了對比研究。
  14. In this paper, the composition and preparation of standard solution for testing color fastness of textiles, such as color fastness to perspiration, light and perspiration, saliva, sea water, chlorine impregnating and chlorine bleaching were described in detailed

    摘要以現行紡織品色牢度試驗國家標準為主，兼及國外同類標準，闡述了耐汗漬、耐光汗復合、耐唾液、耐海水、耐氯浸、耐氯漂等色牢度試驗中，標準工作溶液的組成及制備，並對制備中的一些問題進行了說明。
  15. Standard practice for exposure of metals and alloys by alternate immersion in neutral 3. 5 % sodium chloride solution

    在3 . 5 %氯化鈉中性溶液中用交替浸漬法的金屬及合金暴露的標準實施規程
分享友人
分享到 Line

分享到臉書