瞬時原因 的英文怎麼說

中文拼音 [shùnshíyuányīn]
瞬時原因 英文
transient cause
  • 瞬 : Ⅰ名詞（眼珠一動; 一眨眼） wink; twinkling Ⅱ動詞（眨眼） wink
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 原 : Ⅰ形容詞1 （最初的; 原來的） primary; original; former 2 （沒有加工的） unprocessed; raw Ⅱ動詞（原...
  • 因 : Ⅰ動詞[書面語] （沿襲） follow; carry on Ⅱ介詞1 [書面語] （憑借; 根據） on the basis of; in accord...
  1. Fluid noise mainly comes from out put pulsation of rate of flow, the main reason of out put pulsation of rate of flow is the instant high pressure return flow that obturation cubage produced when the big round curve pressure transition. the v trough on the port plate can reduce the fluid noise. in this paper, the author based on the acting of dam a river and condensability of liquid and used matlab language as tool to calculate the v trough on the original port plate and drew out the p - t diagrammatic curve and analyzed its shortcoming and improved the design of original v trough and got that the best size of its angle was 12. 3 and its length was 5mm and the cross section was an equilateral triangle

    流體噪聲主要來源於輸出流量脈動，造成輸出流量脈動的主要原因是閉死容積在大圓弧段壓力切換時產生的瞬時高壓迴流，在配流盤上開設v型尖槽可降低因高壓迴流而引起的流體噪聲，本文以截流作用和液體的可壓縮性為理論依據，以matlab語言為工具，對原配流盤上的v型尖槽進行了理論計算，繪制出p - t圖線，分析了它的不足，並對原有v型尖槽進行了優化設計，得出了v型尖槽的最佳幾何尺寸：配流盤平面上的v型尖槽的兩邊的夾角為12 . 3 ，槽長5mm ，槽的橫截面為等邊三角形。
  2. The calculation results indicate that the outboard of drum walls fall in plastic yielding at the same time the rising cooling water reaches the height of that point and the yield region becomes narrower and narrower when it comes closer to the circumferential strake weldments, which explains the reason coke drums experience bulging and cracks occur in the weld seams portions of shell to shell after long in service

    計算結果表明：塔壁外側在冷卻水面到達的瞬間進入塑性屈服，筒節中部塑性屈服區較大，當靠近焊縫時塔壁的塑性變形區逐漸縮小直至消失，塔壁塑性屈服區的分佈特點解釋了塔體長期使用后發生鼓凸變形及簡體與焊縫連接處產生裂紋的原因。
  3. This method of diesel engine fault diagnosis is feasible theoretically. while the fault diagnosis system using this method is rare, just because the crankshaft instantaneous angular acceleration measurement is demanding, such as, good frequency response, high precision

    這種柴油機故障診斷的方法在理論上是可行的，但目前這種成型的系統不多，究其原因是測量曲軸的瞬時角加速度需要系統具有良好的頻率響應特性與高精度。
  4. Principal conclusions were drawn as the following : the non compatibility of pressure or velocity of the gas on both sides of the contact surface is the cause of the formation of shock wave ; the heating effect of reflective shock wave to driving gas during charging or exhausting process is the internal mechanism of peak oscillating effect, and all the factors that influence the formation and the running of the shock wave will influence the peak oscillating frequency, cooling effect

    主要結論如下：熱分離機內激波形成的原因是射氣瞬間接觸面兩側壓力和速度不相容；峰值振蕩效應的內在機制為反射激波對充氣階段的驅動氣或低溫排氣的加熱，凡是影響激波形成及運動的因素都將對峰值振蕩頻率、冷效應及熱效應產生影響；當充、排氣時間比為0 . 1763時，最佳射流激勵頻率出現在高階峰值振蕩頻率上。
  5. Flame tube in aircraft engine undergoes high temperature and high speed airflow washing. a hypothesis was suggested, which takes the transient heat transferring as the main reason to the cracking and damage on flame tube. finite element method was adopted to simulate the thermal fatigue and the hypothesis was reproduced

    發動機火焰筒的熱疲勞損傷是導致火焰筒失效的主要原因，本文提出了一種火焰筒熱疲勞損傷假設，認為火焰筒熱疲勞損傷不是由於發動機的運行和停車時冷熱溫度循環造成的，而是發動機啟動時瞬態溫度傳導過程中材料循環塑性變形的結果，利用該假設結合有限元計算模擬了火焰筒產生疲勞損傷的原因。
  6. First, the dynamic stability of braid composite cylindrical shells with the influences of some main factors is introduced. the general governing equations for the nonlinear dynamic stability is obtained. by the hamilton principle. the creep buckling analysis of braid composite cylindrical shells under axial compression and the dynamic stability under nonconservation force are discussed as emphases. in creep buckling question, by means of theoretical analysis, the instaneous critical load and durable critical load of viscoelastic braid composite cylindrical shell under axial compression are obtained and the numerical example is given

    首先介紹了編織復合材料圓柱殼在幾種主要因素影響下的動力穩定性問題，用hamilton原理建立非線性動力穩定性問題的一般性基本方程。然後重點討論了編織復合材料圓柱殼軸壓下的蠕變屈曲問題及非保守力作用下的屈曲問題。對蠕變屈曲問題，通過理論分析來得到了編織復合材料圓柱殼的瞬時彈性臨界載荷和持久臨界載荷，給出了具體的算例。
  7. Otherwise, we also have probed into the reasons for the pulsation of instantaneous powers in distorted systems

    另外，本文對于畸變系統中瞬時功率脈動的原因也做了一些探討。
  8. The hemodynamic change induced by embolization of the cerebral arteriovenous malformation was analyzed using the water hammer principle. the highest pressure that can be reached when the water hammer phenomenon occurs was calculated. the acute instantaneous pressure rising may be an important factor leading to intracranial hemorrhage or swelling when the avm is embolized. it is shown that long feeding artery of avm will increase the possibility of direct water hammer, and high wall shear stress of feeding artery will increase the water hammer pressure. this suggests that such kind of avms should be embolized stepwise and the systemic pressure should be rationally reduced before embolization

    以水擊原理分析了腦avm栓塞治療時血液動力學變化過程，計算了瞬時水擊壓力可能達到的最高值。瞬時增高的水擊壓力可能是avm栓塞時發生急性腦出血或腦腫脹的重要血液動力學因素。而avm供血動脈血管壁面切應力偏高和供血動脈過長可增加水擊的危險程度，提示對這類結構avm栓塞治療時應採取合理的降壓措施並盡可能分多次栓塞。
  9. It is showed that the torque ripple is not only connected with the phase currents, but also with the other factors, such as the instantaneous phase emf ' s in the case of commutation, the angle of commutation and the parameters of the windings

    從一個新的角度分析了繞組換相引起轉矩波動的原因，指出換相轉矩波動不僅與電機繞組電流有關，還與換相時相繞組感生電勢瞬時值、換相位置角、繞組參數等因素有關。
  10. In the experiment of testing instantaneous characteristics for circuit breaker, the transient current exists in the experimental circuit because of the closing making angle, which has serious influence on the testing precision

    斷路器進行瞬動特性試驗時，由於合閘相角的原因，試驗電路中會產生暫態電流，暫態電流的存在對試驗精度產生嚴重的影響。
  11. Nowadays, with the rapid development of cities and industries, human activities take on the characteristics of expansibility and instantaneousness, which produce much information data correspondently. the former information treatment methods in the field of soil, engineering ca n ' t meet the users " demand on exactness and alternation. so the visual evaluation of liquefaction information system becomes the urgent task in soil engineering

    當今，隨著城市化和工業化的加快，人類活動呈現出空間擴展性和時間瞬時性的特點，相應產生了大量的信息數據，原有的巖土工程信息處理方法已不能完全滿足用戶對信息的準確、直觀、迅速、可交互等多樣性需求，因此地震砂土液化的可視化評價信息系統是巖土工程界迫切需要解決的課題。
  12. The working principle of pulsed eddy current ( pec ) nondestructive testing technology is analyzed, the pec testing system was been established to examined the specimen of multi - layered aircraft structure, peak and zero - crossing time of the time domain transient response signal of pec are extracted as the features to detect the corrosion in the second layer of aircraft structure quantificationally, the experiment results are consistent with that of the theory analysis, as the pec have the advantages of fast speed and quantification, this makes the method have the broad using foreground in the testing of aircraft structure corrosion

    摘要對脈沖渦流無損檢測技術的工作原理進行了分析，建立了脈沖渦流的檢測系統對加工的模擬飛機多層結構的試件進行了測試，提取其時域瞬態感應信號的峰值和過零時間作為特徵量，對出現在飛機多層結構第二層中的腐蝕缺陷進行了定量檢測，試驗結果和理論分析相一致，證明了脈沖渦流檢測方法的有效性，由於其具有快速和定量化的優點因而在飛機結構的腐蝕檢測中具有廣闊的應用前景。
  13. It involves not only the detection of signal frequency, signal phase and power factor but also calculation and control of phase. the method of calculating phase is based on fast fourier transform algorithm ( fft ). it is used to calculate signal frequency, signal phase, power factor and the phase on / off time according to sampling instantaneous value of voltage and current

    本文主要提出了採用信號處理技術（快速傅里葉變換fft ） ，根據電壓、電流采樣的瞬時值，計算信號頻率、信號相位、功率因數、分合閘相角的選相控制方法，並介紹了最終控制分合閘的原理與實現方法
  14. Thirdly, a calculation formula of distortion settlement is established by considering soil structure damage and plastic drain board restraining displacement of soft foundation. starting with discussing the main factors affecting settlement of consolidated foundation, a reasonable method to modify the calculated settlement of soft foundation by layer - wise summation method is presented here. with calculable coefficients of volume deformation, lateral displacement and structure damage to modify the settlement will be closed to measurer settlement

    （ ）在土體損傷理論的基礎上建立了考慮結構損傷、排水板加筋作用的瞬時沉降計算公式，分析了影響土體沉降的主要因素，提出了對按單向分層總和法計算的固結沉降量進行體積應變、側向位移、土體結構損傷三項修正的方法，以上述三個修正系數取代原來單一的綜合經驗系數，使沉降計算值與實測值更接近。
分享友人
分享到 Line

分享到臉書