渦輪流量計 的英文怎麼說

中文拼音 [guōlúnliúliángjì]
渦輪流量計 英文
turbine flowmeter
  • 渦 : 渦名詞1. （漩渦） eddy; whirlpool; vortex 2. （酒窩） dimple
  • 輪 : Ⅰ名1 （輪子） wheel 2 （像輪子的東西） wheel like object; ring; disc 3 （輪船） steamer; steamboa...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 渦輪 : [機械工程] turbine; worm wheel渦輪泵 [航空] turbopump; roturbo; 渦輪發動機 turbine engine; 渦輪風...
  • 流量 : rate of flow; flow; runoff; discharge; throughput; （flow） rate; quantity （of flow）; flux
  1. Spiraling of the liquid as it reaches the rotor may affect the accuracy of the turbine meters.

    當液體接近轉子時發生紊流可以影響渦輪式流量計的精確度。
  2. Turbine meter has the advantages of high accuracy, fast response, and greater versatility under extreme operating conditions.

    在不良的工作條件下渦輪式流量計具有精度高，響應快和適應性廣等優點。
  3. An instrument of measuring irrigation water flow with higher precision has been developed by means of integrating smart ic card with turbine flow sensor, which improves the existed flow measuring technique for pumping well from the aspects of precision, sensing, capacity, data storage, safety and monitoring, and then enhances the precision of the irrigation flow measuring device from 1m ^ 3 to over 0. 01m ^ 3

    摘要將渦輪流量傳感器與智能ic卡技術進行集成應用，開發出高精度的灌溉用水計量設備，從精度、傳感、容量、數據存儲、安全、監控6方面提高了現有機井量水技術，將灌溉量水設備精度由1立方公尺提高到0 . 01立方公尺以上。
  4. In chapter 3, the subgrid eddy - viscosity model for large eddy simulation is applied to calculate the three dimensions unsteady periodic turbulent flow in yantan francis turbine. the pulsating characteristics of some main physical parameters in flow field are found. the calculated axial water thrust of hydraulic turbine agrees with the model - test value

    第三章採用大渦模擬亞格子渦粘模型，對巖灘混流式水輪機的流場進行三維非定常湍流分析，得到了流場中各物理量的脈動特性，計算出ms的軸向水推力與模型試驗值大小相當；同時論證了對于下機架承重的混流式水輪發電機組可採用其推力軸承負荷作為水電站廠房振動的最大垂直激振荷載。
  5. The measurement of oil / water two - phase flow is primarily accomplished by the combination of total flow rate and holdup measurement, and at present, the rotator flowmeter is used to measure the total flow rate. since the rotator flowmeter has movable parts, which makes its responsibility behave nonlinearly under poor environment of me under hole whose fluids have very complex and changeful characteristics and affects the measurement precision. what ' s more, the widely used centralized measurement instrumentation meets problems in oil wells characterized with high production or high water cuts

    通常油水兩相流測量主要是通過總流量和持率的測量組合來完成的，目前在總流量的測量中主要使用的是渦輪流量計，由於渦輪流量計具有可動部件使其在流體特性復雜多變的惡劣井條件下的響應呈非線性變化規律，影響測量精度，此外，普遍採用的集流型測試儀器在高產井及含水率高的油井中使用也遇到困難，為此，一種新型的適合非集流型點測的測試方法和測試儀器亟待發展和推廣。
  6. They are mainly used in manufacturing plants for ventilation or delivering gaseous materials and products thus they are considered the necessary equipment in ventilation, dust collection, acid and odor removal. there are numerous types of domestic products but most are exhausting fans, radial fans, vortex fans and axial fans. the technology controlled by domestic companies has been elevated from earlier dependent on international companies for technical assistance to self - sufficient in manufacturing

    除臭設備及焚化爐等設備不可或缺之一環，目前國內所產制之抽送風機種類繁多，而以抽風機、徑向式送排風機、渦輪式送排風機及軸流式送排風機居多，製造廠商之設計製造能力已由早期的仰賴國外技術支援而提升至相當之自製程度，目前國內所產制透浦式送風機之最大處理風量可達
  7. There are five parameters need to be measured. there are five channels for input : the displacement of casting - roller, the rotate speed of casting - roller, the pressure of casting and rolling, the casting temperature and the water - speed of cooling water. they are measured by raster, photoelectric coder, strain pressure sensor, thermocouple and turboflowmeter

    系統需要進行監測的參數有五個，即有五路輸入信號：鑄輥位移、鑄輥轉速、鑄軋壓力、澆鑄溫度、冷卻水流速，分別採用光柵、光電編碼器、應變式壓力傳感器、熱電偶和渦輪流量計作為檢測元件。
  8. Measurement of gas flow in closed conduits - turbine meters

    封閉管道中氣體流量的測量渦輪流量計
  9. Liquid hydrocarbons - volumetric measurement by turbine meter system

    液態烴體積測量渦輪流量計計量系統
  10. Analysis on influence factor of the turbine flowmeter in multiphase flow measurement

    多相流測量中渦輪流量計的影響因子分析
  11. Abstract : clibrating turbine flow meter is traditionally static meter - factor. this thesis introduces the theory and practice method of calibrating the dynamic character of turbine flow meter

    文摘:渦輪流量計傳統上只進行穩態校準，即只校準其（穩態）儀表系數。本文闡述了校準渦輪流量計動態響應特性的理論和實施方法。
  12. It can automatically match rotational speed generator, electromagnetic rotational speed sensor and electromagnetic turbine flowmeter. moreover it can adapted measured signal that is 1v ~ 300v voltage and 1hz ~ 2500hz frequency

    能自動匹配測速發電機、電磁式測速傳感器和電磁渦輪流量計，適應電壓峰峰值從1伏以下至300多伏、頻率從1hz以下至2500hz以上的被測信號。
  13. Then, four different computation methods are applied to compute the hydrodynamic performance of the rotor, which are single - disk single - tube method ( sdst ), double - disk single - tube method ( ddst ), multi - tube method ( mtt ) that are based on momentum theorem and vortex method ( vtth ) that is based on potential eddy theory

    然後，採用基於動量定理的單盤面?單流管方法（ sdst ） 、雙盤面?單流管（ ddst ）方法、多流管（ mtt ）方法以及基於勢渦理論的渦方法（ vtth ）計算直葉擺線式水輪機的水動力性能。
  14. Based on the exhaust heat data of the iurbine ( 6160a - 12 ) and the micro gas turbine produced in japan, parameters of test - bed such as deferent thermal flow temperature and pressure are defined by the calculation of design parameter in method of combined theory and experience data

    以柴油機（ 6160a - 12 ）和日本的微型燃氣渦輪機尾氣參數為設計基礎，通過理論和經驗數據相結合的方法進行設計參數計算，確定了模擬實驗臺熱流量、出口溫度及壓力等參數。
分享友人
分享到 Line

分享到臉書