空氣轉向器 的英文怎麼說

中文拼音 [kōngzhuǎnxiàng]
空氣轉向器 英文
air tumbler
  • : 空Ⅰ形容詞(不包含什麼; 裏面沒有東西或沒有內容; 不切實際的) empty; hollow; void Ⅱ名詞1 (天空) s...
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : 轉構詞成分。
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 空氣 : 1 (大氣) air; atmosphere 2 (氣氛) atmosphere 3 (氣閘) air brake4 pneum ; pneumo ; pneumat ;...
  • 轉向 : 轉向turn; turn round [around]; swing; sway; change direction; change one's political position
  1. Equipped with electronic controller fini tronic and preset for remote control for two or more compressors. it offers working pressure and oil mist separator tank inner pressure indication, separator filter clogging lashing alarm before overpressure e - stop, electric motor temperature control, maximum screw assembly temperature control, air temperature on pressure end indication, electric motor direction of rotation check, time to scheduled maintenance term, total operating hours and operating hours under load, alarm log of last five failure events

    並預設為丙臺以上壓機聯機遠程控制,有工作壓力和油分離罐內壓指示,分離過濾阻塞報警,電機溫控,螺桿總成溫控,壓力端溫度指示,電機檢查,維護周期油,油過濾過濾,分離過濾,總運行時間和負載運行時間,記錄上五個報警故障等。
  2. It offers working pressure and oil mist separator tank inner pressure indication, separator filter clogging flashing alarm before overpressure e - stop, electric motor temperature control, maximum screw assembly temperature control, air temperature on pressure and indication, electric motor direction of rotation check, time to scheduled maintenance term, total operating hours and operating hours under load, alarm log of last five failure events

    並預設為丙臺以上壓機聯機遠程控制可檢測包括操作壓力油分離罐內壓,電機溫度和,螺桿總成溫度過濾堵塞報警等參數,並可顯示總運行時間和負載運行時間。
  3. In order to investigate the unsteady flow frequency domain performances of an axial flow compressor at different mass flow, rotating speed and blade row spacing, plus inlet flow distortion, and considering aerodynamic characteristics and stability of the compressor, the low speed research compressor ( lsc ) at college of energy and power in nuaa is used to carry out the experiment studies. a large amount of test data has been gained through dynamic pressure transducers embedded in the stator blades at the tip, middle and hub section, then fast fourier transform algorithm ( fft ) is applied to calculate the frequency data

    為探討軸流壓機在工作流量、工作速及動?靜葉排軸間距變化時的葉片排流場非定常頻譜特性變化規律,並耦合進畸變的影響,同時與壓動性能和動穩定性相關聯,作者利用南京航航天大學能源與動力學院的低速大尺寸軸流壓機( lsc )試驗,採取在靜子葉片表面埋入動態壓力傳感的實驗方法,對葉尖、葉中和葉根三個截面的動態壓力進行了測量,獲得了大量的可靠的實驗數據。
  4. The design undertaken mainly from the following aspects : 1, mechanism ddesign : included the base and the joints : 2, trasmission mechanism design : adopted a synchronous toothelike transmission bell ; 3, balance system design : adopted springs and a brake and a lay air cylinder ; 4, design parameter and verify alculation ; 5, established motion equation by d - h method ; 6, simulated the motion locus by matlab software ; 7 ^ mapping out the part drawing or asesembly drawing

    本設計主要是從以下幾個方面入手: 1 、機構設計:包括底座和臂關節的設計; 2 、傳動機構設計:將驅動電機安裝在底座上,利用同步齒型帶、離合傳遞手臂的動力;利用齒輪傳動帶動底座回; 3 、平衡系統設計:採用了彈簧平衡系統、電磁式制動和單延時缸; 4 、設計參數和校核計算; 5 、用d ? h法建立運動學方程; 6 、利用matlab軟體對手臂的運動間進行模擬; 7 、利用autocad2000繪圖:包括零件圖和裝配圖。
  5. Air filtration portfolio, air filters, valve, oil mist machine, filter valve, oil mist separator, micro - mist separator, stability activated solenoid valve, pressure gauge, micro - valve and vacuum valves, links the release of the closure - pressure valves, and pipe connection, a one - way valve, t - shelves, shelves, brackets, diaphragm - type flow switches, blades type flow switches, further growth actuator, the valve lock, precision valve, pressure switches, mechanical pressure switches, pneumatic control ratio positioning devices, and electric - gas ratio positioning devices, and telecommunications - pressure converters, electro - pneumatic proportional valve, filter valve, shuttle valve, gas - electric relay and gas indicator, delay pneumatic valve and cylinder fcl, plumbing fcl, mufflers and exhaust cleaner, the excess flow valve with silencer, a one - way valve, rapid valve, rapid joints, rapid valve with fcl, rapid joint sub - cluster gas, micro joints, gas pipes, pipe from the devices, and helical coils, pipes, channels, scissors, multiple fastener, high - speed rotary joint, 10000 threaded joints, and insert the tube joints, rotary joints began, 68. 25 rapid joints and hoses, hose fittings and rapid non - electrostatic

    過濾組合過濾減壓閥油霧過濾減壓閥油霧分離微霧分離穩定啟動電磁閥壓力表微型減壓閥減壓閥三通釋放式截流閥壓力開關管接頭單閥t型隔板隔板托架膜片型流量開關漿葉型流量開關增速繼動鎖定閥精密減壓閥壓力開關機械式壓力開關控比例定位電-比例定位電訊號-電-比例閥過濾減壓閥梭動閥-電繼電源指示動延時閥缸限流管道限流消聲潔凈限流閥帶消聲止回閥快速排閥快速接頭快速排閥帶限流快速接頭集束分微型接頭喉管喉管脫離螺旋管排管管道剪刀多管扣件高速旋接頭萬用螺紋接頭插入式管接頭旋式緊鎖接頭難燃性快速接頭和軟管不帶靜電快速接頭和軟管
  6. The dried material is put into the middle of shell, mixing by the rake teeth and the material shaft works back and forth. the indirect heating, equal agitation of rake teeth and grinding of breaking stick makes water in material evaporation. under the effect of vacuum system, the water in the dried material and apparent water are discharged and the vapor water is discharged from outlet of vacuum pump passing dry dust collector, wet dust collector and condenser

    被乾燥物料從殼體上方正中間加入,在不斷正反動的耙的攪拌下,物料軸來回走動,與殼體內壁接觸的表面不斷更新,受到蒸汽的間接加熱,耙的均勻攪拌,粉碎棒的粉碎,使物料內的水份化,在真系統的作用下,使被乾燥物料內部水份和表面水份更有利的排出,化的水份經乾式除塵濕式除塵冷凝,從真泵出口處放
分享友人