熱擴散比 的英文怎麼說

中文拼音 [rèkuòsǎnbǐ]
熱擴散比 英文
thermal conversion ratio
  • 擴 : 動詞（擴大） expand; enlarge; extend
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  1. The samples were welded at 800, 900. d _ ( cu ) and dni at contacting line increased with increase of welding temperature. and atom diffusion at contacting line welded by bpec heating was much quicker than by radiation heating

    其它條件相同時，改變裝模方式以獲得不同的加熱條件和電場條件，結果表明，無模套時接觸面處cu和ni的擴散系數比有模套時大。
  2. Pulse electric current heat treatment ( pecht ) developed by sodick, ltd., of japan, is a recently developed material processing method which consists of spark plasma sintering and welding, plasma activated sintering and welding, big pulse electric current ( bpec ) diffusion welding etc. the following are basic merits of pecht : rapid heating and cooling ; short sintering or welding time ; lowering sintering or welding temperature

    脈沖電流熱加工（ pulseelectriccurrentheattreatment ，比如燒結，焊接等）是九十年代發展起來的一種材料快速制備新技術，它包括放電等離子燒結與焊接、等離子活化燒結與焊接、脈沖大電流擴散焊接等。它具有升溫、降溫速度快、能在較低的溫度下燒結或焊接以及時間短的特點。
  3. The effects of the fabrication conditions on the crystal structure, grain size, micromorphology and electrochemical performance of these materials have been studied in depth. the reaction mechanism of the low - heating solid - state reaction method has also been investigated. in addition, a novel electrochemical method ( rpg method ) based on the concept of " ratio of potentio - galvano - charge capacity " has been for the first time developed to determine the diffusion coefficient of lithium - ion within insertion - host materials on the basis of the spherical diffusion model

    本論文較系統地考察了低熱固相反應法合成鋰離子電池正極材料的可行性問題，研究了工藝條件對材料的晶體結構、晶粒尺寸、微觀形貌及電化學性能等的影響，探討了低熱固相反應的機理，並通過引進「恆壓-恆流充電容量比」的概念，給出了一種測定鋰離子嵌入脫出固相擴散系數的新方法。
  4. The samples were joined with heat rate of 200 / min, 260 / min, 370 / min

    與輻射加熱相比，接觸面處原子擴散速率加快。
  5. The diffusion carrier concentration profile and junction depth were measured and compared with conventional furnace processing diffusion ( cfd ). it presented following conclusions : 1 ) the temperature distribution in quartz chamber of rtd furnace is uniform because square resistance is uniform after rtd ; 2 ) the diffusion velocity of rtd furnace by a factor of three compare to conventional furnace processing diffusion ( rtd ) ; 3 ) if diffusion temperature and doping phosphorus are equivalent, doping phosphorus of rtd are more than of cfd in equivalent distance to the silicon surface

    實驗研究了快速熱擴散（ rtd ） ：通過旋塗磷膠和印刷磷漿兩種方式考查了2 4和103 103單晶硅的快速熱擴散特性，發現： 1 ）此樣機的溫度場在空間分佈上是均勻的； 2 ）快速熱擴散可以比傳統擴散快3倍的速度進行擴散； 3 ）在擴散溫度和摻雜磷源相同的條件下，與傳統擴散相比，快速熱擴散將雜質向結更深的地方推進。
  6. A two - dimensional double diffusive laminar natural convection in rectangular enclosure is detailed analyzed. the results show that when the thermal and solutal buoyancies aid each other, the airflow consists of one main cellular structure and is steady, regardless of the relative strength variation between the heat and pollutant sources. there are multiple flow structures, however, according to the relative strength when the buoyancies opposing each other

    模擬結果表明雙擴散自然對流系統的空氣流動與傳熱傳質特性完全是由離散熱源與污染源浮升力之間的相互作用關系訣定的：當離散熱源與污染源浮升力協同作用時，自然對流呈比較穩定的單一流動結構；而當熱源與污染源浮升力對抗作用時，自然對流系統隨它們之間強度變化呈現出多種流動狀態。
  7. Test methods of thermal diffusivity, specific heat capacity, and thermal conductivity for fine ceramics by laser flash method

    激光閃爍法測定精細陶瓷的熱擴散率比熱容量熱傳導率試驗方法
  8. Limiting the extraction of great amount of heat from the underground even more is the low thermal conductivity and low thermal diffusivity of rocks.

    由於巖石的熱導率和熱擴散率都比較低，更加限制了地下熱能的大量抽取。
  9. The membrane properties were found to be dependent upon the content of styrene. the membrane physic - chemical properties compare to nafion 117 except that their chemical stability has to be further improved to make them acceptable for practical use in the proton exchange membrane fuel cell. the proton transport through the membrane follows the " liquid - like " proton conductivity mechanism y and the water balance is important for the working condition of the fuel cell

    對磺化膜的研究分析表明：膜的性能參數如離子交換容量、吸水率、水合系數、形體穩定性、導電性能、化學與熱穩定性等依賴于膜中苯乙烯含量，且接枝苯乙烯相互間的位阻效應對膜性能影響很大；膜的性能可與nafion膜相比較；質子在膜中的傳導遵循「似液體」質子傳導機理；電滲析與擴散作用使膜保持水平衡。
  10. Vacuum coating machine, vacuum coating equipment, diffusion pump, vacuum plating factory, vacuum coating, ion injector, vacuum thermal treatment, vacuum thermal treatment equipment, vacuum equipment, thermal treatment equipment - longkou bite vacuum technology co., ltd

    真空鍍膜機，真空鍍膜設備，擴散泵，真空電鍍廠，真空鍍膜，離子注入機，真空熱處理，真空熱處理設備，真空設備，熱處理設備-口市比特真空技術有限公司
  11. In this paper, we discuss fick law and the thermodynamics theory which can be used to describe diffusion phenoma, and find that the thermodynamics theory not only can be used to describe the contrary diffusions and other various diffusions, but also can be used to deduce fick law, so it has a wider range of application

    摘要本文討論了描述擴散現象的菲克定律與擴散的熱力學理論，指出擴散的熱力學理論可以描述包括逆擴散現象在內的眾多擴散現象，並可導出菲克定律，因而比菲克定律具有更廣泛的適用性。
  12. The titanium alloy valve is more superior than ordinary steel valve in lighter, smaller thermal expansion coefficient, lower in thermal expansion, fatigue durable, good elasticity, and reduces oil consumption so as to prevent instability while revolving at high speed and obtain perfect performance

    鈦合金汽門彈簧比一般鋼閥材質更輕巧、熱膨脹系數小、熱量傳導擴散更低、耐疲勞、彈性佳、減少油耗，以阻止在高速運轉下的不穩定以獲致最完美的性能表現。
  13. Abstract : water solution polymerization and precipitation polymerization of ethenyl radical monomers were carried out at same conditions, and the differences between the products in molecular weight and other aspects were investigated

    文摘:針對目前溶液聚合體系中、後期粘度高，熱擴散不利，從而影響分子量提高的問題，進行乙烯基類單體在同等條件的水溶液聚合及沉澱聚合，比較了獲得的聚合物產物在分子量及應用性質上的差異。
  14. The results show that the thermal diffusivity of thin film is smaller than its corresponding bulk material, and with the decreasing of the thickness, the thermal diffusivity also decreasing

    ）的二氧化硅薄膜、氮化硅薄膜、多晶硅薄膜的熱擴散率，實驗結果表明，薄膜的熱擴散率比其體材料的要小，並且隨著薄膜厚度的減小，熱擴散率也減小。
  15. Both hydrogen plasma and sinx thin film can effectively enhance the short circuit current density of mono and poly silicon solar cells, which cause the improvement of the absolute transfer efficiency about 0. 5 % ~ 2. 9 %. depositing sinx thin film followed by hydrogen plasma treatment will result in better passivation effect. the thickness of sinx thin film will decrease and the refractive index will increase after annealing

    經過薄膜後退火處理發現，氮化硅薄膜經熱處理后厚度降低，折射率升高，但溫度達到1000oc時折射率急劇降低；沉積氨化硅薄膜后400oc退火可以促進氫擴散，提高鈍化效果；超過400oc后氫開始逸失，晶體硅材料中的少子壽命急劇下降； rtp （快速熱處理）處理所導致氫的逸失比常規退火處理顯著。
  16. The heat transfer and thermophysical properties of thin films, including thermal conductivity and thermal diffusivity, differ from the corresponding bulk material when it comes into microscale regime

    進入微尺度以後，薄膜材料的導熱規律以及熱物性（包括熱擴散率、熱導率）與體材料相比發生了很大的變化，出現了超常現象。
  17. Additional annealing experiments in nitrogen atmosphere revealed that the heavily damaged region with hydrogen - induced defects appears to be the adsorption center for the outside oxygen to diffuse into the silicon during the high - temperature annealing process, and consequently, broaden the thickness of the box layer. this important finding may provide a possible solution to reduce the cost of the conventional simox - soi wafers while maintaining a desirable box thickness

    獨特設計的氮氣氛退火及分步退火實驗證明了原注入樣品的缺陷層中氫及氫致缺陷的存在使得在退火過程中加速外界氣氛中的氧擴散進來，並成為強捕獲中心使擴散進來的氧滯留于缺陷層從而促使氧缺陷層中的氧沉澱生長，加速了高溫退火中的內部熱氧化過程，從而形成了比傳統相同劑量simoxsoi厚得多的氧化埋層。
  18. The simulation of flow, heat transfer, combustion, species diffusion, and analysis of the result got pleased conclusion and provide important basis for the designing of the sncr system

    通過對流動、傳熱、燃燒和組分擴散進行數值模擬和分析，獲得了比較滿意的結果，為鍋爐進行sncr改造提供了參考依據。
  19. Numerical results are obtained for velocity, temperature and concentration profiles, variations of both nusselt and sherwood numbers under different buoyancy ratio and inclination angles of = 15 - 90. at a given inclination angle, heat and mass transfer rates decrease with heat and mass buoyancies and the buoyancy ratio b decrease from high positive values, and then increase again with the buoyancy radio b further decreasing after the velocity and transfer rates reaching a minimum

    研究結果表明：傾斜角度一定，當熱浮力與物質擴散浮力共存且二浮力之比b從較高正值變化到較高負值時，流體速度和熱質傳遞速度從高逐漸變低並出現最小值，此後隨著向下浮力的增大，流體向下流動且隨| b |的增大而加速，熱質傳遞速率隨| b |的增大而重新增大。
  20. All these indicate that diffusion binding technique is available approach for connecting the metallic slice sheet

    實驗結果表明真空固態熱擴散焊接是一種比較理想的金屬分層板連接方法。
分享友人
分享到 Line

分享到臉書