無負荷 的英文怎麼說

中文拼音 [wúfùhé]
無負荷 英文
nl no-load
  • 無 : 無Ⅰ動詞（沒有） not have; there is not; be without Ⅱ名詞1 （沒有） nothing; nil 2 （姓氏） a surn...
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 荷 : 荷名詞（蓮） lotus
  • 負荷 : [電學] load; charge; weight
  1. The elongation of a body in tension above its no-load length is directly proportional to the stretching force.

    物體在拉伸狀態下，其伸長量（相對于無負荷時的長度）與拉伸力成正比。
  2. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。
  3. Using the opened thermosiphon of 38x3 as experimental element and water as working fluid, the characteristics of dynamic low load boiling, stable severe boiling heat transfer coefficient and critical heat flux are gotten for the opened thermosiphon at the pressure of 0. 02 - 0. 1mpa and 0. 1 - 0. 8mpa respectively, which makes up the drawback that the opened thermisiphon has not yet accurate boiling heat transfer relationship formulas. by means of experimental results, an opened thermisiphon waste heat recovery boiler is designed for the high temperature gases that the positi e electrode copper refining furnace exhaust, which overcomes effectively the drawback of short life, little capacity and unable to inspect that the closed steel - water thermosion has

    本文以工程上常用的38 3的開口封底為實驗元件，以水為工質，對開啟式熱管內的動態低負荷沸騰、穩態旺盛沸騰及臨界沸騰特性進行系統的可視化實驗研究，實驗壓力為0 . 02 0 . 8mpa ，實驗得出了38 3的開口封底管在工作壓力為0 . 02 0 . 8mpa和0 . 1 0 . 8mpa下的管內沸騰傳熱系數及臨界熱負荷計算關聯式，彌補了開口封底管? ?這一新型傳熱元件尚無準確的沸騰換熱關聯式的缺陷。
  4. 1. 5 m in diameter ) were dispersed in n46 engine oil with different concentrations using ultrasonic respectively in order to study their tribological properties. the tribological experiments were carried out by mq - 800 four - ball tribometer and mm - 200 ring - on - block tribometer, in which extreme pressure properties, wear scan diameter, friction coefficient and wear volume loss were measured. the results showed that oil containing mos2 nanoparticles had a better wear resistance, friction - reducing and extreme pressure than the oil containing common mos2

    將上述制備得到的納米二硫化鉬顆粒和普通二硫化鉬粉末（ 1 . 5 m ）以不同濃度分散在n46機械油中，在mq - 800四球摩擦磨損試驗機上考察它們的最大無卡咬負荷（ p _ b值） 、耐磨性能和摩擦系數；並在mm - 200摩擦磨損試驗機上，通過環?塊摩擦副，比較和分析了它們的摩擦學特性。
  5. They meet the requirements for non - leaded heavy - duty gear lubricants of high load - carrying capacity, including the ux steel 224 gear oil specification

    適合於無鉛的重負荷齒輪的潤滑要求，符合多種齒輪油標準包括美鋼224規格。
  6. First from system aspect, this paper uses voltage sensitivity, pv curves method, equivalent reactive compensation method, back - up generation method to evaluate the reactive value of the generators in seven buses system and ieee 14 buses system. the vs and pv methods can evaluate the source ' s ability of tracking the load ' s variation. the erc and back - up methods can evaluate the availability of replacing other generators. the value determines the cost

    從對系統貢獻角度，採用電壓靈敏度方法（ vs法） 、 pv曲線法、等效無功補償法（ erc ） 、無功備用方法來確定一個七節點系統中的發電機的無功價值和ieee14節點系統的發電機的無功價值，電壓靈敏度法和pv曲線法可比較出不同電源跟蹤負荷變化的靈敏度大小，而等效無功補償法和無功備用方法可比較出不同電源替換其它發電機是否是最有效率的。
  7. Code of practice for design and installation of non - loadbearing precast concrete cladding

    無負荷預制混凝土護板設計和安裝實用規程
  8. Standard practice for heat aging of plastics without load

    無負荷塑料製品熱老化的標準實施規程
  9. Helical coil screw thread inserts - free running and screw locking inch series

    螺紋襯套.無負荷旋入和螺紋鎖緊英制系列
  10. Helical coil screw thread inserts - free running and screw locking metric series

    螺旋線圈螺紋鑲嵌件.無負荷旋入和螺紋鎖緊
  11. A motor that is be directly coupled to a fan - blade or blower - wheel load is to be operated at the applicable test voltage and under no - fan, no - load conditions with the shaft running free

    直接耦合到一個風扇葉片或鼓風機葉輪負荷的馬達，將在適用的試驗電壓下做無風扇，無負荷，軸空轉狀態的運行。
  12. No - load steam loss

    無負荷漏汽量
  13. Now the common means of testing the performance of engines in real time is noload dynamometer test, which computes the engine power by measuring the average accelerate time

    目前國內外常用的發動機動力性能實時檢測系統是採用無負荷測功法，即通過加速后測定平均加速時間的方式來計算發動機的功率值。
  14. Rate of no - load steam loss

    無負荷漏汽率
  15. Nset no load opeed setting of governor

    調速器的無負荷調整
  16. Investigations have been made on the influence of the heating power, working pressure, stack packing ratio, and the opening of the orifice valve and the double - inlet valve on the performance of the system

    以氦氣為工質，獲得了119 . 7k的脈管無負荷製冷溫度，在國內首次用熱聲機械進入低溫溫區。
  17. Nnl normal no - load spee

    正常無負荷轉速
  18. Test code for machine tools - part 1 : geometric accuracy of machines operating under no - load or finishing conditions

    機床檢驗通則第1部分:在無負荷或精加工條件下機床的幾何精度
  19. Nl no - load

    無負荷，不加載
  20. Cables for signs and luminous - discharge - tube installations operating from ? no - load rated output voltage exceeding 1 kv but not exceeding 10 kv

    無負荷額定輸出電壓1kv至10kv的信號和氣體放電管設備用電纜
分享友人
分享到 Line

分享到臉書