纖維長度分佈 的英文怎麼說

中文拼音 [xiānwéizhǎngdùfēnbù]
纖維長度分佈 英文
fiber length distribution
  • 纖 : 纖形容詞（細小） fine; minute
  • 維 : Ⅰ動詞1 （連接） tie up; hold together; link 2 （保持; 保全） maintain; safeguard; preserve; keep ...
  • 長 : 長Ⅰ形容詞1 （年紀較大） older; elder; senior 2 （排行最大） eldest; oldest Ⅱ名詞（領導人） chief;...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 纖維 : fibre; staple; filamentary
  • 長度 : length; longitude; size; extent; footage
  1. In the course of studying the fibre parameter in different development period, it was discovered that the rod density increased from the top to the middle of the boule

    考察纖維參數在不同生長階段的分佈規律發現，從頂部到中段纖維密度增大，從中部到根部纖維密度基本不變化。
  2. Study on fiber length distribution of taker - in droppings and card strips

    梳棉機刺輥落棉和蓋板花纖維長度分佈
  3. Advanced technical ceramics - ceramic composites - methods of test for reinforcements - determination of distribution of tensile strength and of tensile strain to failure of filaments within a multifilament tow at ambient temperature

    高級工業陶瓷.陶瓷復合材料.增強纖維的試驗方法.室溫下復絲束中長絲斷開時的拉伸強度和拉伸應變分佈的測定
  4. Advanced technical ceramics - ceramic composites - methods of test for reinforcements - part 5 : determination of distribution of tensile strength and of tensile strain to failure of filaments within a multifilament tow at ambient temperature

    先進工藝陶瓷.陶瓷復合材料.增強纖維的試驗方法.第5部分:周圍溫度下復絲束中長絲拉伸強度的分佈和斷裂拉伸應變的測定
  5. Textiles fibres - determination of length and length distribution of staple fibres by measurement of single fibres

    紡織纖維.短纖維長度和長度分佈的測定
  6. The distribution of linear density of cotton fibre along its longitudinal direction

    棉纖維沿長度方向線密度之分佈
  7. Base on the ideal sampling theories, fiber length distributions and figrogram of samples taking from the ideal sliver by actual sampler are studied, and factors affecting the distributions curves are researched into, some basic requests and references of sampling are concluded for the future developing of sampler

    摘要在理想的截面取樣理論基礎上，進一步研究了具有一定寬度的取樣夾持器以一定角度從「理想棉條」中取樣時試樣的理論分佈及照影機曲線，並結合實驗分析了取樣影響因素；根據研究結果得出了棉纖維長度測試的取樣要求，為取樣器的進一步開發提供了參? 。
  8. Epoxy - bonding a carbon - fiber composite plate to the tension face of concrete beam is an effective technique for repair and retrofit of concrete beams. in the first part of this paper, based on the fracture mechanics and the theory of beam, a theoretic model is proposed to analyze the shear stress in the adhesive between carbon - fiber composite and concrete. and then the closure - form solution for the shear stress distribution is drawn

    本文的第一部分基於斷裂力學與梁的基本理論，對碳纖維加固混凝土梁的粘結膠層以及粘結界面的剪應力分佈進行了理論分析，得出了其理論解析解；討論了碳纖維板的粘結長度、粘結厚度和粘結膠層的抗剪模量對界面剪應力分佈的影響。
  9. The length of fiber after pulp manufacture decreased, the width of fiber increased

    制漿后，纖維長度分佈的正態峰值擬合較好，纖維長度正態分佈較好。
  10. Textiles. tests on fibres. determination of length and length distribution by measurement of single fibres

    紡織.纖維試驗.纖維長度和纖維長度分佈的測定單根纖維測定
  11. Firstly, when the pipe flow was laminar, the movement of fibers was computed in the 2 - d force formulae that were deduced from the slender body theory and in 3 - d integral method. results revealed that angles between fibers " axis and the orientation of flow would concentrate gradually on a low number as the re numbers increased. that is, the axis of fibers would rotate toward the orientation of flow

    首先，當管道內流動為層流時，分別利用從細長體理論出發得出的纖維二維受力公式和三維分段積分計算方法模擬了大量纖維在流場中的運動，然後在最終時刻統計了纖維的偏角分佈，並得出相同的結果：隨著re數的增加，纖維粒子的偏角逐漸集中於小角度，即纖維軸線方向越來越集中於流向，此結果與實驗吻合較好。
  12. Standard test method for fiber length and length distribution of cotton fibers

    棉纖維纖維長度和長度分佈的標準試驗方法
  13. Standard test method for length and length distribution of cotton fibers array method

    棉纖維長度和長度分佈的標準試驗方法
  14. One is the method of figured sea - island : this method adopts bicomponent conjugate spinning technology to produce super - fine fibers, whose cross section is made up of two types of components : one type of elements that are fine and dispersed is encircled with another, which bears a resemblance to islands amid the sea

    一是定島法：它是通過雙組份復合紡絲技術製成，其纖維橫截面是一種成分以微細而分散狀態被另一種成分所包圍，很像海中島嶼，其島與海成分在纖維長度方向上是連續密集均勻分佈。
  15. And this numerical result is similar to the experimental result. then, the computation was played on different domain, rate of fibers and st numbers and got the conclusion that the farther the distance between the domain and the center of the pipe was, the more fibers " axis concentrated on the orientation of flow, while the rate of fibers and the st numbers had little influence on the distribution

    然後通過考慮管道截面上的不同區域、改變纖維長徑比和st數來研究他們對纖維偏角分佈的影響，從而得出結果：隨著計算區域從管道截面的中心向壁面的轉移，纖維粒子的偏角分佈逐漸集中於低角度；而纖維長徑比和st數卻對纖維的偏角分佈沒有明顯影響。
分享友人
分享到 Line

分享到臉書