液流噴管 的英文怎麼說

中文拼音 [liúpēnguǎn]
液流噴管 英文
spout
  • : 名詞(液體) liquid; fluid; juice
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : 噴動詞1. (液體等受壓力而射出) spurt; spout; gush; jet 2. (噴灑) spray; sprinkle
  • : Ⅰ名詞1 (管子) pipe; tube 2 (吹奏的樂器) wind musical instrument 3 (形狀似管的電器件) valve;...
  1. The main products of our company : series of mining emulsion pump station, series of electric haulage shearer, sparying pump station, series of mining flame - proof vacuum / air electromagnetic starter, series of mining vacuum / air feeding switch, series of mining fame - proof and natural - safe. type ac soft starter, series of hydraulic stand valve and pipe system, high flow rate quick - moving valve, the new product nearing into market - the hydraulic support electric - control system, mining electric drill, hydraulic valve test table, electric performance test table

    公司主導產品為:系列電牽引採煤機、系列礦用乳化泵站、霧泵站、礦用隔爆兼本質安全型交軟起動器、系列礦用隔爆真空、空氣電磁起動器、系列礦用真空、空氣饋電開關、系列壓支架閥類及路系統、大量快速移架閥、即將投入市場的新產品? ?壓支架電控制系統、煤電鉆系列、壓閥試驗臺、電性能試驗臺等。
  2. Based on the analysis of regime of spray and heat transfer, the spray nozzles were redesigned to distribute liquid in the center area of th e tower and the gas inlet was enlarged to raise gas velocity

    根據對順式空塔的淋及傳熱模式的分析,重新設計了嘴,使在設備中心附近集中;縮小了進氣直徑,以提高進口氣體的速。
  3. Measurement of fluid flow in pipes using orifice, nozzle, and venturi - part 1 - general

    用孔板嘴和文杜利量計測量道中量.第1部分:總則
  4. Measurement of fluid flow in pipes using orifice, nozzle, and venturi - part 2 - orifice plates

    用孔板嘴和文杜利量計測量道中量.第2部分:孔板
  5. Measurement of fluid flow in pipes using orifice, nozzle, and venturi - part 4 - venturi meters

    用孔板嘴和文杜利量計測量道中量.第4部分:文杜利量計
  6. Measurement of fluid flow in pipes using orifice, nozzle, and venturi - part 3 - nozzles and venturi nozzles

    用孔板嘴和文杜利量計測量道中量.第3部分:嘴和文杜利
  7. In other instruments, the stream is accelerated through a venturi or nozzle

    在其他儀器中,則是通過文氏嘴加速的。
  8. Analysis has been concentrated upon the triple - pipe construction method in this thesis. detailed introduction has been carried out from the cut of earth by means of gaseous - hydraulic co - axial composite grouting flow to the principle of earth stabilization, from the makeup of grouting liquid to the equipments, types of instruments, operation regulations and means of quality control required in every link of grouting

    論文重點分析了三重法施工技術,分別從氣同軸復合對土體的切削到對土體的加固原理,從注漿體的配備到注漿各環節所需設備、機具型號及操作規程和質量控制手段等方面都做了詳細的介紹。
分享友人