粘結能力 的英文怎麼說

中文拼音 [niánjiēnénglì]
粘結能力 英文
caking capacity
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 能 : 能名詞（姓氏） a surname
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 能力 : ability; capacity; capability
  1. The research overcomes the shortcomings of primers in common use, and breaks through the traditional astriction of absence of chemical bond between new and old concrete. both macrostructure and microstructure as well as bond mechanism was discussed and some further research advice was put forward

    本研究克服了以往的界面劑僅能改善界面層宏觀或微細觀結構的缺點，突破了新老混凝土粘結層主要依靠范德華力提供界面粘結力而幾乎不存在化學鍵作用的缺點。
  2. The coalescence & separation filter core, targeting at low viscosity oils, is highly efficient to dewater according to the difference of different material ' s surface tension

    針對低粘度油液的特殊配比的聚結分離濾芯，根據介質表面張力的不同進行細化分離，脫水效率高，脫水能力強。
  3. Following is the factors ideating with the surface of old concrete in different way ( including brushing surface, chiseling surface, cleaving surface ), adherence agent ( including cement slurry, cement sand slurry, cement slurry with the u expansion agent ), the freeze - thaw circulation times and air - entraining. as a result, we found that the roughness influence on the adhesion capability of the new on old concrete to a large degree. the larger rougeness is, the larger the splitting tensile strength on the adhension face is. the kind of adhesion agent is also influence on the adherence capability of new on old concrete. the circulation times of freez - thaw have a large influence on the splitting tensile strength of adherence face of new on old concrete. the analysis of tests give some advices to the practical engineering

    主要考察了老混凝土表面不同處理方式（刷毛面，鑿毛面，劈裂面） 、界面粘結劑類型（水泥凈漿，水泥砂漿， u型膨脹劑水泥漿） 、凍融循環次數等對新老混凝土粘結面劈拉強度的影響，以及凍融作用下新混凝土加氣對粘結面劈拉強度的影響。試驗結果表明，粗糙度對新老混凝土粘結性能有重要影響，隨著粘結面粗糙度的增大，粘結面劈拉強度不斷增加；界面粘結劑類型對新老混凝土粘結性能有一定影響，在凍融作用下， u型膨脹劑水泥漿粘結效果不如水泥凈漿和水泥砂漿；凍融循環對粘結面劈拉強度有較大影響，加氣能明顯改善新老混凝土粘結面的抗凍能力。
  4. Hyaluronic acid, as acid mucopolysaccharide, fulfils important tasks in the connective tissue ; it plays an essential role in the regulation of water binding capacity, supports the regulation of the distribution of plasma proteins and promotes wound healing

    透明質酸，作為一種粘多糖酸，在結締組織中有著非常重要的作用，它是調節組織水合能力的關鍵，同時改善血漿蛋白的運輸和促進傷口愈合。
  5. The effect of reynolds number on rudder hydrodynamic performance is also analyzed. up to the stall angle the computed lift and drag agree well with measurements and other author ' s calculations, whereas stall angle, lift and drag beyond the stall angle are slightly under - predicted. the solver is used to investigate laminar and turbulent separated flows around a 6 : 1 prolate spheroid at high incidence angles and their effects on hydrodynamic forces

    應用所開發的求解器，以naca0015翼型舵為算例計算了船舵在不同雷諾武漢理三;大學博士學位論文數下大舵角范圍內的三維粘性流場及水動力，成功地預報了舵的失速角和最大升力，並初步探討了雷諾數對舵水動力的影響;計算結果與現有試驗和計算數據比較，吻合程度相當好，初步檢驗和驗證了該求解器精確模擬粘性流動和計算水動力的能力。
  6. The results showed that compared with the colocasia esculenta schott starch, the starch phosphate ester had properties of easier gelatinization, higher clarity, better retrogradation, freeze - thaw stability and anti - mycotic characteristics improved, and paste viscosity decreased

    結果表明，與原澱粉相比，香芋澱粉磷酸酯更容易糊化、透明度高、沉降穩定性好、凍融穩定性和抗黴菌能力有所改善、糊粘度減小。
  7. Theoretical analysis and testing results demonstrated that viton, a new substitute of the former plasticizer, could noticeably improve its performances, which has been proved as the important improvements of the mixture. due to the favorable thermochemistry performance, dicyandiamide can act as a good combustion - rate regulator. the addition of antistatic agent can desirably increase the antistatic capability of the mixture, and the testing results showed that the performance of the improved mixture was excellent

    理論分析和測試結果均表明了以氟橡膠取代耐水點火藥中原粘合劑將使藥劑的各項性能有明顯的改善，是耐水點火藥改進的重要方面；雙氰胺具有良好的熱化學特性，作為耐水點火藥改進中的燃燒速度調節劑具有很好的調速效果；抗靜電劑的加入，進一步提高了藥劑的抗靜電能力，測試分析表明改進后藥劑的性能更加優異。
  8. At first, the bonded magnet has been produced at varied technological conditions. then the influences of varied technological conditions, such as species and quantity of coupling agent, species and quantity of agglomerant, process of compression moulding and solidification process on magnetic property and compression strength of bonded magnet have been analysis by means of apparatus for measuring magnetic property and compression strength

    首先，在不同工藝條件下制備出粘結磁體，然後利用磁性能測試儀、力學性能測試設備等測試手段，分析了偶聯劑的類型及其用量、粘結劑的類型及其用量、模壓工藝和固化工藝等因素對鐵氧體粘結磁體磁性能及力學性能的影響。
  9. Abstract : basic stuff of sinter flyash ceramisite is flyash and clay as agglomerant. the si nter flyash ceramisite is of dense in structure, low porosity which can improve t he mechanical properties of the material. it has properties such as high strong a nd low absorption of water and better stability. it is a new type ofbuliding mate rial

    文摘:燒結型粉煤灰陶粒的主要原料是粉煤灰和作為粘結劑的粘土，文中所述燒結粉煤灰陶粒結構緻密，孔隙率低，能較好地改善了材料的力學性能，具有高強、吸水率低、穩定性好等特點，是一種新型建築材料
  10. The adhesive specimens shows some degree of deterioration in appearance and mechanical characteristics after artificial aging test

    粘結劑試件在人工加速老化曝露試驗后，其外觀顏色和力學性能均發生一定的變化。
  11. Columns under axial compression and biaxial bending. in the beginning of the paper, it summarized the history and the actuality of the nonlinear analysis of special - shaped columns and the capability of the sliding of reinforcement anchoring. on the basis of related papers, the full path of stress - strain relation of concrete and the sliding of longitudinal reinforcement anchoring are all considered

    本論文主要內容是對鋼筋混凝土異形截面雙向壓彎柱（包括l形、 t形、十字形柱）進行非線形全過程分析，首先綜述了異形柱構件非線性分析以及粘結滑移性能研究的歷史與現狀，在有關文獻基礎上考慮了受拉縱筋和周圍混凝土的粘結滑移和混凝土應力?應變關系曲線的下降段。
  12. So, the bond stress and slip of src eccentric loading columns must be accurately measured and studied further

    因此有必要通過準確量測構件內部的粘結應力和滑移，進一步對偏壓柱的粘結滑移性能進行研究。
  13. Through direct pullout test, we examine the effect of the water to cement ratio, contend of steel fiber and silica fume on the bond behavior ; compare the bond behavior of two types of cfrp bars with difference surface treatment ( r1 bars and g1 bars ), and reprocess the one of inferior bond strength ; investigate the bond stress distribution along the bond length of cfrp bars, and assess the adequacy of some exist analytical models of bond - slip behavior to reproduce the experimental bond behavior

    本文主要通過直接拉拔試驗，考察水膠比、鋼纖維摻量、硅灰摻量以及cfrp筋的表面處理類型等材料參數對粘結性能的影響，並對粘結效果較差的cfrp筋研究了表面處理方法，以提高cfrp筋與rpc的粘結性能;通過在cfrp筋表面粘貼應變片，測定了粘結應力沿cfrp筋埋長的分佈情況，並對現有的粘結滑移本構模型與試驗結果的擬合效果進行了比較。
  14. Conclusions : the study suggests that the proliferation and adhesion of trophoblast in placenta of patients with early abortion was declined

    結論：研究提示早期自然流產患者胎盤中滋養細胞增殖、粘附能力下降。
  15. The results showed that the capacities of four types of bacteria for adhesion to dacron, pyrolytic carbon and ptfe coincided with the bacterial - growth curve

    結果四種細菌對三種材料粘附能力與細菌生長曲線基本一致。
  16. The results indicate that the capacities of different types of bacteria for adhesion to the same prosthetic valve material are different, and the capacities of one type of bacteria for adhesion to different materials are also different

    結論：不同細菌對同一種人工心瓣材料或同一種細菌對不同的人工心瓣材料有不同粘附能力。
  17. We also found that p1206 " 1 can be easily phosphorylated at tyrosine by epidermal growth factor ( egf ). tyrosine phosphorylation of p ! 20ctn strengthened bel - 7404 cells malignant behavior, and p120ctn translocated into nucleus

    我們還發現，芒果貳有降低pi20ctn磷酸化的作用，其結果是bel一7404細胞粘附能力有所增強，遷移能力降低。
  18. Standard practice for effect of moisture and temperature on adhesive bonds

    潮氣和溫度對膠粘劑粘結能力影響的標準方法
  19. Compression dispersion - type anchor can be mainly classified into two categories, one of which is that, plastic coated strands in different length are respectively passed through their own bearing bodies and pre - bent as their midpoints to be t he shape of " u ", then forming several totally unbonded strand loops, i. e. unit anchor tendon. as the research object in this paper, study is performed on the anchor holding capacity, load - displacement behavior, displacement of the fixed anchor length, strain and bond stress distribution, and the removability of anchor tendon, furthermore, with the aid of analytical solution, the distribution of the bond stress is calculated and analyzed, based on the results of test and analytical solutions, design method is provided in this paper

    壓力分散型錨索主要有兩種結構型式，本文是以將不同長度的無粘結鋼絞線分別繞過不同的承載體彎曲成「 u 」形而組成各個單元錨索體這種型式為研究對象，對其承載力、荷載位移特性、錨固段位移特徵、應變與粘結應力分佈特徵以及錨索體的可回收性能展開研究，並藉助于理論分析研究其粘結應力分佈狀態，然後在此基礎上提出了壓力分散型錨索的設計計算方法。
  20. Based on the fast freeze - thaw test, the alkaline resistance test, the water immersion test, the wet thermal exposure test and artificial accelerated aging test, the influence of the corroding environment on the mechanical behavior of fiber reinforced polymer ( frp ) laminates and adhesive was studied

    摘要通過快速凍融試驗、耐堿性試驗、浸水試驗、濕熱暴露試驗、人工加速老化試驗，研究了腐蝕環境對纖維增強復合材料（ frp ）的復合體及粘結劑力學性能的影響。
分享友人
分享到 Line

分享到臉書