瞬時加熱 的英文怎麼說

中文拼音 [shùnshíjiā]
瞬時加熱 英文
instantaneous heating
  • : Ⅰ名詞(眼珠一動; 一眨眼) wink; twinkling Ⅱ動詞(眨眼) wink
  • : shí]Ⅰ名1 (比較長的一段時間)time; times; days:當時at that time; in those days; 古時 ancient tim...
  1. The results indicated that low graphite spheroidization rate and free cementite were the main causes of poor mechanical property

    試驗結果表明,控制碳當量和球化劑入量,採用孕育等可提高球化率;採用預砂型等可減少滲碳體。
  2. Floc point the lowest temperature at which vapors rising a sample will ignite momentarily on application of a flame under specified conditions

    在規定條件下,油品后所逸出的蒸氣與火焰接觸發生間閃火的最低溫度。
  3. Principal conclusions were drawn as the following : the non compatibility of pressure or velocity of the gas on both sides of the contact surface is the cause of the formation of shock wave ; the heating effect of reflective shock wave to driving gas during charging or exhausting process is the internal mechanism of peak oscillating effect, and all the factors that influence the formation and the running of the shock wave will influence the peak oscillating frequency, cooling effect

    主要結論如下:分離機內激波形成的原因是射氣間接觸面兩側壓力和速度不相容;峰值振蕩效應的內在機制為反射激波對充氣階段的驅動氣或低溫排氣的,凡是影響激波形成及運動的因素都將對峰值振蕩頻率、冷效應及效應產生影響;當充、排氣間比為0 . 1763,最佳射流激勵頻率出現在高階峰值振蕩頻率上。
  4. Floc point the lowest temperature at which vapors rising from a sample will ignite momentarily on application of a flame under specified conditions

    閃點在規定條什下,油品后所逸出的蒸氣與火焰接觸發生間閃火的最低溫度。
  5. Instantaneous water heater

  6. Gas water heaters - volume iii : storage, with input ratings above 75, 000 btu per hour, circulating and instantaneous water heaters ; addenda

    燃氣水器.第3卷:輸入額定值為75000英國量單位小以上的蓄循環和瞬時加熱水器.補充件
  7. Gas - fired instantaneous water heaters for the production of domestic hot water, fitted with atmospheric burners

    配備氣體燃燒爐供應家用水的燃氣式
  8. Household and similar electrical appliances - safety - part 2 - 35 : particular requirements for instantaneous water heaters

    家用和類似用途電器.安全.第2 - 35部分:器的特殊要求
  9. Csa 4. 3 gas water heaters, volume iii, storage water heaters with input ratings above 75, 000 btu per hour, circulating and instantaneous same as csa 4. 3

    燃氣式水器.卷iii .輸入額定值為每小75 , 000btu以上的存儲式循環與
  10. Transient temperature field comes from changes of boundary conditions and the heat which is produced by the concrete chemical reactions with the water during the mass concrete pouring

    由於混凝土澆灌產生的水化和澆築過程中邊界條件變化而產生態溫度場,這種溫度場對結構施變溫度載荷。
  11. In contrast with conventional thermo - ionic cathode, field emitter array ( fea ) cathode has many special advantages, such as room - temperature operation without a cathode heater, high current density, low power dissipation, excellent on / off isolation characteristics and instant turn - on characteristics

    與傳統的陰極相比,場發射陣列陰極具有許多獨特的優點,如無需,可以在室溫下工作;電流密度比陰極高幾個數量級,並可工作在低電壓調制下;功耗低;極好的開關特性;可啟動等。
  12. Mapping rheogram and analyzing thixotropy of fresh cement paste with different superplasticizers by measuring the rheologic parameters such as shearing stress 、 yield stress and plastic viscosity. using multi - channel isothermal calorimeter together with non - contacting electrical resistivity device, traditional hydration heat testingl and electrical resistivity testing were connected. using temperature - sensitive of traditional hydration heat model and structure - sensitive of structure formation model, instantaneous formation condition of paste structure was described exactly

    `採用多通道等溫量儀以及無電極電阻率測定儀,將傳統的水化測試與電阻率測試結合起來,運用水化敏感性與結構形成的結構敏感性,更真實地描述了水泥漿體初始結構的形成狀態;系統全面地研究了高效減水劑對水泥水化過程的調控作用;運用微觀測試方法,深入探討了高效減水劑對水泥水化過程的影響。
  13. 2. tow different types of power loading condition were applied on chips respectively. the transient thermal analysis was conducted to determine temperatures vary over time

    2 .以兩種不同功率載方式進行自然對流換條件下的封裝分析,得出封裝體溫度隨間的變化規律。
  14. For investigating thermal character changing of matter with shock compression, we need to measure the time character of radiating spectrum of matter with shock compression and its temperature, that is to measure transient time - resolved spectrum and its temperature

    為了研究沖擊載下物質特性的變化,需要測量沖擊壓縮態物質所發射脈沖輻射光譜及溫度的間特性,即進行態光譜的間分辨測量及溫度解析。
  15. The extruded az91d alloy was heated continuously and soaked at constant temperature. then it was quenched in the water and the instant texture at high temperature was acquired

    首先對經過擠壓形變的az91d鎂合金分別進行連續及等溫保溫,然後水淬快速激冷固定其高溫組織。
分享友人