直流信號方式 的英文怎麼說

中文拼音 [zhíliúxìnháofāngshì]
直流信號方式 英文
direct current signaling
  • 直 : Ⅰ形容詞1 （成直線的; 硬挺的） straight; stiff 2 （跟地面垂直的; 從上到下的; 從前到后的） erect; v...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 號 : 號Ⅰ名1 （名稱） name 2 （別號; 字） assumed name; alternative name3 （商店） business house 4 （...
  • 方 : Ⅰ名詞1 （方形; 方體） square 2 [數學] （乘方） involution; power 3 （方向） direction 4 （方面） ...
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 直流 : direct current （dc）; constant current; steady current; continuous current; zero frequency curre...
  • 方式 : way; fashion; pattern
  1. This thesis firstly introduces new demands of aerial product logistics support under high - tech war and some defects of traditional logistics support, and puts forward a kind of system model of aerial product logistics support following data - sharing of cals, and emphasizes detm. secondly it sets forth application of step and xml in the ietm, researchs conversion of xml schema and relation schema, and simply researchs mapping of xml and express. afterword, a based - xml framework of info - transfer between different platform are presented, according to this framework, the author establish a archetypal system of helicopter information query system based xml and dbms

    本文首先介紹了現代高科技戰爭條件下對航空產品維修保障的新要求，概述了傳統的後勤保障技術的不足，遵循cals的數據共享的理念，提出了航空產品維修保障系統模型，重點研究了互動式電子技術手冊；接著分析了step標準和xml技術在製作互動式電子技術手冊中的應用，重點研究了肌模式和關系模式之間的相互轉換，初步研究了xml和express語言之間的映射關系；然後，提出了基於xml的一種解決航空產品信息跨平臺傳遞的解決方案，給出了該方案的具體實現流程和詳細的通訊協議，並開發了基於xul和數據庫的某型號直升飛機的信息查詢原型系統。
  2. Depend on the comprehensive analysis and study of the structure, principle, and exterior characteristic of the motor, through the methods of system modeling and digital simulation analysis, two kind of control device that work for the low voltage ( lvdc ) and the high voltage ( hvdc ) in avigation are researched respectively. point to the control technique of close - loop speed stabilization at a limited adjustment speed range, we bring out the close - loop speed control method that using the rotor position sensor indirectly measure the speed of the motor

    在全面分析了稀土永磁無刷直流電動機的結構特點、工作原理、運行方式以及外部特性的基礎上，通過系統建模和數字模擬分析，分別針對航空低壓直流（ lvdc ）和高壓直流（ hvdc ）兩種電動機構用永磁無刷電動機，在小范圍轉速連續調節下的閉環穩速控制技術進行了詳細理論研究，提出了利用轉子位置傳感器信號間接測量電機轉速進行電機轉速閉環穩速控制的策略。
  3. In allusion to the working characteristics and technical difficulties of 155mb / s burst mode receiver, we have put forward to the quick synchronization of inpouring phase locked loops ( pll ). for receiving burst signal, we introduce the scheme of dc coupling and dynamic threshold decision

    針對155mb s突發式收發模塊的工作特點和技術難點，我們提出了注入鎖相環法的快速同步技術；對于突發式信號的接收，我們採用了直流耦合和動態閾值判決的技術方案。
  4. In the synchronous " model, based on the idea of polygonal flux linkage locus, by means of constructing the switch state period table of three phrase voltage inverter is required. in the brushless model, the igbt ( isolated gate bipolar transistor ) switch state period table is gained by gal ( generic array logic ) which analyzes the signal of position feed - back

    在同步方式下，基於多邊形磁鏈軌跡法的思想，用作圖法求得三相電壓型逆變器的pwm波形序列；在無刷直流方式下，用gal對位置反饋信號進行邏輯綜合，得到開關管的導通規律。
  5. One is to use fourier transformation to convert the source signal from time domain to frequency domain and to discard high frequency harmonious components upwards of 19 ( gb / t14953 - 93 d5. 3 demanding ), then to have static huffman coding to the quantized char array which is composed of reserved direct current component and basic wave and each high frequency " s amplitudes and angles. the other is to use discrete wavelet transformation to convert the source signal from time domain to frequency domain and to set the high frequency coefficients that its absolute value is smaller than the given threshold to zero, then to have dynamic huffman coding to the quantized char array which is composed of multiple, wavelet ' s level, datum length, low frequency coefficients and reserved high frequency coefficients. mass simulinks and analyses under the two circumstances have done to show that data compression ratio is small and the relative error is also small and within the permission of engineering and the compression problem can be solved in theory of measured datum of power system

    第一種情況的壓縮方法為：採用傳統的傅立葉變換把原始信號從時間域變換到頻率域，舍棄20次及其以上的高次諧波成分（保證了gb / t14953 ? 93d5 . 3要求） ，然後對保留的直流分量、基波和各次諧波的幅值和相角數據量化后和量化時分別乘以的倍數系數構成一個數組，以字元形式保存，採用靜態huffman編碼對變換數據進行壓縮；採用離散小波變換把原始信號從時間域變換到頻率域，然後對分解得到的高頻系數進行閾值量化處理，對乘以的倍數系數、小波變換的階數、小波變換后的低頻、各級高頻以及原始數據長度、量化后的低頻系數以及保留的高頻系數大小、位置構成一個數組，以字元形式保存，採用動態huffman編碼對這個文件進行壓縮。
  6. The direct torque control theory is a kind of new control method after vector control theory in ac control field. it calculates and controls the torque and the flux of ac electromotor in stator coordinate using the voltage space vector. adopting the stator magnetism field direction method, it recurs to discrete pang - pang control producing pulse width modulation signal and controls the switch state of the transductor when better quality steady - state performance is produced

    直接轉矩控制技術是繼矢量控制技術之後交流調速領域中新興的控制技術，它採用空間矢量分析的方法，直接在定子坐標系下計算並控制交流電動機的轉矩和磁鏈，採用定子磁場定向，藉助于離散的兩點式控制產生脈寬信號，直接對逆變器的開關狀態進行最佳控制，以獲得轉矩的高動態性能。
  7. Tri - level sync eliminates the dc component and provides a more robust way to identify the coming of synchronization in the signal chain

    三電平同步方式消除了直流分量，提供了更有效的辦法來確定同步信號在信號鏈的位置。
  8. Hardware design, the main part of tlle system, stresses the signal regulating methods such as signal amplification, channel choice and am transformation as we1l as the measure of usual parameters such as ac & dc electric parameters, contact resistance, time, temperature and practical signal transform circuit, etc. furthermore, the anticipated functions have been proved by practical use

    其中硬體部分主要側重於信號調理即信號的放大、通道選擇、模數轉換以及各測試量包括直流電參數、交流電參數、接觸電阻、時間以及溫度的測試方法以及具體的信號變換電路，並以生產出實際產品的方式驗證了結果。
  9. In the design of real - time control system, the paper takes three - phase full - bridge mosfet inverter as the real - time control main circuit, and adopts a control scheme with 120 ? switching mode combined with half - bridge pulse width modulation ( pwm ), which would avoid straightthrough short of a certain bridge. phase current is detected by single current sensor ; three - phase position signals generated by position sensors could not only supply commutation information for inverter, but also be used for speed detecting based on signals " period measurement, which makes the speed sensor unnecessary. the whole control system adopts speed and current dual closed - loop control strategy in order to construct a high performance rare - earth permanent magnetic brushless dc motor ( repm bldcm ) full - digital real - time control system

    在實時控制系統的設計中，本文以三相全橋mosfet逆變電路作為實時控制主電路，採用120導通方式結合半橋pwm調制的控制方案，從而有效地避免了橋臂的直通短路；本文用單電流傳感器實現對相電流的檢測，來自位置傳感器的三相位置信號不僅為逆變電路提供換相信息，而且也用於基於信號周期測量的轉速檢測，這樣就省去了速度傳感器；系統採用的是速度、電流雙閉環控制策略，力求構建高性能的稀土永磁無刷直流電動機全數字實時控制系統。
分享友人
分享到 Line

分享到臉書