熱通量變換器 的英文怎麼說
中文拼音 [rètōngliángbiànhuànqì]
熱通量變換器
英文
thermal flux transformer-
Secondly, in phase unwrapping to overcome the spread of wrong point, changing the patch of unwrapping phase is done to improve the correctness of it. then, the relation between the unwrapping phase and the height of reconstructed object is discussed detailedly. the data processing, algorithm analysis and reconstructing object are done for the collecting fringe image which are all based on matlab language, in all these achievements, the improvement and innovation aspect are following : a ) in order to stabilize the interference fringe, a new equivalent shifting object method is presented by using fringe stabilizing device to stabilize the interference fringe though moving object and ccd camera which fixed on a precise moving platform together, the experimental result shows the fringe drift is less than a / 20 in five minutes, and the equivalent phase shifting precision is x / 100
論文在全面闡述了光學三維輪廓位相測量術的發展、應用現狀、研究熱點及未來發展趨勢的基礎上，簡要介紹了傅立葉變換和相移位相輪廓測量術的基本原理，對兩種測量方法存在的問題及誤差進行詳細分析和比較；針對位相解包裹錯誤點的傳播問題，作者通過改變解包裹路徑來提高位相解包裹的正確性；分析討論從解包裹位相（ x ， y ）到再現物體的高度h （ x ， y ）物理量之間的關系，研究相應的演算法，利用matlab平臺，對實際採集的條紋圖像進行處理和輪廓重構，其中改進及創新工作主要表現在以下兩個方面： （ a ）針對干涉型結構光場干涉條紋出現的漂移抖動對相移的影響，提出了一種用條紋穩定器穩定干涉條紋，用精密移動平臺使物體和ccd攝像頭同步移動實現等效相移的方法，建立了相應的測量系統，系統的條紋穩定可以達到。The paper analyzes the non - lineal relations of the quantity of heat exchange and water flux of coil exchanger in part - load operating condition, the shortage of deciding the water flux in bypass pipe, the disadvantage that the operating condition of pumps and chiller ca n ' t be met with the load change of the air conditioning system in different operating condition of using pressure - difference bypassing control in primary water pump system. using load control method in the change of the operating condition of primary water pump system can realize that the load change is small and reasonable in the on / off condition of pumps and m m chiller by comparing load control method in primary variable - flow water pump system with pressure - difference bypassing control method, back water temperature control method
本論文從目前空調工程中使用的變流量水系統入手，研究了盤管換熱器在部分負荷下水流量與換熱量的非線性關系，分析了文獻中介紹的旁通管通流能力選擇的不足之處和一次泵水系統採用壓差旁通控制時，工況轉換不能滿足系統控制要求的缺陷；比較了一次泵變流量水系統中壓差旁通控製法、回水溫度控製法、負荷控製法的精確性，並得出了在一次泵水系統的工況轉換時，採用負荷控製法能使冷水機組及其相應水泵在啟停時的負荷變化范圍較小，更符合建築物的冷量需求，節能效果較好的結論。At present, people usually use birefrigence and quasi - phase - matching methods to achieve higher effiency in the process of conversion. a significant advantage of quasi - phase - matching method is that the interaction is occurred through the largest element of the x ( 2 ) tensor ; the period of optical superlattice can be designed randomly, and any interaction can be matched without walk - off angle ; they are fitted to be used in frequency conversion of lower power especially. the quasi - phase - matching method has some advantages over birefrigence method, improving the efficiency of frequency conversion ; the range of frequency conversion covers its whole transperant wavelength
由於準相位匹配技術有其獨特的優勢，可以利用非線性光學晶體的最大二階極化張量，如ppln 、 pplt 、 ppktp用的非線性極化張量都是d _ （ 33 ） ，其有效非線性系數高出普通非線性光學介質（如bbo 、 lbo 、 ktp ）一個數量級，而且可以人為靈活設計調制周期，通過周期設計其頻率變換范圍可以覆蓋準相位匹配介質的整個透明波段，選擇無走離效應，解決了常規pm難以解決的問題，拓寬了非線性晶體的應用范圍，極大地提高了頻率轉換效率，已成為非線性光學材料和固體激光器的研究熱點之一。Of the currently available coolers for electronic products with a high heat flux, microchannel heat sinks have been proved to be able to provide the best heat transfer performance and are one of the most promising coolers. the manifold microchannel ( mmc ) heat sink has many advantages such as low thermal resistance, compact structure, little amount of coolant, low flow rate, uniform temperature distribution along the flow direction and many others, so it is able to provide the best heat transfer performance : lowering the maxmal temperature and the temperature difference
在目前高熱通量電子產品冷卻器中，微通道熱沉已被證實是傳熱性能最佳且最具應用潛力的冷卻方式之一，而歧管式微通道熱沉因具有低熱阻、結構緊湊、所需冷卻液量小、沿流動方向溫度分佈均勻等優點則成為減小電子元器件換熱表面最高溫度、降低溫度變化的一種有效方法。Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging
文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging
針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。The experimental results indicate that when the air flow rate is determined, the key problem for energy saving is how to keep the indoor thermal comfort at a suitable level and reduce the difference between the internal and external temperature of the room. a formula is gained for calculating the critical values of air exchange rate. when ventilating rate is greater than the value, radiating heating is the better way for energy saving, or else, convection method in heating is more suitable
實測還指出，當通風量一定時，如何保證人體熱舒適度不變而減少室內外氣溫差將成為大通風量房間節約採暖能耗的關鍵，本文結合圍護結構傳熱機理，在對三種方式的能耗狀況進行理論分析的基礎上，提出了換氣次數的節能臨界值，若換氣次數高於此值，則輻射供暖是較好的選擇，否則，散熱器供暖是較好的方法。They are agricultural productive materials price growth rate, sown area of grain crops growth rate, grain yield per area growth rate -, natural disaster covered grain areas growth rate, net grain import change rate, grain reserve change rate, population growth rate, per income growth rate, city and town population growth rate, food industry production value growth rate, year - end pig number growth rate, medical & pharmaceutical and textile industry production value growth rate, grain marketization degree, inflation rate using the previous year as base year ( preceding year = 100 ), public grain purchases price growth rate, investment in agricultural science and technology growth rate, investment in agricultural infrastructure growth rate, growth rate of graduates number from agriculture, forestry, science & technology universities and colleges and specialized secondary schools, government expenditure for agriculture and agricultural credit growth rate, international grain price growth rate, rmb exchange rate growth rate, last grain price growth rate, economic crop price growth rate, meanwhile, a new method is attempted to be used in this paper and the grain price early - warning problem is transformed into machine learning problem by introducing statistic learning theory and svm method which are gaining popularity in machine learning field at present in the world
在此基礎上，篩選出23個警兆指標：農用生產資料價格增長率、糧食播種面積增長率、糧食單產增長率、糧食受災面積增長率、糧食凈進口量變化率、糧食儲備變動率、人口增長率、人均收入增長率、城鎮人口增長率、食品工業產值增長率、豬年末頭數增長率、醫藥紡織工業產值增長率、糧食市場化程度、以上年為基年的通貨膨脹率、國家糧食定購價格增長率、農業科技投入增長率、農業基礎設施投入增長率、農、林、科技高校大、中專畢業生人數增長率、財政支農資金比重及農業信貸增長率、國際糧食市場價格增長率、人民幣匯率增長率、上期糧食價格增長率、經濟作物價格增長率。同時論文在預警方法上作了新的嘗試，把糧食價格預警問題轉換成一個機器學習問題，引進當前國際上機器學習領域中比較熱門的統計學習理論和支持向量機方法，用順序回歸演算法對歷史數據進行學習建立了糧食價格預警模型。The thesis analyse the dynamic characteristic of heat - exchange equipment from the regulation channels and interference channels by the way of system simulation, and confirm the law of dynamic response of the second average temperaure when the first flow ( or temperature ) or the second flow change, and finish the design of heat power station ' s energy regulation system hereby it. at last, it simulate heat - exchang equipment and heat power station ' s energy regulation system by using matlab / simulink
本文用系統辨識的方法分別從調節通道、干擾通道對換熱器動態特性進行了分析，確定了當一次側流量（或溫度）或二次側流量變化時，換熱器二次側供回水平均溫度的動態響應規律，並據此建立了換熱器數學模型組成了熱力站能量控制系統。最後用maflab / simulink對換熱器和熱力站能量控制系統進行了動態模擬。This machine adopts high - level siemens plc concentration control, set up with computer controlled gear shifting vacuum gauge, and a three - flow controller, one set of contra - variant bias power and four - route contra - variant arc power supply, four side - installed heating tubes, computer pid automatic temperature control device, 60 and 100 two kinds versatile arc supply
該設備採用先進的西門子plc集中控制，裝有電腦自動換檔真空計和三路流量控制器，一套逆變偏壓和四路逆變弧電源，邊裝式加熱管四支，電腦pid自動控溫， 60和100兩種弧源通用。分享友人