熱氧化降解 的英文怎麼說
中文拼音 [rèyǎnghuàjiàngjiě]
熱氧化降解
英文
thermal oxidative degradation-
The photocatalytic activity of the samples was evaluated by the photocatalytic oxidation of nitrogen monoxide in the gaseous phase and the photocatalytic decolorization of methyl orange solution in the aqueous phase, respectively. the titania thin films on fused quartz were prepared by lpd method and then calcined at different temperatures
用液相沉積法在石英玻璃上制備了二氧化鈦薄膜，並在不同的溫度下進行熱處理，用甲基橙水溶液的降解脫色評價二氧化鈦薄膜的光催化活性。The results indicated that the dimension, shape and purity of base material could meet the functional demand of solid lubricant ; the thermal decomposition temperature of ptfe resin exceeds 400 c, but organic and inorganic packing filler added in ptfe made the water absorption rate of composite material increased, melting temperature and decomposition temperature decreased, in the meanwhile oxidative decomposition reaction was accompanied ; polar groups such as c = o, c - o - c and so on in the carbon fiber surface is advantageous to increase compatibility with other components and interlayer shearing strength ; uniform design experimental method could help to find the relationship between formula and frictional property by relatively small tests. the developing trend of each formula ' s friction coefficient could be showed by fitting curve ; the friction coefficient with no copper powder or graphite in formula was relatively big. this fact showed that copper powder and graphite should be used cooperatively ; it was found that when the ratio of copper powder to graphite by weight is 15 : 60, 30 : 30 - 40 and 60 : 15 - 30 respectively, the friction coefficient was relatively small. the degree of crystallinity of pure ptfe reached maximum by air cooling and the abrasion loss also reached maximum among three ones ; at the same time, the abrasion loss of solid lubricant sample was also the biggest among three ones ; when solid lubricant matched with 45 # steel axle or gcrl5 steel axle, lubricant transfer film could be formed on metal surface, thus direct contact between the surface of metal friction pair rings was reduced. their working life was elongated extremely ; there was mainly much graphite, a little ptff, moo3, feso4, cus and so on in lubricant transfer film
試驗結果表明：所選原料的尺寸、形狀及純度可滿足固體潤滑劑的性能要求；聚四氟乙烯樹脂熱分解溫度超過400 ，但在ptfe中加入無機填料會使復合材料吸水率提高，熔融溫度及分解溫度降低，且伴有氧化分解反應；碳纖維表面含有c = o及c - o - c等極性基團，有利於提高其與其它組分的相容性，提高層間剪切強度；均勻設計試驗方法能夠用較少的試驗次數找出配方與摩擦性能間的關系，擬合曲線基本能表示各配方的摩擦系數發展趨勢；配方中不加銅粉或不加石墨，其摩擦系數均較高，說明銅粉和石墨應該配合使用；當銅粉15份、石墨60份時，銅粉30份、石墨30 - 40份時，銅粉60 、石墨15 - 30份時，摩擦系數均具有較低值；純聚四氟乙烯樹脂在空氣冷卻時結晶度最大，磨損量也是三者中最大的；同時，固體潤滑劑試樣在空氣冷卻時的磨損量也是三者中最大的：不論是固體潤滑劑與45 #鋼軸配副或是固體潤滑劑鑲嵌入銅套后與gcr15鋼軸配副，在金屬表面均可形成潤滑轉移膜，從而減少金屬摩擦副表面間的直接接觸，大大延長其使用壽命;轉移膜中主要含有較多的石墨、少量聚四氟乙烯、 moo 。Thermal oxidative degradation
熱氧化降解Study of thermal oxidation degradation of shenfu coal at ambient temperature in a fixed - bed reactor
神府煤固定床低溫熱氧化降解研究Standard practice for heat aging of oxidatively degradable plastics
氧化降解塑料熱老化標準規范Insulating and sheathing materials of electric and optical cables - common test methods - methods specific to polyethylene and polypropylene compounds - tensile strength and elongation at break after conditioning at elevated temperature - wrapping test after conditioning at elevated temperature - wrapping test after thermal ageing in air - measurement of mass increase - long - term stability test - test method for copper - catalyzed oxidative degradation
電纜和光纜的絕緣和護套材料.通用試驗方法.聚乙烯和聚丙烯化合物專用方法.高溫處理后抗拉強度和斷裂伸長度.高溫處理后的卷繞試驗.在空氣中熱老化后的卷繞試驗.質量增加的測量.長期穩定性試驗.催化銅氧化降解的試驗方法The simulations results show that the average combustion temperature is much lower in fuel - rich state and little higher in oxygen - rich state near the best o / f ratio. by extending the post - chamber length the oxidizing gas and the fuel pyrolytic gas can burn completely and the average combustion temperature can be prominently increased. the fuel - rich recirculation zone close to the head of combustion chamber is very important for the combustion
計算結果分析表明：發動機在富燃狀態下平均燃燒溫度偏低，在接近理想配比的富氧狀態下平均燃燒溫度有所提高；加長補燃室可以大幅度提高發動機的平均燃燒溫度，並促進氧化劑氣體和熱解氣體的充分燃燒；燃燒室頭部的富燃迴流區對發動機的燃燒非常重要，去掉燃燒室頭部突擴段后，氧化劑氣體和燃料熱解氣體不能充分燃燒，發動機的平均燃燒溫度大幅下降。Practice for heat aging of oxidatively degradable plastics
可氧化降解塑料的加熱老化實施規程Common test methods for insulating and sheathing materials of electric cables. part 4 : methods specific to polyethylene and polypropylene compounds. section two : elongation at break after pre - conditioning - wrapping test after pre - conditioning - wrapping test after thermal ageing in air measurement of mass increase - long - term stability test appendix a. test method for copper catalysed oxidative degradation appendix b
電纜絕緣和護套材料通用試驗方法第4部分:聚乙烯和聚丙烯混合料專用試驗方法第2節:預處理后斷裂伸長率試驗-預處理后卷繞試驗-空氣熱老化后的卷繞試驗-測定質量的增加附錄a :長期熱穩定性試驗附錄b :銅催化氧化降解試驗方法Insulating and sheathing materials of electric and optical cables - common test methods - part 4 - 2 : methods specific to polyethylene and polypropylene compounds - tensile strength and elongation at break after conditioning at elevated temperature - wrapping test after conditioning at elevated temperature - wrapping test after thermal ageing in air - measurement of mass increase - long - term stability test - test method for copper - catalyzed oxidative degradation
電纜和光纜的絕緣和護套材料.通用試驗方法.第4 - 2部分:聚乙烯和聚丙烯化合物專用方法.高溫處理后抗拉強度和斷裂伸長度.高溫處理后的卷繞試驗.在空氣中熱老化后的卷繞試驗.質量增加的測量.長期穩定性試驗.催化銅氧化降解的試驗方法Moreover, the sio2 / tio2 composite thin film showed the lowest pl intensity due to a decrease in the recombination rate of photo - generated electrons and holes under uv light irradiation, which further confirmed the film with the highest photocatalytic activity at 700 c. when the calcination temperature was higher than 700 c, the decrease in photocatalytic activity was due to the formation of rutile and the sintering and growth of tio2 crystallites resulting in the decrease of surface area
同時，此時sio _ 2 / tio _ 2復合薄膜的熒光光譜顯示最低的熒光強度，這表明此時薄膜中的光生電子和空穴的復合速率最低，因而更有利於物質的光催化降解。當熱處理溫度高於700時，武漢理工大學碩士學位論文薄膜的光催化活性下降，這是由於薄膜中晶相二氧化欽的燒結和成長導致樣品的表面積下降以及金紅石相的形成。Thermal - oxidative degradation
熱，氧化降解分享友人