熱力學特性 的英文怎麼說

中文拼音 [rèlìxuétèxìng]
熱力學特性 英文
thermodynamic behaviour
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 學 : Ⅰ動詞1 （學習） study; learn 2 （模仿） imitate; mimic Ⅱ名詞1 （學問） learning; knowledge 2 （學...
  • 特 : Ⅰ形容詞（特殊; 超出一般） particular; special; exceptional; unusual Ⅱ副詞1 （特別） especially; v...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 特性 : characteristic（s）; character; performance; features; properties; behaviour; response; character...
  1. A lot of engineering applications are carried out using our proposed method in this paper, such as thermal deformation measurement of a car lamp, analysis of the super low frequency harmonic vibration of a piezoelectric ceramic, dynamic mechanical behavior analysis of the ballistite material and so on

    在前面所提出的理論基礎之上，本文對該方法在實際工程中的應用做出了大量的工作。本文利用時間序列法實現了汽車前燈配光鏡的熱變形檢測、壓電陶瓷片的超低頻振動分析以及火箭固體燃料的動態力學特性研究。
  2. Whereas art historians will dilate on the symbolism of capturing the visual world in the convex mirror prominently displayed on the rear wall, i will be concerned instead with its optical properties, such as its focal length and light - gathering power

    藝術史學者會注意後面墻上那面醒目的凸面鏡，對它捕捉了視覺世界的象徵意義加以熱烈討論，而我則會專注於它的光學特性，如焦距與聚光能力。
  3. This thesis first studies the hydrokinetics, heat transfer characteristics, combustion and dynamics of cfbb. three types of single fuzzy controllers and a kind of synthetically fuzzy controller are designed, through the analysis of the control system of a certain plant

    本文通過對循環流化床的流體動力學特性、傳熱學特性、燃燒特性和動態特性等方面的研究，設計了三種單模糊控制器和一種綜合模糊控制器，分析了某一電廠實際控制系統，並對方案進行了比較。
  4. Through the study on the character of hydrokinetics and heat transfer and combustion and dynamic of cfbb, three kind of single fuzzy controllers and a kind of synthetically fuzzy controller are designed, and control system is analyzed in some one power plant, and the three kind of control scheme are simulated on deferent objects

    本文通過對循環流化床的流體動力學特性、傳熱學特性、燃燒特性和動態特性等的研究，設計了三種單模糊控制器和一種綜合模糊控制器，分析了某一電廠實際控制系統，並對這三種控制方案進行了變對象的模擬。
  5. Theoretical analysis and testing results demonstrated that viton, a new substitute of the former plasticizer, could noticeably improve its performances, which has been proved as the important improvements of the mixture. due to the favorable thermochemistry performance, dicyandiamide can act as a good combustion - rate regulator. the addition of antistatic agent can desirably increase the antistatic capability of the mixture, and the testing results showed that the performance of the improved mixture was excellent

    理論分析和測試結果均表明了以氟橡膠取代耐水點火藥中原粘合劑將使藥劑的各項性能有明顯的改善，是耐水點火藥改進的重要方面；雙氰胺具有良好的熱化學特性，作為耐水點火藥改進中的燃燒速度調節劑具有很好的調速效果；抗靜電劑的加入，進一步提高了藥劑的抗靜電能力，測試分析表明改進后藥劑的性能更加優異。
  6. Characteristic thermodynamic function

    熱力學特性函數
  7. The theoretical analysis on the operational characteristics of gshps taking into consideration of the characteristics that taking soil as the heat source and cold source, by means of thermodynamic methods, the theoretical research on the operational changing patterns of gshps with a scroll compressor using r22 as refrigerant has been conducted

    土壤源熱泵系統運行特性的理論分析針對以土壤為冷熱源的特點，運用熱力學的方法，對r22渦旋壓縮式土壤源熱泵系統的運行變化規律進行理論研究。
  8. In the third chapter of this dissertation, based on the physical and chemical properties of hydrogen and the combustion characteristics of hydrogen, the quasi - dimension combustion calculation model of hydrogen ? fueled engine is set up through analyzing the characteristics of turbulence flame and chemical reaction kinetic of hydrogen ? air mixture. the model includes the dual ? area thermodynamics sub - model, quasi - dimensional turbulent entrainment combustion sub ? model, turbulence flame promulgating sub ? model, hydrogen - air mixture chemical kinetic sub - model and loss of heat transfer sub - model and so on

    本文從氫燃料的物化特性和燃燒特徵著手，通過分析氫空氣混合氣燃燒的湍流火焰結構和燃燒化學反應動力學，基於雙區燃燒模型，建立了包括雙區熱力學、準維湍流卷吸燃燒、湍流火焰傳播速度、氫空氣混合氣燃燒化學反應動力學以及傳熱損失等模塊的燃燒模型，並給出了相應的計算方法。
  9. The numerical simulation of axisymmetric two - dimensional shock tube is studied, which has a conical convergent section, and its driving gas is the hot product of hydrogen oxygen detonation. finite volume tvd scheme is adopted and the mesh is local orthogonal. the primitive equations are euler s equations of multi - component flow. the new method of eliminating numerical oscillation at the interface of two materials is extended to two dimensions. the mechanical character of this shock tube is analyzed

    對由前向爆轟產生驅動氣體並具有局部錐形收縮截面的軸對稱激波管利用兩相常比熱完全氣體的歐拉方程組和有限體積tvd格式在局部正交的網格上進行了二維數值模擬。將消除兩種介質界面處數值振蕩的新方法成功地推廣到二維情況。分析了該激波管的力學特性。
  10. It is the first time to use the conventional espi system ( neither phase shifting nor carrier is used ) to continuously analyze the super low frequency vibration with high quantitative in the world

    在火箭固體燃料動態力學特性研究中，時間序列法成功的給出了固體燃料的蠕變曲線和蠕變速率曲線，並且給出了其熱變形和蠕變不同時刻的全場位移分佈。
  11. This paper aims at the characteristics of thermal response of lpg vesse1 under high temperatue, conjoining the project of " study on transportation safety early - wdring system of lpg dangerous goods " supported by transportation departinen of china and the project of " mechanism study and numerical simulation of the explosion of lpg vessel " supported by science foundation of hubei province. the interdisciplinary research has been done among temperature field distribution of lpg vessel under flame surroundings, intensity calculation, crack propagation predication and mechanism of explosive accident, etc. three parts are analyzed and discussed

    本文針對高溫環境下液化氣壓力容器的熱響應特性問題，結合交通部重點科技項目「液化氣體類危險品運輸安全預警系統的研究」和湖北省自然科學基金項目「液化氣容器爆炸機理研究及數值模擬」 ，對在火焰包圍下的液化氣壓力容器的溫度場分佈、強度計算、裂紋擴展預測以及爆炸事故機理等方面開展了多學科的交叉研究。
  12. These problems boost the study of high - k materials as the alternatives of sio2 gate dielectrics. among all high - k gate dielectric materials, hafnium oxide ( hfo2 ) is being extensively investigated as one of the most promising candidate materials due to its superior thermal stability with poly - si, biggish constant and reasonable band alignment. our researches focus on hfo2 dielectrics

    高k柵介質材料已經被廣泛地研究來替代sio _ 2 ，以降低柵泄漏電流和改善可靠性，其中， hfo _ 2由於其較大的介電常數、較大的禁帶寬度、與si的導帶和價帶較大的偏置、以及與si的高的熱力學穩定性等特徵，被認為是最有希望的替代sio _ 2的柵介質材料之一。
  13. According to dynamical characteristic of the bubble motion in the flow field, and under the assumptions of isothermal system without interior heat source, uniform bubble size, and ignoring surface tension, the mathematical expressions for interfacial momentum exchanges have been deduced which include drag, virtual mass force, and lift

    針對氣液泡狀流中氣泡運動力學特性，在系統絕熱、無內熱源、忽略表面張力、氣泡尺寸均一前提下建立了氣液相間曳力、虛質量力、升力的數學模型表達式。
  14. Mechanical behavior of tini shape memory alloy in constrained thermal cycles

    形狀記憶合金絲在約束態熱循環后的力學特性
  15. The process parameters of electric upsetting include : velocities of upsetting cylinder and anvil cylinder, heating current, preheating length and time, etc. because different materials have different mechanical, electric and thermal characteristics, and there are effects between different parameters, the determination of those parameters becomes a complex problem

    電熱鐓粗成形過程的工藝參數主要包括鐓粗缸活塞運動速度、砧子缸活塞運動速度、鐓粗壓力、加熱電流和預熱長度等。這些參數的選擇是一個復雜的問題，其復雜性不僅在於不同的材料具有不同的力學、電和熱傳導特性，而且各參數相互影響、相互制約。
  16. And non - fourier heat conduction is encountered. when the wavelength of the heat carrier is comparable to the characteristic length of the structures, or the time of heat conduction is shorter than that required for reaching the state of thermal equilibrium, the heat conduction has wave characteristics

    當載熱體的微時間尺度與能量激發特徵時間相比擬時，或者傳熱發生的時間比達到熱力學平衡態所需的時間短時，熱傳導就可能出現波動性質。
  17. This paper analyzes the percolation mechanism and characteristics of gas under low - velocity percolation state in terms of slippage effect and threshold pressure effect by using molecular dynamics, thermodynamics and percolation mechanics in order to understand the practical reason of low - velocity non - darcy percolation

    摘要為明確氣體在低速滲流狀態下的滲流規律以及產生低速非達西滲流的實質性原因，運用分子動力學、熱力學和滲流力學等相關知識，基於滑脫效應和閾壓效應兩方面分析了氣體在低速滲流狀態下的滲流機理及滲流特徵。
  18. Based on thermodynamics laws, inner - variable theory and analysis of conventional tn - axial tests data and breakage characteristics of loess, this paper proposed that the loess would produce elastic, plastic and nonreversible damage deformation during loading

    從熱力學定律和內變量理論出發，在對常規三軸試驗數據和土樣的破壞特性分析的基礎上，認為土體在受力過程中將產生彈性變形、塑性變形和不可逆損傷變形。
  19. Study on heat transfer characteristics in microtube under heating of constant heat flux

    形螺旋槽管傳熱與流體力學特性研究
  20. First, the dynamics characteristics of the heat - exchanger unit is analyzed carefully by using the knowledge of the fluid dynamics and heat transfer etc., and makes some reasonable simplicities and assumptions. so it establishes the mathematical model of the working process of the heat - exchange unit, and applies the recurrence parameter estimator to identifying and proving

    本文首先綜合應用流體力學、傳熱學等方面的知識，分析了換熱機組的動力學特性，通過合理的簡化和假設，建立了換熱機組工作過程的數學模型，並使用遞推參數辨識器對其主要參數加以估計和驗證，從而得到換熱機組的carma （受控的自回歸滑動平均）或carima （受控的自回歸積分滑動平均）模型。
分享友人
分享到 Line

分享到臉書