疲勞過度 的英文怎麼說

中文拼音 [píláoguòdù]
疲勞過度 英文
excessive fatigue; overfatigue
  • 疲 : 形容詞（疲乏; 勞累） tired; weary; exhausted
  • 勞 : Ⅰ動詞1 （勞動） work; labour 2 （煩勞） put sb to the trouble of; trouble sb with sth : 勞您費心...
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 疲勞 : 1. （疲乏勞累） tired; fatigued; weary; become fagged 2. （機能或反應能力減弱） fatigue; strain 3. [物理學] fatigue
  • 過度 : excessive; over; undue; ana-; hyper-
  1. According to medical advice, the two motormen fainted owing to illness rather than fatigue

    根據醫生的診斷，該兩名車長是因病暈倒，而並非由於疲勞過度。
  2. Based on the aircraft structure fatigue theory, the article discussed the theoretical basis of methods that are usually used for aircraft structure fatigue crack - forming life estimation, i. e. the stress severity factor approach ( normal stress approach ), the local stress & strain approach, detail fatigue rating approach ( dfr ). also the processes of life estimation of these approaches are studied in the article

    文章在簡要介紹飛機結構疲勞強度理論的基礎上，對目前飛機結構勞疲勞裂紋形成壽命估算常用的應力嚴重系數法（名義應力法） ，局部應力應變法，細節疲勞額定值dfr法的理論依據作了較詳細的論述，同時對這些估算方法進行壽命估算的過程與步驟也作了詳盡的闡述。
  3. By means of area method and stress field intensity approach and computational analysis of finite element, the fatigue strength of misaligned welded joint, " t " type of plate welded joint and cruciform joint are estimated. estimations are consistent with fatigue testes

    利用面積法和應力場強法，通過有限元計算分析，預測了錯位板接頭、 t型板接頭和十字型板接頭在對稱循環和非對稱循環時的疲勞強度，並與疲勞試驗進行了比較，理論預測與試驗基本一致。
  4. The fatigue alternating stress, which are highly variable in time, subject the crankshaft to very high and complex loading that induced to fatigue breakdown. the crankshaft design and manufacture must therefore precise calculations of the fatigue characteristics

    柴油機球鐵曲軸在工藝性和成本上佔有一定的優勢，通過滾壓強化工藝，疲勞強度有很大程度的提高，因而在國外得到廣泛應用。
  5. Based on the experimental data of rotor steel 1crmov in the loading of low - cycle fatigue at high temperature, the strength behavior and the fatigue life curve of this material at 550 have been achieved. meanwhile, with respect to three kinds of notched bar, their material damage assessment method under multiaxial stress condition is discussed

    本文在1crmov材料的高溫低周疲勞實驗數據進行了整理和統計的基礎上，得到了材料的疲勞強度特性曲線和疲勞壽命曲線，同時對三種不同缺口形式的圓柱形試件進行了多軸應力狀態下的材料損傷的研究，並通過數值計算方法進行了疲勞壽命評估。
  6. This paper analyses the engineering feasibility of using the static fem in the fatigue strength design of the shipunloaders structure through discussing the difference of infinite fatigue life design and finite fatigue life design and puts forward the calculating work cycle of this structure after considering the shipunloaders work process. it is useful for crane design - engineer to introduce the general fatigue strength design processes of the shipunloaders

    分析了有限壽命疲勞設計和無限疲勞壽命設計的異同，研究了用靜力學的有限元法進行結構的疲勞強度設計的技術可行性問題；並結合裝卸橋的工作過程，提出了相應的計算工作循環；介紹了裝卸橋疲勞設計的一般步驟
  7. Hurstwood made the best of a bad lot by keeping on his clothes and pushing away the dirty covering from his head, but at last he dozed in sheer weariness

    他和衣躺下來，推開臟蓋被，不讓它挨著頭。但是，他終于因疲勞過度而瞌睡了。
  8. The following morning, i received a letter from duval which informed me of his return and asked me to drop by, adding that, being worn out by fatigue, it was impossible for him to go out

    第二天早晨，我收到了迪瓦爾先生的一封信，他告訴我他已經回來了，請我到他家裡去，還說他因為疲勞過度不能外出。
  9. Mr. st. john came but once : he looked at me, and said my state of lethargy was the result of reaction from excessive and protracted fatigue. he pronounced it needless to send for a doctor : nature, he was sure, would manage best, left to herself

    約翰先生只來過一次，他瞧著我，說我昏睡不醒是長期疲勞過度的反應，認為不必去叫醫生，確信最好的辦法是順其自然。
  10. The intention of this paper is to develop a set of testing system, which has high efficient and reliable performance and advanced technology. it is applied in testing extrusion pressing of new type elevator wire rope tie - in in its making process and tensile strength, fatigue strength of tie - in. then to test the validity of design theory of the new type tie - in by analyzing the testing data and grope for new theory on and on

    本課題研究的目的是開發一套高效可靠、技術先進的測試系統，用於測試新型電梯鋼絲繩繩頭製作過程中的擠壓力、以及繩頭本身的抗拉強度和疲勞強度性能，然後根據測試數據來驗證新型繩頭設計理論的正確性，並不斷進行新理論的探索。
  11. Babies normally fuss for many reasons : overtiredness, overstimulation, loneliness, discomfort, etc

    寶寶通常哭鬧的原因很多：過度疲勞、過度刺激、感到孤獨、不舒服等等。
  12. Residual stresses not only result in unexpected machining distortion, but also increases the possibility of unpredicted fatigue failures and stress corrosion cracks ( scc )

    殘余應力的存在直接影響構件的疲勞強度、抗應力腐蝕性能及尺寸穩定性，並導致后續機械加工過程中產生變形。
  13. A lot of oil tanker failure was reported in recent years, which attracted much attention of navigation industry. after investigation and analysis, fatigue crack was suspected to be one of main causes. the fatigue cracks were discovered mostly on the side longitudinals at the connections to transverse bulkheads or transverse webs

    近年來，世界上有大量的油輪在海上失事，這一現象引起了各國航運界的高度重視，通過組織力量對油輪失事原因進行調查分析，認為一個重要的原因是艙內肋骨與上下翼艙的連接處的疲勞強度不足，導致艙室進水，然後波紋橫艙壁破壞導致進水過多而沉沒。
  14. These spectral changes are generally attributed to a progressive decrease in muscle fiber conduction velocity with the accumulation of h + in muscle in the development of muscle fatigue. however, there are a few other experimental studies revealed it was not all

    長期以來，人們傾向認為在肌肉疲勞過程中semg信號功率譜左移可能與h ~ +積累誘發肌纖維動作電位傳導速度下降有關，但有研究提示此結論並不可靠。
  15. Based on the study of strength degradation of material in the fatigue process, a strength degradation model is proposed. a stochastic differential equation, which controls strength degradation, is obtained from the model randomized by markov process. by using the theory of stochastic, the distributions of residual strength at any given lifetime and lifetime of any given residual strength are attained. under a few suitable hypotheses, inverse gaussian distribution of fatigue life is derived, and verified by means of experimental data. the result shows that the model and the method are reasonable

    在研究疲勞過程中材料強度退化規律的基礎上，建立了一個強度退化模型.對其進行隨機化處理，得到控制強度退化過程的隨機微分方程.在一定假設條件下，獲得了剩餘強度概率密度函數的封閉解，並推導出疲勞壽命的反高斯分佈形式.給出一種考慮損傷狀態對隨機漲落影響的近似處理方法.與試驗數據的比較結果表明，本文的模型和方法是合理的
  16. 3. the crane load and fatigue strength are regarded as stochastic process, the fatigue dynamic reliability based on limit stress model and fatigue dynamic reliability based on accumulation damage model are established on the base of statistic analysis the fatigue load and resistance

    3 、在對疲勞荷載與抗力統計分析的基礎上，視吊車荷載與疲勞強度為隨機過程，建立了基於極限應力模式的疲勞動態可靠性分析模型及基於累積損傷模型的疲勞動態可靠性分析模型。
  17. It is these particles that can change nitriding layer microstructure and that accelerates the layer formation. nitrogen is infiltrated through the surface of metals and it changes the chemical components. as a result, the surface of metal has good performance with high hardness, high resistant attrition, high fatigue strength, high resistant erode and resistant die burn

    這些高能粒子可以改變滲層組織，結構和促進化學反應過程，加速滲層形成，使氮元素滲入金屬表面，從而改變金屬表面的化學成分，使之具有高硬度、高耐磨性、高疲勞強度、高腐蝕能力及抗燒傷性。
  18. The effectiveness of predicting model is proved by means of comparison between predictions and experiments for a few types of welded steel structures

    通過對幾類典型焊接鋼結構疲勞強度的理論預測與疲勞試驗結果的比較，驗證了理論模型的正確性。
  19. The s - n curve, the mathematical relationship of bend fatigue strength or life to strengthening loads and strengthening cycles, the maximum increments of fatigue strength and life were obtained by experimental digital processing

    通過對試驗數據的處理，得到了兩種結構彎曲疲勞強度的s - n曲線、彎曲疲勞強度和疲勞壽命與強化載荷、強化次數之間的數學關系，以及經過低載強化后彎曲疲勞強度和疲勞壽命提高的最大幅度。
  20. The using rules about the fatigue strength in " design and calculation standard for submarine structure " is worked out according to the standard that the ultimate time of submergence is less than 500

    現行的「潛艇結構設計計算規則」中關于疲勞強度的設計，是按照極限下潛次數不超過500次的標準進行校核。
分享友人
分享到 Line

分享到臉書