直接液冷 的英文怎麼說

中文拼音 [zhíjiēlěng]
直接液冷 英文
direct liquid cooling
  • : Ⅰ形容詞1 (成直線的; 硬挺的) straight; stiff 2 (跟地面垂直的; 從上到下的; 從前到后的) erect; v...
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  • : 名詞(液體) liquid; fluid; juice
  • : Ⅰ形容詞1 (溫度低; 感覺溫度低) cold:冷水 coldwater; 你冷不冷? do you feel cold?; are you feeling...
  • 直接 : direct; immediate
  1. The paper mainly consider the followings : the performance parameter determination of cryopump, heat load determination and heat transfer of large cryopanel, reasonable distribution of heat load, the condition for construct steady flow in small vertical circle pipeline, balance condition for gas and liquid two - phase flow in the connection pipe between cryopanel and dewar, the safety of cryopump

    文中探討了低溫泵性能參數的確定;大抽速低溫抽氣面的熱負載的確定及合理分配;凝面上豎圓管內受熱建立穩定流動的條件;凝面與杜瓦間的連管道內氣「雙相流動」的平衡條件;低溫泵系統運行的安全問題。
  2. The i - phases directly nucleate and grow from melt of cooling mg - zn - y ternary alloys

    Mg - zn - y三元合金熔體在室溫卻過程中,準晶相相形核、長大。
  3. Iso - 4388 - 92 cigarettes. determination of the smoke condensate retention index of a filter. direct spectrometric method

    卷煙.過濾嘴的香煙存留指數的測定.光譜測定法
  4. From the viewpoint of safety technology of chemical reaction with heat release. the technical causes of getting out of control of these reactors are analyzed. hazardous effects of the leakage of chemical reactants both on human and environment, and the existing problems in current safety technological measures are also discussed. the cooling method of jet vaporization based on the jet principle and the direct cooling by non - vaporized liquid are introduced. the development trends of the safety technology for chemical reactors are analyzed

    從放熱化學反應的安全技術觀點出發,分析了放熱化學反應器失控的技術原因、化學反應物泄漏對人員和環境造成的危害、現有安全技術措施存在的問題;介紹了基於射流原理的噴射汽化和非汽化體的卻方法;還展望了化學反應器安全技術的發展方向。
  5. Abstract : from the viewpoint of safety technology of chemical reaction with heat release. the technical causes of getting out of control of these reactors are analyzed. hazardous effects of the leakage of chemical reactants both on human and environment, and the existing problems in current safety technological measures are also discussed. the cooling method of jet vaporization based on the jet principle and the direct cooling by non - vaporized liquid are introduced. the development trends of the safety technology for chemical reactors are analyzed

    文摘:從放熱化學反應的安全技術觀點出發,分析了放熱化學反應器失控的技術原因、化學反應物泄漏對人員和環境造成的危害、現有安全技術措施存在的問題;介紹了基於射流原理的噴射汽化和非汽化體的卻方法;還展望了化學反應器安全技術的發展方向。
  6. The project studied the direct contact condensation behavior of saturated steam on the subcooled liquid in passive gravity injection system. the experiment parameters were as follows : the initial pressure of prz ranged from 0. 2 0. 6mpa and the initial fluid temperature of core makeup tank ranged from 10 80. condensation phenomenon in cmt was observed

    本課題進行了非能動重力補水系統中飽和蒸汽在過面上凝的實驗研究,研究了在加裝遮流板時,系統壓力0 . 2 0 . 6mpa , cmt初始溫度為10 80條件下壓力容器cmt中飽和蒸汽在過面上凝的瞬態特性。
  7. The liquid waste is mixed and diluted with the effluent from the plant after treatment before discharging to the sea

    體廢物先經過處理,再與核電站內循環卻水混合及稀釋,然後排放出大海。
  8. In wax setting and casting process, gemstones are pre - set in the wax models and directly set by the poured metal liquid solidifying

    摘要首飾蠟鑲鑄造是將寶石預先鑲嵌在蠟模中,鑄造后金屬卻收縮而將寶石固定在鑲口中的工藝。
  9. Membrane distillation is an important branch of membrane separation technology which employees a hydrophobic microporous membrane for the separation process. during md process, feed contacts with one side of membrane, after water evaporates on hot side, vapor transfers to cold side under pressure drive, where vapor is condensed on cooling wall and then collected or removed

    膜蒸餾技術是膜分離技術中的一個重要分支,它是指利用一疏水性的多孔膜,膜熱側與待處理觸,待處理溶中的水在膜熱側汽化后,氣體在壓強差的推動下,通過膜孔傳遞到膜側,凝后收集或除去的一種分離技術。
  10. For the purpose of high temperature gradient, liquid metal cooling with circulatory water cooling is used directly to cool the sample, and at the same time, radiation baffle with appropriate size and shape is needed

    該裝置採用了雙區加熱和態合金卻技術,再配以合適的輻射擋板,可以提高固界面處的溫度梯度。
  11. Especially, in the filed of high tc superconductor, the technology that the cryocooler directly cool the superconducting system has changed the traditional cooling manner, which adopts the method of low tc fluid helium ' s convection and boiling to exchange the heat. it mainly depends on the cooling manner of conducting heat through the interfacial layer between the material of superconductor and non - superconductor ( such as cu, isolator, etc )

    特別是在高溫超導領域中,由於製卻技術改變了傳統的靠低溫氦對流、沸騰換熱的卻方式,主要依靠超導材料與非超導材料(如銅、電絕緣材料等)固體間的觸導熱卻方式,固體間界面熱阻成為影響導熱性能的關鍵因素之一。
分享友人