空氣動力軸 的英文怎麼說

中文拼音 [kōngqìdònglìzhóu]
空氣動力軸 英文
aerodynamic axis of an air foil
  • 空 : 空Ⅰ形容詞（不包含什麼; 裏面沒有東西或沒有內容; 不切實際的） empty; hollow; void Ⅱ名詞1 （天空） s...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 空氣 : 1 （大氣） air; atmosphere 2 （氣氛） atmosphere 3 （氣閘） air brake4 pneum ; pneumo ; pneumat ;...
  1. The aerodynamic forces on any control surface produce a moment about the hinge.

    在任何操縱面上的空氣動力均產生圍繞其鉸鏈軸的力矩。
  2. We can use the mm5 model in definite time, definite area weather forecasting. we conclude that : : the moving route of this necw in its developing progress was direct - south along latitude, the cold air is rough, and just this made the rough vertical velocity ; the necw southern moving and conflicting with the west pacification sub - tropical high makes rough jet steam. the plenty south - west warm and wet air made by the jet stream gave the rainstorm demanded vapor ;. the rough vertical velocity by jet stream is a main reason in this rainstorm ; the mm5 model uses four - direction analysis data as its input, this avoids some errors occurred in observe and transfer, thus made the result more useful

    綜合分析認為： （ 1 ） 、這次冷渦在其發生發展過程中，其移動路徑是沿經圈直線南壓，攜帶的冷空氣勢力較強，形成槽后較強的垂直運動； （ 2 ） 、西太平洋副熱帶高壓偏北位置與東北冷渦南壓形成的急流軸，把源源不斷的西南暖濕氣流輸送到遼西地區，也就是急流軸的左前方位置，為這次暴雨的產生提供了充足的水汽來源； （ 3 ） 、低空急流不但為暴雨輸送水汽，其造成的較強的垂直環流也是產生強降水的一個主要原因； （ 4 ） 、 mm5模式以四維同化資料作為初始場，最大限度地避免了觀測誤差可能造成的積分不穩定，提高了模擬結果的參考價值。
  3. A component level aerothermodymamic model of a turbofan aeroengine is created in this thesis using oo technology

    本文基於面向對象技術建立了某型雙軸渦扇航空發動機的部件級氣動熱力模型。
  4. Aerodynamic axis of an air foil

    空氣動力軸
  5. In order to investigate the unsteady flow frequency domain performances of an axial flow compressor at different mass flow, rotating speed and blade row spacing, plus inlet flow distortion, and considering aerodynamic characteristics and stability of the compressor, the low speed research compressor ( lsc ) at college of energy and power in nuaa is used to carry out the experiment studies. a large amount of test data has been gained through dynamic pressure transducers embedded in the stator blades at the tip, middle and hub section, then fast fourier transform algorithm ( fft ) is applied to calculate the frequency data

    為探討軸流壓氣機在工作流量、工作轉速及動?靜葉排軸向間距變化時的葉片排流場非定常頻譜特性變化規律，並耦合進氣畸變的影響，同時與壓氣機氣動性能和氣動穩定性相關聯，作者利用南京航空航天大學能源與動力學院的低速大尺寸軸流壓氣機（ lsc ）試驗器，採取在靜子葉片表面埋入動態壓力傳感器的實驗方法，對葉尖、葉中和葉根三個截面的動態壓力進行了測量，獲得了大量的可靠的實驗數據。
  6. Aerodynamics - concepts, quantities and symbols. part 2 axis systems and aircraft motion state quantities

    空氣動力學概念量和符號第2部分坐標軸系和飛行器運動狀態量
  7. Characteristics of structure : this machine adopts shaft type speed reducer drive which covers less space and can be conveniently repaired. upper supporting roller adopts clamping type fixu which can be conveniently installed. furthermore, it can well regulate deflection of conveying belt ; holdback is set for speed reducer with reliable performance to prevent back - slippign of the glusive belt ; dumper has three types : pneumatically actuated, electric and manual ; course of direction - change roller of the rail has three types : 300, 500 and 800

    2結構特點：該機採用軸裝式減速器驅動，佔用空間尺寸小，安裝維修方便上托輥採用夾緊式固定，安裝方便調整輸送帶跑偏能力強，減速器內設逆止器，防止膠帶倒滑的性能可靠卸料器有氣動電動和手動三種驅動型式尾部改向滾筒張緊行程有300 500 800三種，用戶可接輸送距離的1100選取。
  8. In addition, it is useful in some places that contain harmful air and air is needed is needed to input. on the other hand, based on the theory of aerodynamics, the optimum structural factors for contra - rotating axial local fan are studied

    根據軸流式通風機空氣動力學理論，在分析了普通軸流式通風機的結構對氣動力性能參數影響的基礎上，對對旋式軸流通風機的有關氣動力參數和結構參數進行了綜合優化分析研究。
  9. This paper presents the development and preliminary application works of an automatic strain gauge balance static calibration system in ecs for 1m hypersonic wind tunnel of cardc

    本文論述了cardc超高速空氣動力研究所1m高超聲速風洞配套的新型全自動六分量應變天平地軸系（ ecs ）校準系統的研製和初步應用研究工作。
  10. According to the study work of this paper, an automatic six - component strain gauge balance calibration system development scheme was put forwards : the system calibrates the balances in the ecs, and translates the loads to the bcs of the balances with measuring the balance ’ s position changes during the calibration

    本文根據1m高超聲速風洞氣動力試驗的總體要求，提出了採用天平校準載荷地軸系全自動加載、並通過天平空間位移測量將校準載荷換算到天平體軸系（ bcs ）的六分量天平校準系統總體研製方案，並確定了詳細的技術指標。
  11. Low grade fuels and / or polluted air can cause gum, varnish and carbon deposits to be formed in the carburetor during comustion which can result in rough idling, stalling and incrased gasoline consumption. 3 + 3 cleaner ' s superior formula will effectively remove gum, varnish and carbon deposits when sprayed directly into the carburetor, 3 + 3cleaner will clean carburetors, linkage, automatic chokes, pcv valves, heat risers, the spark plugs and the entiro system while lubricating and femoving moistuer on all moving parts, use 3 + 3 cleaner to restore efficiency, increase engine power maintain high gasmileage and have a smooth running engine

    空氣和汽油中的不純物質，在汽車使用過程中會產生污垢和炭積物，阻塞汽車的化油器（呼吸系統） ，使汽車無力及加油不暢順， 3 + 3牌化油器強力清洗劑獨有的特殊配方，直接噴入于化油器內，能迅速有效地清除洗化油器，火花塞及燃油系統的油漬污穢和炭積物，並對轉軸等旋轉部位提供潤滑及防銹保護，減少積炭的產生，使引擎起動順利及平穩運轉，增強馬力及節省燃油
  12. To study the aircraft - engine stability assessing technology about total - press distortion, four different structure insert - boards and testing schemes are designed, based on the technology of russian insert - board distortion and assessing compressor stability of english and usa. the low speed compressor ( lsc ) at college of energy and power in nuaa is used to carry out the all insert - board distortion experiments studies

    為了能夠更清楚地認識俄羅斯關于總壓畸變下的航空發動機穩定性評定的技術，本文在了解俄羅斯插板畸變試驗技術和英美等國家的穩定性評定技術的基礎上，設計了4塊不同結構形式的插板畸變擾流器裝置及試驗測量方案，利用南京航空航天大學能源與動力學院的低速大尺寸軸流壓氣機（ lsc ）試驗器，完成了各插板的畸變試驗。
  13. Motor vehicles need energy to accelerate ( overcome inertia ), to push the air out of their way ( aerodynamic drag ), and to overcome the friction from tires, wheels and axles ( rolling resistance )

    帶發動機的車輛需要能量進行加速（克服慣性阻力） ，推開路上的空氣（空氣動力學拖曳力） ，並克服輪胎、車輪和車軸的摩擦力（滾動阻力） 。
分享友人
分享到 Line

分享到臉書