等壓相當溫度 的英文怎麼說

中文拼音 [děngyāxiāngdāngwēndù]
等壓相當溫度 英文
isobaric equivalent temperature
  • 等 : Ⅰ量詞1 （等級） class; grade; rank 2 （種; 類） kind; sort; type Ⅱ形容詞（程度或數量上相同） equa...
  • 壓 : 壓構詞成分。
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 當 : 當Ⅰ形容詞（相稱） equal Ⅱ動詞1 （擔任; 充當） work as; serve as; be 2 （承當; 承受） bear; accept...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 相當 : 1 （兩方面差不多; 配得上或能夠相抵） match; balance; correspond to; be equivalent to; be equal to...
  • 溫度 : [物理學] temperature
  1. The quality of buffer layer and thin films was analyzed by afm, xrd, rheed and xps respectively. the effect of the experimental parameters such as carbonization time, working pressure, c source gas flow rate, carbonization temperature, different carbonization gas and substrate on the carbonization process was studied firstly. it was observed that the size of particles was increased with the increase of carbonization time and the rms was opposite, but the trend was reduced while the carbonization time was long enough ; the size of particles was increased with the increase of working pressure too, and choosing a proper working pressure could get a smooth surface ; the size of particles was unobviously changed while the gas flow rate was low, but it was notability increased with the increase of gas flow rate while the gas flow rate was high enough, and a smooth surface could be also obtained by choosing a proper gas flow rate ; with the increase of carbonization temperature, the size of particles was increased, the rms is decreased and a good single - crystalline carbonization layer could be obtained, but a rough surface was formed at a excessive high temperature ; the rms of

    對于碳化工藝，側重研究了碳化時間、反應室氣壓、 c源氣體的流量、碳化溫度以及不同種類的c源氣體、基片取向等因素對碳化層質量的影響，研究結果表明:隨著碳化時間的增長，碳化層的晶粒尺寸隨之變大，表面粗糙度隨之降低，但當碳化到一定時間之後，碳化反應減緩，碳化層的晶粒尺寸以及表面粗糙度的變化幅度變小;碳化層的晶粒尺寸隨反應室氣壓的升高而變大，適中的反應室氣壓可得到表面比較平整的碳化層;在c源氣體的流量相對較小時，碳化層的晶粒尺寸隨氣體流量的變化不明顯，但當氣體流量增大到一定程度時，碳化層的晶粒尺寸隨氣體流量的增大而明顯變大，同時，適中的氣體流量得到的碳化層表面粗糙度較低;碳化溫度較低時，碳化層的晶粒取向不明顯，隨著碳化溫度的升高，碳化層的晶粒尺寸明顯變大，且有微弱的單晶取向出現，但取向較差，同時，適中的碳化溫度可得到表面平整的碳化層;相比于c _ 2h _ 2 ，以ch _ 4作為c源氣體時得到的碳化層表面平整得多;比起si （ 100 ） ，選用si （ 111 ）作為基片生長的碳化層的晶粒取向一致性明顯更好。
  2. The optimized experimental conditions are determined and the densities of some elements in the mental alloy standard samples are measured. the experimental results shows that the spectral intensity of the plasma enhances significantly with the increase of the operating voltage and the power density. ( 1 ) to the steel ally sample, the emission intensities of the spectra reach to the maximum values when the laser operating voltage is 1600v and the argon pressure is 600 torr. under the same pressure, the spectral intensity of the plasma in the argon atmosphere is stronger than that in the air. when the argon pressure is 320 to rr, the signal - noise ration is about 5 times than that which the argon pressure is 700 torr, but the temperature of plasma is less about 1000k

    （ 1 ）對于光譜標鋼準樣品，當激光器工作電壓為1600v 、氬氣壓力為600乇時，譜線強度達到最大，並且在相同壓強下，氬氣中的等離子體與空氣中的等離子體相比，其輻射強度明顯增強；氬氣壓力為320乇時的譜線信背比約為600乇條件下的5倍，而等離子體溫度卻下降了近1000k ，即等離子體溫度隨環境氣壓的增大而增大；當激光束的焦斑在樣品表面上下移動時，激光誘導量、等離子體的激發溫度、譜線強度都呈不對稱性分佈，其最大值對應的焦斑位置都位於樣品表面之下0 . 4mm左右。
  3. In this paper, firstly, monolithic materials cosb3 and bi2te3 were prepared by sparkle plasma sintering ( sps ) respectively, and at the same time the microstructure of cosb3 and bi2te3 were studied by sem ; the seebeck coefficients and electrical conductivities of monolithic materials were measured by standard - four - probe method ( ulvac zem - 700 ) in a he atmosphere simultaneously, and their thermal conductivities were investigated by laser flash method ( tc - 7000 ) in vacuum. secondly, the junction temperature of graded bi2te3 / cosb3 thermoelectric materials was optimized based on the thermoelectric transport properties of monolithic materials, also when graded materials were used in the temperature difference ranging from 300k to 800k, the length ratio of monolithic materials cosb3 and bi2te3 were optimized in theory. thirdly, graded bi2te3 / cosb3 thermoelectric materials were prepared by two - step sps sintering, and the relationship between its average seebeck coefficients and temperature were calculated by theory mo del

    均質材料cosb _ 3和bi _ 2te _ 3的電導率和seebeck系數採用標準四端子法于he氣氛下在zem - 1上同時進行測量；熱導率採用激光微擾法（ tc - 7000 ）于真空狀態下進行測量；其次，在對均質材料cosb _ 3和bi _ 2te _ 3熱電傳輸特性研究的基礎上，對結構梯度bi _ 2te _ 3 cosb _ 3熱電材料的界面溫度進行了優化；為了使結構梯度bi _ 2te _ 3 cosb _ 3熱電材料在300k至800k的溫度范圍內具有最佳的熱電性能，本研究同時對梯度結構熱電材料當中均質材料cosb _ 3和bi _ 2te _ 3材料的長度進行了優化設計；第三，通過兩步放電等離子燒結的方法制備出了結構梯度bi _ 2te _ 3 cosb _ 3熱電材料；採用理論計算的方法研究了梯度結構熱電材料平均seebeck系數和溫度的關系；同時為了驗證設計的結果，本論文對結構梯度bi _ 2te _ 3 cosb _ 3熱電材料的開路輸出電壓和熱端溫度之間的關系及梯度材料在300k至800k的溫度范圍內使用時的功率輸出進行了相應的研究。
  4. For further researching the influence on the phase transition curve by these parameters, we first present discussions on the " cigar type " phase diagram by the normalized pressure or the ratio of the mixed energies. we fixed the other parameters and changed the normalized pressure or the ratio of the mixed energies only. the results show that the lattice structure, the phase transition normalized temperature and the coexistence area of the phase diagram changed with the variety of the given parameters in certain regularity

    參戮對相圖的店響約化壓強和勢參數對相圖來說都是很重要的參數，為了更深人的研究約化壓強屍和勢參數對相圖的影響，我們首先討論了在其他參數都不變的情況下，約化壓強p對「雪茄型」相圖的影響，即研究當約化壓強屍增大或減小時，系統的結構、相變溫度、相圖的共存區域等的變化規律；接著，我們又討論了在其他勢參數和約化壓強都不變的情況下，改變混合能比（ 。
  5. Pressure readings measured at different weather stations after making corrections according to temperature etc. at the same time are plotted on a weather chart. meteorologists then draw lines to show places with the same pressure. these lines are called isobars

    氣象人員把各地氣象站同一時間所量度到之氣壓值根據溫度等作出適當的修正後填上天氣圖上，然後將氣壓數值相同的地點用線連接起來，便成為等壓線。
  6. Pressure readings measured at different weather stations ( after making corrections according to temperature etc. ) at the same time are plotted on a weather chart. meteorologists then draw lines to show places with the same pressure. these lines are called isobars

    氣象人員把各地氣象站同一時間所量度到之氣壓值（根據溫度等作出適當的修正後）填上天氣圖上，然後將氣壓數值相同的地點用線連接起來，便成為等壓線。
  7. The architecture is simple, with high respond speed, high stability and adopts very advanced charging termination methods such as - v, max voltage, max temptature and temptature change rate so its reliability and safety are very high

    該電路結構簡單，響應速度快，有很高的穩定性，採用了非常完善的充電中止方法，如- v終止，最高電壓，最高溫度和溫度變化率等，使得該電路具有相當高的可靠性和安全性。
分享友人
分享到 Line

分享到臉書