渦輪計 的英文怎麼說

中文拼音 [guōlúnjì]
渦輪計 英文
turbine meter
  • 渦 : 渦名詞1. （漩渦） eddy; whirlpool; vortex 2. （酒窩） dimple
  • 輪 : Ⅰ名1 （輪子） wheel 2 （像輪子的東西） wheel like object; ring; disc 3 （輪船） steamer; steamboa...
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 渦輪 : [機械工程] turbine; worm wheel渦輪泵 [航空] turbopump; roturbo; 渦輪發動機 turbine engine; 渦輪風...
  1. Each module has a microcomputer with both turbocharged and naturally aspirated calibrations resident in its internal rom.

    每一模件都有一個在其內部Rom中間同時保存有渦輪增壓和自然吸氣計算的微計算機。
  2. Design and specification of gearboxes for wind turbines

    風力渦輪機齒輪箱的設計和規范
  3. Experimental studies on s1a - 02 gas turbine with water injection into compressor interstage / inlet as well as that on turbocharger self - loop test rig with inlet water injection are introduced. test results are in good accordance with simulation results, wet compression can lower compression work and increase engine power output so engine performance is enhanced, if engine power output is not changed, efficiencies of compressor and this engine become higher and turbine inlet temperature and fuel consumption become lower and if keeping t4 the same as that before wet compression is used, efficiencies become furthermore higher and engine power output increases greatly

    實驗結果和計算結果同樣表明：濕壓縮減少了壓氣機所消耗的壓縮功，增加了燃氣輪機的輸出功率，提高了燃氣輪機性能，如果保持發動機輸出功率恆定，濕壓縮可以提高壓氣機和整個燃氣輪機機組的效率，與此同時，渦輪進口溫度t _ 3 ~ *和燃油消耗率下降；如果保持渦輪排氣溫度t _ 4 ~ *恆定，壓氣機和燃氣輪機機組效率進一步提高，燃氣輪機輸出功率增加。
  4. 05. 01 test method for luminometer numbers of aviation turbine fuels

    航空渦輪機燃料光度計數目測試方法
  5. Standard test method for luminometer numbers of aviation turbine fuels

    航空渦輪機燃料發光計值的標準試驗方法
  6. Spiraling of the liquid as it reaches the rotor may affect the accuracy of the turbine meters.

    當液體接近轉子時發生紊流可以影響渦輪式流量計的精確度。
  7. Abstract : being aimed at the recovery system of ethanol pulping, and based on the techniques requirement of recovery processing and energy - savin g expectation, two kinds of flash tank, directed and turbine based, are designe d in this paper

    文摘:針對乙醇法制漿的藥液回收系統，根據制漿回收工藝和節能要求，研究設計了直接式和渦輪式兩種閃蒸器
  8. 05. 02 design of steam turbine generator oil systems

    蒸汽渦輪發電機油路系統設計
  9. Turbine meter has the advantages of high accuracy, fast response, and greater versatility under extreme operating conditions.

    在不良的工作條件下渦輪式流量計具有精度高，響應快和適應性廣等優點。
  10. Questions about whether the adsorbent is endurable and whether the adsorption refrigeration equipment has effect on the performance of diesel are answered with theoretical analysis and test. numerical simulation is used in optimum design of adsorbent bed of an adsorption refrigeration prototype which is driven by exhaust heat of gas electric generator

    分析了吸附製冷系統是否增加內燃機能耗和吸附劑使用壽命等問題，並採用數值模擬方法，對以燃氣渦輪發電機尾氣為熱源的吸附式製冷樣機，進行了吸附床結構的優化設計。
  11. By using harika algorithm, the characteristic of a high - pressure compressor is calculated at different installation angle of the inlet guide vane and the stator vanes ; the characteristics of a high - pressure turbine and a low - pressure turbine are simulated at different installation angles of the guide vane based on ainley method

    本文用harika演算法計算了導流葉片和靜子葉片安裝角度可調的變幾何高壓壓氣機特性；用ainley法計算了渦輪導向器面積可調的高壓渦輪和低壓渦輪的特性。
  12. In this paper. the conclusion of this paper has utility meaning in analysis on turbine blades cooling after some proper correcting of the geometry structure and boundary conditions

    由於所採用的結構及計算域近似渦輪葉片的冷卻形式（主流加熱，內流通道冷卻） ，因此這種方法經過進一步的改進，可用於渦輪葉片冷卻的計算研究。
  13. Understanding the three - dimensional nature of these flows and understanding the interactions between the ejected coolant and the endwall flow are the key to a successful endwall film - cooling design. results from this investigation enhance this understanding

    揭示流場的三維特性以及噴射的冷空氣與端壁附近的外流場相互作用規律是渦輪葉柵端壁氣膜冷卻設計成功的關鍵，本文的研究成果增加了對此規律的更深入了解。
  14. An instrument of measuring irrigation water flow with higher precision has been developed by means of integrating smart ic card with turbine flow sensor, which improves the existed flow measuring technique for pumping well from the aspects of precision, sensing, capacity, data storage, safety and monitoring, and then enhances the precision of the irrigation flow measuring device from 1m ^ 3 to over 0. 01m ^ 3

    摘要將渦輪流量傳感器與智能ic卡技術進行集成應用，開發出高精度的灌溉用水計量設備，從精度、傳感、容量、數據存儲、安全、監控6方面提高了現有機井量水技術，將灌溉量水設備精度由1立方公尺提高到0 . 01立方公尺以上。
  15. Ntu " khpi " is the only higher education institution that trains specialists for such important branches of machine - building as turbine construction for atomic, thermoelectric, hydraulic power engineering, heavy electric machine - building, tractor - building, computer control systems for internal combustion engines, boiler - and reactor manufacturing, fat technologies and fat substitutes technologies, tank - building, electrical insulation, cable and condenser engineering

    哈爾科夫工業大學是唯一一所培養下列重要部門的機器製造業專業人材：原子能、火電和水電渦輪機製造，重型電機製造，拖拉機製造，內燃機、鍋爐和反應堆的計算機控制系統，油技術和油替代技術，坦克製造，電氣絕緣，電纜和電容器製造。
  16. The results of computation show that the axial force on the impeller of pump pushes the pump impeller towards turbine, that axial force on the turbine makes the turbine close to the pump impeller, and axial force on guide roller propelles guide roller towards the pump impeller

    實例計算發現，泵輪的軸向力拉動泵輪向渦輪靠近；渦輪的軸向力拉動渦輪向泵輪靠近；導輪的軸向力拉動導輪向泵輪靠近。
  17. Designs and manufactures turbine engine test cells and wind tunnels

    設計生產渦輪發動機測試單元和風洞。
  18. A new model for film cooling effectiveness computation on blade surface in a turbine cascade

    渦輪葉片型面氣膜冷卻效率的計算模型
  19. Two good examples about conjugate heat transfer problem, one with cooling method, the other without cooling inside turbine blade were investigated

    最後進一步地討論了渦輪葉片中無冷卻和有簡單冷卻通道情況下的流/熱耦合計算。
  20. Haibo huang ( mechanical engineering ) directed by jianzhong xu cooling techniques in turbine have become more important since the extra high inlet temperature in turbine

    隨著渦輪前溫度的提高，渦輪葉片的冷卻技術變得十分重要。渦輪葉片中流/熱耦合計算成為必不可少的熱環境分析手段。
分享友人
分享到 Line

分享到臉書