熔結結構 的英文怎麼說

中文拼音 [róngjiējiēgòu]
熔結結構 英文
welded texture
  • 熔 : 動詞（熔化） melt; fuse; smelt
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 構 : Ⅰ動詞1 （構造; 組合） construct; form; compose 2 （結成） fabricate; make up 3 （建造; 架屋） bui...
  • 結構 : 1 （各組成部分的搭配形式） structure; composition; construction; formation; constitution; fabric;...
  1. The results show that there is anomalistic crystal whose size reaches nanometer grade in fine pvc ; the crystal structure is damaged by jet - milling, which induces the melting point of nanocrystal pvc decreases from 210 to 128. the nanocrystal pvc induces the decrease of plasicizing time and equilibrium torque and the increase of maximal torque, which show that the nanocrystal pvc have self - plasticization in pvc composites

    通過sem 、 tem 、 ftir和dsc測試表明：氣流粉碎制得的pvc微粉中具有不規則納米晶體；氣流粉碎破壞了pvc的晶體結構，使納米晶pvc的熔點從210下降到128 ；納米晶pvc使體系塑化時間、平衡轉距的降低、最大轉距升高，具有自增塑作用。
  2. Cobalt based alloy powder for laser cladding

    激光熔覆鈷基合金塗層的組織結構
  3. Abstract : the formation technologies, the structure and properties of tcs microporous man - made yarn - kind new polyester fibre which was spinned in tcs with some micrometallic - oxide have been studied. the results indicate that the rheological behaviour and spinnability of commixed polyester melt, and the structure and properties of the fibre, are relative to the spinning temperature, melt pressure, microporpus size for spinning, formation conditions, thermo - vascellum temperature, thermo - vascellum position and rolling speed, besides the viscosity of polyester cuts, coacervation particles, adding amount and size of micrometallic - oxide

    研究表明， tcs微孔化共混聚酯熔體在成型加工中的流變行為和可紡性，及其纖維的結構性能除了與原料切片的特性粘度、凝聚粒子和共混聚酯中超細金屬氧化物微粒的添加量、粒徑等因素的影響有關外，還與紡絲溫度、紡絲熔體壓力、噴絲板微孔尺寸、冷卻成形條件、熱管溫度、熱管安裝位置以及卷繞速度等因素的影響密切有關。
  4. We might help forge in the crucible of conflict a structure of peace.

    我們就有可能協助在沖突的熔爐中鑄造出一個和平的結構。
  5. In nature, the rights of each species are cast in a broad ecological framework.

    在自然界，所有物種的權利都熔鑄於一個寬廣的生態結構之中。
  6. The difference of reactive mechanisminduced the difference of their structure. v _ 2o _ 5 product prepared by melting - cooling showed more notable undefined structure. after heat - treating under300, particle size becomes smaller, and aggregate to globate grain, showesbetter electrochemical performance at low charge - discharge rate

    熔融淬冷法合成的樣品其無定型結構更明顯，前驅體經過300熱處理后，材料的粒徑變細，團聚成球狀的顆粒，球狀特徵更顯著，在低倍率下具有較好的電化學性能。
  7. A new method should be discovered to design the function block. the thesis is based on the rheology and hydrokinetics of the polymer melt, and calculates the velocity in the die by fem simulation, and provides die design with theory proof. according to the existed theory, i summarize and conclude the fem formula of the polymer flow, and then write the program to calculate on the computer

    本論文中功能塊結構的研究，是以熔體的流變性以及流體動力學理論基礎上，對在口模中的熔體進行數值模擬，計算出熔體在口模中的流動參數（主要是速度的分佈） ，從而可以科學的對功能塊幾何結構進行優化。
  8. The study shows that the products of quasicrystal materials mainly consists of a - ( ti, zr ) solid - solution, i - phase, and c14 - laves phase with the mgzn2 structure type

    通過研究我們發現合成產物主要是由準晶i -相、 （ ti zr ）固熔體相及具有mgzn2晶體結構的laves相所組成。
  9. However, in the area with strong magma mingling, there are widespread abnormal fabrics, distinguished differences in the idiomophic - textures and the peritectic reaction, poililitic texture, metasomatism among the minerals, metasomatic border, embayment, rimmed structure, abnormal plagioclase zoning, relict fabric as well as the acicular apatite are very common

    巖石的異常結構構造十分發育，礦物之間自形程度差異顯著，常見包晶反應、包含結構、交代邊、熔蝕邊、交代蠶食的港灣狀結構構造及交代縫合線、礦物鑲邊、斜長石異常環帶和礦物殘留等，多見指示巖漿混合的標志性礦物針狀磷灰石。
  10. Two kinds of n - substituted pyrrole ( trimethyl - ( 2 - pyrrol - l - yl - ethyl ) - ammonium iodide and 2 - ( 2 - pyrrol - 1 - yl - ethoxy ) - ethane - sulfonate sodium ) were synt hesized ; poly ( trimethyl - ( 2 - pyrrol - l - yl - ethyl ) - ammonium iodide ) / v2os nanocomposites were synthesized by two methods ( monomer in - situ intercalate polymerization and polymer intercalation in solvent ). to fabricate vaos sol by melt quenching, oxygen top - blend technique was applied to improve oxygenic part - pressure, decrease the oxygenic anoxic and restrain the increase of v4 + ion when vos was melted. the xos xerogel prepared by the new technique had more complete structure than the vos xerogel which v20s powder was melted in the air

    針對以v _ 2o _ 5為原料、熔融淬冷法合成v _ 2o _ 5溶膠、制備v _ 2o _ 5干凝膠薄膜這一方法，提出了在v _ 2o _ 5熔融時運用氧氣頂吹工藝這一思路，目的是增加熔體表面的氧分壓，減少熔體的氧缺損，使v _ 2o _ 5干凝膠的v ~ （ 5 + ）離子含量更高、其結構更完整、性能更穩定。
  11. Polybenzoxazine / vermiculite hybrid nanocomposites were prepared from two kinds of polybenzoxazine precursors and two kinds of organically modified - vermiculite minerals and expanded - vermiculite which were consisted of vermiculite, hydrobiotite and phlogopite. after treatment of vermiculite minerals by hexadecyl trimethylam monium bromide ( ctab ), the d001 of vermiculite layers of vermiculite mineral increased from 1. 43nm to 2. 67nm and developed a d002 = 1. 34nm

    本文分析了蛭石精礦和膨脹蛭石的組成和結構，用十六烷基三甲基溴化銨（ ctab ）進行了有機化處理，再通過熔融或溶液混合插層苯並嗯嗪樹脂（ ben ）制備了ben插層蛭石納米復合材料，並採用蒙脫土進行了對照實驗。
  12. Study on the preparation and relationship between micro - structure and mechanical properties of epoxy / rubber / clay composites epoxy / rubber / clay composite has been prepared by the melted intercalation of octadyl ammonium exchanged montmorillonite ( c18 ) with dgeba and carboxyl - terminated butadiene - acrylonitrile random copolymers ( ctbn ), and piperidine as the curing agent

    環氧樹脂橡膠粘土三元復合材料採用熔融共混法制備了環氧樹脂橡膠粘土三元復合材料，就ctbn 、 c18含量、加料順序和固化工藝等制備工藝對c18在三元復合材料結構以及材料的力學性能的影響進行了研究。
  13. The effects of melting and pulverization technics on the electrochemical properties and microstructure of the ab5 - type hydrogen storage alloys were summarized

    綜述了熔煉及制粉工藝對其微觀組織結構和電化學性能的影響，旨在使人們對其有一個全面的了解。
  14. By analyzing the microstructure of as - cast alloys with different surplus of samarium added, the optimum surplus of samarium is decided. by comparing the microstructure of the alloys annealed for different time, the ideal and economical annealing time is confirmed. the microstructure and phase composition of alloys during the whole preparation of sm2fe17nx are analyzed using the scanning electron micrograph with energy - dispersive x - ray analysis and x - ray diffraction patterns

    本論文首先就熔煉工藝參數對鑄態組織微結構的影響進行了探討，並制定出一套較為合適的熔煉工藝；通過對不同釤加入量的鑄態組織微觀結構的觀察分析，確定了原料配置過程中釤的最佳補償量；通過對採用不同退火時間的合金組織進行比較，確定了理想、經濟的退火時間；同時還利用掃描電子顯微圖像和x射線衍射圖譜，比較了整個制備過程中，試樣微結構和相組成的變化情況。
  15. The analysis of ir spectrum and melt flow index showed that the composite had a micro - crosslinking structure, and the analysis of dsc discovered there was - spherulite in the aggregate structure of the composite of pp

    紅外光譜分析和熔體質量流動速率的測定表明，復合材料體系產生了微交聯； dsc分析發現， pp材料的聚集態結構中含有球晶。
  16. Study on the relationship between the melting point the hardness of the alkaline earth metal oxide and the electron structure

    堿土金屬氧化物熔點和硬度變化規律與電子結構的關系
  17. Molecular dynamics simulation and application in the research of metal melt structure

    分子動力學模擬技術及其在金屬熔體結構研究中的應用
  18. Cl, s, f, tongchang porphyry copper deposit and the dajishan tungsten deposit are selected as the studying objectives, detailed investigations have been conducted into the geological and geochemical characteristics of the granitic rock, biotite, trace element and ree geochemistry, fluid inclusion geochemistry and the partitioning coefficients of the f, cl, cu, w. based on these data, the following conclusions are drawn : ( 1 ) fluorine can reduce the viscosity and density of magma, temperature of solide - liquidus line and change the melt frame, but cl has little effect on the melt

    主要的認識如下： （ 1 ） f在花崗質巖漿中，可以降低巖漿的粘度、密度、固液相線溫度、改變熔體結構，而cl對熔體結構沒有多大的影響。 f在流體?花崗質熔體相間，絕大多數配分系數小於1 . 0 ，趨向于熔體相中配分， d _ f隨體系中f濃度的升高而增加。
  19. Modification effect andmechanism of sr, na in al - si alloy

    合金熔體結構的影響
  20. Molecular dynamics computer simulation of structure of lacl3 - kcl melt

    熔體結構的分子動力學研究
分享友人
分享到 Line

分享到臉書