管線壓力 的英文怎麼說

中文拼音 [guǎnxiànyālì]
管線壓力 英文
pipeline pressure
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 管線 : line pipe; lead-out管線安裝 pipelining; 管線泵 in-line pump; 管線測量 pipeline survey; 管線敷設 pipelining
  1. At first, in the process of experiments, it were measured that dry plate pressures drop and point pressures in the flow fields around the single fixed - valve and double fixed - valves under different velocities by using of pitot tube. after that point pressure was transformed to point velocity, two dimensions flow plane of flow fields around fixed - valve were plotted to observe the difference between of the fixed - valve tray with fold edges and the common rectangular fixed - valve tray on the distributions of flow fields and pressures, to provide comparisons and refer - rence for cfd simulation

    在實驗中，利用測速管等儀器對在不同速度下的單閥和雙閥固定閥周圍的流場進行了點壓力測量，然後把點壓力轉化為點速度后繪出固定閥周圍流場的二維流線圖，同時測定了塔板的干板壓降，來考察新型固定閥帶折邊后對流場分佈和壓降的影響，為隨后的數值模擬提供對比和依據。
  2. Before intervening in any circuit which has a gas filled pressure vessel, the pressure must be discharged from the circuit

    當管道與充有壓力氣體的容器連接時，如果需要對任何管線進行操作，必須先將管線中的殘余壓力進行釋放。
  3. And results are : ( 1 ) analyze the force and distortion on pipeline under collapse and gulch in theory. on the base of beam deformation, analyze the bending moment and deformation of pipeline with frusta and without frusta. calculate a true problem, contrast the differences between pipeline with frusta and one without frusta, draw some conclusions

    得到的主要結果為： （ 1 ）基於彈性地基理論和彈性梁的撓曲線理論，給出了管道在固定墩（相當跨越河溝情況）和無固定墩（相當坍塌和沖溝情況）的變形微分方程，並分析了當量軸力為拉力或壓力時管道的變形和受力情況。
  4. Controlled closing of the valve, opens the mainline check valve, gradually increasing line pressure

    閥門受到控制的關閉操作，開啟主管線止回閥，逐漸增加管線壓力。
  5. Deriving capillary presure curves from nmr t2 spectra

    2譜法估算毛管壓力曲線綜述
  6. The pressure at every point along the pipeline, the gas - liquid phase flow rate and the law of the liquid holdup in the pipeline chang ing with time in the process of gas storage and supply at the time of peak shaving are simulatively calculated, and based on this, the problem on peak shaving is thoroughly analyzed by combining with the existing pinghu - shanghai gas pipeline in china

    模擬計算了調峰過程中管道儲氣和供氣過程沿線各點的壓力、氣液相流速和管內持液率隨時間的變化規律，據此結合我國已建成現有的平湖一上海的天然氣管線，對調峰問題作了深入地分析。
  7. In this paper, thermal evolution history of organic matter of the source rocks and hydrocarbon generation history have been researched by tti method, hydrocarbon migration direction and migration times were probed combining with the area structure development feature ; distribution pattern of the main reservoir intervals on lateral and longitudinal have been predicted by researching on development feature and control factors of the reservoir intervals, the actions of reservoir conditions in hydrocarbon accumulation and bearing also were probed combining with pore evolution feature ; the micro - pore feature of regional cap and direct seal in carboniferous - lower triassic in this area have been determined with micro - capillary pressure curve and intrusive mercury curve ; the prospecting districts have been pointed out combining with the hydro - geologic feature, the potential reservoirs were classified according to trap types in this area, the author attempt to evaluate on the hydrocarbon - bearing condition in the str ata of carboniferous ~ lower triassic from hydrocarbon generation and migration reservoir condition, reserved condition etc, and predict the reservoir types and hydrocarbon - bearing patterns combining with the structure evolution. based on above, the author point out that the central block of chenghu - tuditang synclinorium and the southern block of dangyang synclinorium are the advantageous regions for exploration

    本文用tti方法研究了烴源巖有機質的熱演化史和油氣生成史，並結合區內構造發育特徵，探討油氣在區域上的運移方向和在時間上的運移期次；通過對儲集層段的發育特徵和控制因素的研究，預測了本區主要的儲集層段在橫向上和縱向上的分佈規律，並結合孔隙演化特徵，探討儲集條件在油氣聚集成藏中的作用；利用微毛細管壓力曲線法和壓汞法，對石炭系?下三疊統的區域蓋層和直接蓋層的微孔隙特徵進行了定量評價，並結合水文地質分佈特徵，指出有利於油氣保存的地區；根據區內存在的各種圈閉類型，對可能存在的油氣藏進行了分類，並試圖從油氣的生成與運移、儲集條件、保存條件等方面，動態地綜合評價石炭系?下三疊統油氣成藏條件，並結合構造演化特徵，預測其油氣藏類型和成藏模式。
  8. A nonlinear mathematical model is developed to determine the flow rate distribution in the parallel tubes of boiler superheater and reheater by depending on the relation of pressure drop among individual tubes and accounting for the static pressure variations in the inlet and outlet headers

    根據並聯管組各根管子進、出口壓力降之間的關系，並考慮到分配集箱與匯集集箱中流體的靜壓變化，建立了鍋爐過熱器、再熱器流量分配的非線性數學模型。
  9. Attach the riser tensioners, choke and kill lines to the slip

    將隔水管張力器，壓井及放噴管線連到伸縮節上。
  10. Hotline counselling service on stress management

    壓力管理諮詢熱線
  11. Aiming at the study actuality of fan performance monitoring system and analysis of fan performance curve changes affected by inlet - box and the different fixed - angles of guide blades in the course of installation, a fan flow monitoring model based on rbfnn in whole flow zone was established in this thesis. in the model, the method of no throttle and fan performance curve were used as basis. and on the basis of that model, fan performance curves of 4 - 73no. 8d were approached with experimental data of different speed, different opening - angles of guide blade and different resistance of pipeline, the precision and the error law of model were studied

    本文針對電站風機性能監測系統研究較少的現狀，在實驗的基礎上分析了現場加裝進氣箱和由於安裝造成的導流器葉片開度不一致對風機性能曲線的影響，並在此基礎上採用無節流方法測量流量，以風機調節性能曲線為依據，建立了基於徑向基函數（ rbf ）神經網路的風機流量全程監測模型；以實驗室4 - 73no . 8d離心風機為研究對象，探討了rbf神經網路差壓模型在變轉速、變導流器開度和變管網阻力等工況下的應用精度和誤差分佈規律；最後用visualc + +語言開發了風機性能在線監測系統。
  12. Avoiding the difficulties of detecting the difficult parameters in furnace control and of building up the models, integrated with fuzzy control and conventional pid control, abb ’ s control it system is used to predict the bloom surface and center temperature directly based on the temperature of furnace wall easily to be detected so that the temperature settings in various furnace sections can be self - corrected, the furnace temperature of each section self - adjusted and on - line parameters of combustion control self - optimized. in addition, the heating parameters and the operating status of the field plant can be monitored with alarm

    採用abb公司的controlit控制系統，避開爐子控制中遇到的困難參數檢測及建模困難等因素，直接根據容易檢測的爐壁溫度來推知鋼坯表面溫度及鋼坯中心溫度，將模糊控制技術與常規pid控制相結合，實現各段溫爐設定值自修正、各段爐溫自協調、各參數在線自整定的自尋優最佳燃燒控制;對熱工參數、現場設備的運行情況進行監視、報警，實現爐膛壓力、管道壓力、換熱器的保護控制，並將重要參數送往廠級mis網路。
  13. This dissertation describes the studying of the whole construction of water - saving irrigation expert control system, the realization of hardware and software and low - cost soil - moisture sensor which is needed for water - saving irrigation. the distributed control system based on bus. according to real - time data of soil - moisture, water - level of sump, pressure of tube, etc. and irrigation knowledge in expert knowledge bases, it can make decisions such as when to irrigation, the water quantity to irrigation and the cost and benefit of the irrigation

    本文對節水灌溉專家控制系統的總體結構、軟硬體實現以及節水灌溉急需的低成本土壤水分傳感器進行了研究，系統採用了基於總線的分散式控制結構，根據實時檢測的土壤水分、水槽水位、管道壓力等實時參數，知識庫的作物灌溉知識，分析決策灌水時間、灌水量、灌溉成本及灌溉效益。
  14. Finally, the paper expatiates the realization process of this design, including the rotation equipment management, the static equipment management, examines and service project management, the electrical management, the meter computer management, the water quality management, the lubricating oil management, the static seal management, the craft pipeline management, the bearing management, the pressure vessel

    最後，文章對系統的設計實現過程進行了闡述，分別對大慶石化總廠設備管理系統的轉動設備管理、靜設備管理、檢維修計劃管理、電氣管理、儀表計算機管理、水質管理、潤滑油管理、靜密封點管理、工藝管線管理、軸承管理、壓力容器管理、安全閥管理進行重點描述。
  15. Reduce hydraulic control manifold pressure to 5200 kpa

    將液壓控制管線壓力減少到5200千帕
  16. The valve reopens during shut - down cycle to gradually decrease line pressure and prevent shock

    在關閉周期內，閥門將重新開啟，以逐漸降低管線壓力，防止出現沖擊現象。
  17. In addition, the center - reflecting wavelength shift of the fbg varies in good linearity with the applied pressure

    98x106mps 」 l ）的引41 ff ； fbg的中心反射波長位移量與施加給直彈簧管的壓力之間具有良好的線性關系。
  18. When making adjustment in the reduced pressure, always bleed the line to allow the line pressure to adjust to the regular setting

    在減少的壓力上進行調節時，要始終對管道進行排放，使得管線壓力調節到常規的設置點。
  19. This thesis focused on the pressure control problem of apron - hydrant - system in modern airport. implied with expert theory, intelligent pid was used to solve pressure control problem, and statistics method was innovatively used in parameter optimizing process. with the practice in realization, the expert pid control policy and parameter optimizing method introduced in this thesis turned out successful

    論文介紹了機坪自動供油系統中的管線壓力控制問題，針對供油管線中的時滯、干擾問題提出了應用專家思想的智能pid控制策略，在控制參數的尋優過程中創新性地應用數理統計的方法來權衡各組參數控制指標的優劣，通過模擬與實施證明了控制策略和參數整定方法的優越性。
  20. Installing isolation valves will allow you to perform maintenance service without draining the system or exposing service personnel to line pressures

    安裝隔離閥使得用戶不需要進行系統排放或使維修人員承受管線壓力的威脅就能夠進行維護維修。
分享友人
分享到 Line

分享到臉書