熱防護系統 的英文怎麼說

中文拼音 [rèfánghùxìtǒng]
熱防護系統 英文
tps thermal protection system
  • 防 : Ⅰ動詞（防鷥） provide against; defend against; guard against Ⅱ名詞1 （防守; 防禦） defence 2 （堤...
  • 護 : 動詞1. （保護; 保衛） protect; guard; shield 2. （袒護;包庇） be partial to; shield from censure
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 統 : Ⅰ名詞1 （事物間連續的關系） interconnected system 2 （衣服等的筒狀部分） any tube shaped part of ...
  • 防護 : protect; shelter; shield; guard; shielding; protection; proofing
  • 系統 : 1. （按一定關系組成的同類事物） system 2. （有條理的;有系統的） systematic
  1. The investigation of a lot of parameters about treated sandstone, brick materials and earthen materials with fluorited polymers has been carried out, such as the formation of polymer, the penetration depth, porosity, capillary absorption and penetration coefficient, water uptake, compressive strength, drilling resistance, absorption isotherms of water vapor, water vapor diffusion, color changes as well as resistance to desegregation of water, frizzing - throwing cycles, worming - cooling cycles, and so on. in addition, the influence of salt crystallization, acid and base, and uv aging have also been assessed in order to better understand the protection effects and utilization possibility of two fluorinated polymers, mainly according to astm standard and the combination of international methods together with general technological

    分別以國家級文物保護單位的土質、砂巖和磚材文物樣品為對象，依據astm標準及國際通用文物保護研究方法與評估準則相結合，通過膠化物形成周期、滲透深度、孔隙度、毛細吸水和滲透系數、持水量、抗壓強度、抗鉆強度、吸附水蒸氣的能力、透氣性、外觀顏色等系列參數的測定，及凍融、冷熱循環、酸堿腐蝕后抗壓強度的衰減、可溶鹽對保護效果的影響、酸堿及光照對表面保護效果的影響，對兩種含氟聚合物及其與有機硅的共混物在文物加固保護和表面防護中的可行性和保護效果給予了系統研究。
  2. Sicp / al matrix composites, with 5, 15 and 25 % volume fraction of sic particles, were prepared by vacuum hot - pressing sintering processing in this paper. based on mechanics properties, sem observation and energy dispersive x - ray analysis, the interface reaction phenomenon of sicp / al composites made by vacuum hot - pressing sintering, as well as the reinforcement and fracture mechanisms of this composite were analyzed. the dynamic responses of sipc / al composites were studied by a split hopkinson high - speed pressure bar impact system which strain rate was from quasistatic state strain rate ( 3. 3 10 - 3s - 1 ) to dynamic state strain rate ( 5. 2 103 s - 1 )

    本研究以武裝直升飛機防護裝甲材料為研究對象，採用真空熱壓粉末冶金燒結工藝制備了含sic顆粒體積分數分別為5 、 15和25的sic顆粒增強鋁基復合材料，結合其力學性能、掃描電鏡和界面微區能譜分析結果，分析了sic _ p al復合材料的真空燒結過程中的界面現象，以及材料增強和斷裂機理，並利用hopkinson高速壓桿沖擊實驗系統對其從靜態到動態（應變率為3 . 3 10 ~ （ - 3 ） s ~ （ - 1 ） 5 . 2 10 ~ 3s ~ （ - 1 ） ）的壓縮破壞響應進行了研究，分析了不同體積分數sic _ p al復合材料高應變率壓縮載荷下，材料的變形和微觀損傷機理，以及利用高速沖擊空氣炮測定了改復合材料制備剃度復合板的穿透性能。
  3. Function of compensation lead cable which used for thermocouple is to prolong cold end of thermocouple, and composing system for measuring temperature by connecting with temperature meter. adopting high - quality import teflon insulation and sheath advanced technologic production chain, makes products owning good performance of resistance to high low temperature acidproof anticorrosive antiaging long - term using in oil, etc. normal working temperature is - 40 275

    熱電偶用補償導線電纜的作用是來延伸熱電偶的冷端，與測溫儀連接構成測溫系統，產品選用進口優質聚四氟乙烯絕緣和護套，並採用先進擠出設備新工藝流水生產線，具有耐高溫低溫，耐酸堿，防腐，耐老化等優異性能，可浸入油水中長期使用，正常工作溫度- 40 275 。
  4. The flow diagram of a lpg bottle paint - drying heating system using heat carrier as heat - medium, which has similar properties as other heat - carrier heating systems, has been improved, which has good effect in avoiding oil - spraying, shortening dehydration time and power - fail protecting etc. after making a series of analysis, calculational methods of expansion tank dimension have been deduced, which takes the moisture boiling - off of heat carrier into account and accords with real conditions

    對與其它熱載體加熱系統具有共性的鋼瓶熱載體加熱系統的流程圖進行了改進和完善，在防止噴油、縮短脫水時間和停電保護等方面取得了良好效果。通過分析，整理出了熱載體加熱系統膨脹器容積的計算方法，該方法考慮了熱載體所含水分汽化而帶來的影響，比原有的計算方法更加符合實際。
  5. The its group offers a comprehensive line of abrasion, bundling, thermal management, emi / rfi shielding and electrical solutions that are used on a variety of applications including wire harnesses, hoses and cable assemblies

    Its系統提供不同的產品系列，耐摩、捆紮、熱保護、 emi / rfi電磁兼容防護以及電氣絕緣保護，應用在不同的場合包括電纜、管子和電纜配件。
  6. With the development of reusable launch vehicles, the thermal protection system has been oriented by the idea of incorporate design which involves thermal protection - structure - thrust system. at the same time, the weight proportion of thermal protection system has been reduced, but the working temperature of thermal protection system has been increased

    隨著可重復使用航天器的發展，熱防護系統在向著防熱-結構-推進系統一體化設計的方向發展，與此同時，整個防熱系統在總起飛重量中所佔的重量比例也在降低，而使用溫度升高，即要求防熱結構日趨先進。
  7. Products and systems for the protection and repair of concrete structures - test methods - part 3 : determination of the adhesion of injection products, with or without thermal cycling - slant shear method

    混凝土結構防護和修理用產品和系統.試驗方法.第3部分:有或無熱循環的注塑產品粘結性的測定.斜剪切方法
  8. After that, begin to construct thermal insulation and protection layer. then repeat last step ( 4 ) to check electric heating system and switch on for 24hours

    試送電運行正常后，可進行保溫層和防護層的施工。施工完后，電伴熱系統重復本節第（ 4 ）條的檢查，並連續通電24小時。
  9. Leak - preventive coating ( with an electric monitoring system, testing the appropriate resistance ) for both standing and seated tanks containing : heating oil, gas oil, petrol, aircraft petrol, and other liquids hazardous to groundwater

    裝備有電力檢測系統、測試合適的防護能力的防泄露塗層，用於直立或平臥的容器（熱油、汽油、石油、航空煤油、和其他對地下水有害的液體。
  10. Products and systems for the protection and repair of concrete structures - test methods - determination of thermal compatibility - dry thermal cycling

    混凝土結構的防護和維修的產品和系統.試驗方法.熱符合性的測定.乾熱循環法
  11. Heat transfer analysis on thickness of fibrous insulations of metallic thermal protection system

    金屬熱防護系統纖維隔熱材料的傳熱分析
  12. Steady heat transfer analysis and parameter optimization for multilayer thermal insulations

    金屬熱防護系統多層隔熱材料的傳熱分析及參數優化
  13. Analysis of heat transfer and effective thermal conductivity of high temperature fibrous insulation for thermal protection system

    熱防護系統高溫纖維隔熱氈傳熱及有效熱導率分析
  14. In this dissertation : the advance of the attachment of the metallic tps is reviewed, including the history and development home and abroad and so on

    本文內容主要如下:對金屬熱防護系統連接結構的研究現狀進行了分析，包括金屬熱防護系統的發展歷史，國內外研究現狀等。
  15. As an important part of metallic tps, the attachment must be strong enough to transfer mechanical load to the substructure and at the same time not much heat quantity

    連接結構是金屬熱防護系統的重要的子部件，要求其在傳遞力學載荷同時，不能向機體傳遞過多的熱量，對其研究具有重要意義。
  16. As a kind of typical durable thermal protection system ( tps ), the metallic thermal protection system not only overcomes many disadvantages of the traditional ceramic tps, but also has many inherent advantages such as low cost of full life span, character of structure module, integration of mtps and the main structure of vehicle, all weather and easy to check, maintain and exchange. therefore, it is very important to investigate reusable mtps technology

    金屬熱防護系統作為一種典型的耐久性熱防護系統，不但克服了傳統陶瓷熱防護系統的諸多缺點，而且還具有許多獨特優點，如:全壽命成本低，結構模塊化，熱防護系統與機體結構一體化，全天候，易檢查、維護和更換等，所以先進可重復使用金屬熱防護系統的研究是十分必要的。
  17. Electric heating products have all - weather proof capacity. when installing, pay attention to easy maintenance, tidy and good looking and no rain and snow will be collected in future use

    電伴熱產品具有全天候防護能力。安裝時應考慮維護方便，整齊美觀，且不使系統積聚雨雪。
  18. Automatic control system includes the auto - temperature control, auto anti - freezing control, auto - defrost control, anti - overload protection, voltage - over range protection, diagnose, display systems. the cooling capacity varies with the changes of the environment temperature, flowing out temperature of the cooling water

    電腦系統應設置自動溫度控制、自動防凍控制、自動除霜控制，熱過載、缺相、壓縮機高低壓保護，故障監測、顯示和保護等相應的控制和保護措施。
  19. Products and systems for the protection and repair of concrete structures - test methods - determination of thermal compatibility - part 1 : freeze - thaw cycling with de - icing salt immersion

    混凝土結構的防護和維修用產品和系統.試驗方法.測定熱容性.第1部分:解凍.浸入防凍鹽融雪
  20. Products and systems for the protection and repair of concrete structures - test methods - determination of thermal compatibility - part 5 : resistance to temperature shock

    混凝土結構的防護和維修用產品和系統.試驗方法.測定熱容性.第5部分:耐溫度沖擊
分享友人
分享到 Line

分享到臉書