脈動泵 的英文怎麼說

中文拼音 [màidòngbèng]
脈動泵 英文
jerk pump
  • 脈 : 脈名詞1. （動脈和靜脈的統稱） arteries and veins2. （脈搏的簡稱） pulse 3. （像血管的組織; 連貫成系統的東西） vein
  • 泵 : 名詞（吸入和排出流體的機械） pump
  • 脈動 : [物理學] [天文學] pulsation; pulsing; pulse; ripple; impulsive motion; pulsating; panting; loping...
  1. If the coefficient of engagement overlap decreases, the flow aggrandize, trapping volume and the flow pulsating ratio decreases

    隨著齒輪嚙合重合系數的減小，齒輪泵的流量增大，困油容積和流量脈動率減小。
  2. This paper supplied a new way through variable frequency variable speed ( vfvs ) to change its output flow rate and adding a constant - pressure - drop valve, which could solve the defects in hydraulic pressure servo control system, such as low efficiency in control system, short life, poor ability in resisting pollution, low efficiency in driving system and flow rate, pressure pulse. and this way was proved to be effective

    本論文針對傳統伺服控制系統效率不高、元件壽命短、抗污染能力差、驅動系統效率低、存在流量及壓力脈動等缺陷，利用先進的交流變頻調速技術改變液壓泵轉速的容積調速新方法，提出了在液壓系統中加一個定差減壓閥的新思路，較好地解決了液壓伺服系統存在的上述問題。
  3. The rubber joint between stepper motor and transfer pump can minish pulsation caused by the shake of the motor when transfusing

    步進電機與輸液泵之間通過橡膠連接頭實現連接，可緩解輸液時由步進電機震動引起的脈動。
  4. The flow characteristics of the elliptic rotator pump

    擺動活齒泵的流量脈動
  5. Objective : to investigate the effect of pumpless portosystemic bypass in clinical piggyback liver transplantation. methods : after catheterized inferior mesenteric vein, the silastic catheter ( filled with heparin saline ) was connected with the catheterized tube of internal jugular vein or subclavian vein in four piggyback liver transplantation patients. the channel was opened after the portal vein was occluded. the portal vein blood poured into the superior vena cava through the pumpless channel. the changes of mesenteric congestion, portal vein pressure, blood pressure and pulse were observed. results : during the occlusion of portal vein, the portal vein pressure was increased greatly, the intestine was congested and swelled obviously and the blood pressure and pulse fluctuated gently. after the pumpless bypass opened, intestinal congestion and swell were abated markedly, the portal pressure, blood pressure and pulse gradually returned to normal range. conclusions : pumpless portosystemic bypass shows a great effect on clinical piggyback liver transplantation. it is a feasible and economical method

    目的探討背駝式原位肝移植術中採用體外門-體靜脈無泵轉流的臨床效果.方法4例行背駝式原位肝移植患者，腸系膜下靜脈屬支插管經體外硅膠管（充滿肝素鹽水）與頸內靜脈或鎖骨下靜脈插管相接，在阻斷門靜脈后開通腸系膜下靜脈插管，門靜脈血從體外無泵轉流管流入上腔靜脈，觀察轉流前後腸道瘀血、門靜脈壓、血壓、脈搏等變化情況.結果門靜脈阻斷后腸道明顯瘀血、腫脹，門靜脈壓力明顯升高，血壓、脈搏有不同程度的波動，無泵門靜脈轉流開放后，腸道瘀血、腫脹明顯好轉，門靜脈壓力逐漸恢復正常水平，血壓、脈搏恢復正常.結論背駝式原位肝移植術中體外門-體靜脈無泵流具有方便、經濟、實用等優點，具有良好的臨床效果
  6. Aim at to turn a dense oil pump in the movement the metal bellow expansion joint and buffer tank was installed in the dense oil pump export because of the violent vibration and noise cause by the discharge and the pressure pulsation, the result show lowered the vibration and noise availably was obvious

    摘要針對轉子式稠油泵在運行中因流量和壓力脈動所引起的劇烈震動和噪聲，在稠油泵出口安裝金屬伸縮節和緩沖罐，有效地降低了震動和噪聲。
  7. The following is the detail design of the pump, and a optimum mathematical model are presented to mostly reduce the helical gear pump flow pulse

    在此基礎上進行了斜齒齒輪泵的結構設計，通過建立斜齒齒輪泵齒輪的優化數學模型，優化計算出使輸出流量脈動最小的斜齒輪參數，製造出斜齒齒輪泵樣機。
  8. 2. the flux characteristics of ordinary helical gear pump are lucubrated by theory for the first time, on this condition the selective qualification of the helical gear pump is gained

    首次對普通斜齒齒輪泵流量特性進行了深入的理論研究，在此基礎上研究了全齒廓嚙合斜齒齒輪泵流量特性，首次得到了完全消除斜齒齒輪泵流量脈動的螺旋角的選擇條件。
  9. And at last the measurement of helical gear pump flow pulse has been presented, which include how to measure the flow pulse and the validating the theory mentioned before and to try to the solve the problems happened during the process

    根據齒輪泵流量脈動的檢測要求，採用新的測試方法和手段，建立了中高壓齒輪泵性能測試裝置，並對樣機進行了性能測試。
  10. The researchful results indicate that the flux pulse ration of ordinary helical gear pump without clearance is less than that of the gear pump with clearence under the condition that the main parameters are same, and the flux pulse ration of ordinary helical gear pump is less than that of whole profile meshing helical gear pump

    研究結果表明：在主要參數相同的情況下，普通斜齒齒輪泵無側隙時流量脈動率小於有側隙時的流量脈動率；全齒廓嚙合斜齒輪泵比普通斜齒輪泵的流量脈動略小。
  11. With the research in the paper succeeded it would be certain that the helical gear pump would replace the spur gear pump now widely existed in the market and also could replace the other type of hydraulic pump in some areas, which surely greatly decrease the cost of manufacture and advance the development of technology. the importance is undisputable

    本論文研究的斜齒嚙合式低脈動齒輪泵可代替現廣泛存於市場上的直齒輪泵，並能在很大程度和范圍內替代其它形式液壓泵的作用，這對于促進機械裝備的技術進步、降低機械裝備的製造成本具有十分重要的意義，其應用前景將十分廣闊。
  12. At first, on the base of the analysis of the mechanism of the helical gear pump, the paper try to find the relationship of the helical gear pump flow pulse with its corresponding parameters, give the solution of the problems brought by the replace of spur gear to lay the firm basis for the structural design of helical gear pump

    本論文在對齒輪泵工作原理和流量脈動機理分析的基礎上，首先探討了斜齒齒輪泵的輸出流量脈動與斜齒輪各結構參數之間的關系，以及由於斜齒輪替代直齒輪帶來的相關問題並提出解決辦法，為斜齒齒輪泵的結構設計奠定基礎。
  13. Experimental study on the sliding - tooth pump

    擺動活齒泵流量脈動的試驗研究
  14. The flow characteristics of compound gear pump

    中心輪齒數對復合式外齒輪泵流量脈動的影響分析
  15. The tooth shape of gear pump has important influence on machining and characteristics of pumps, such as flow rate, fluctuation rate and noise etc. first, the working principle of tatsuno combined pumps is analyzed in this article

    齒輪泵的齒形對泵的加工、性能（如：流量、脈動率、噪聲）等有很大的影響。本文首先分析了進口tatsuno組合泵的工作原理，並進一步分析了其採用一對雙圓弧齒輪的優缺點。
  16. Although the flux per revolution of the optimized pumps is a little smaller than that of tatsuno combined pumps, other characteristics, such as fluctuation rate, maximum pressure angle and velocity fluctuation rate etc, are much better. the methods to cut gears are proposed in the theory for the practical produce in the future

    雖然，在體積相等的條件下，優化出來的外圓弧包絡線內嚙合齒輪泵的排量略小於tatsuno組合泵的排量，但其它性能（如：流量脈動率、最大壓力角、速度波動量）都更優。
  17. The mathematical model of diesel - generator set in the mechano - electronic transient process is proposed in this paper, the pulsation and delay of diesel torque are analyzed, the relation between diesel torque and diesel rotational speed together with injection pump rack bar displacement is described exactly. the motion law of diesel - generator set is revealed all - sidedly and nonlinear problem of diesel - generator set is settled by piecewise linearzation method

    本文提出了柴油發電機組機電暫態過程的數學模型，分析了柴油機轉矩的脈動和滯后，準確地描述了柴油機輸出軸扭矩與柴油機轉速和噴油泵齒桿位移之間的關系，全面揭示了柴油發電機組的運動規律，利用分段線性化的方法解決了柴油發電機組的非線性問題。
  18. In the third chapter, the mathematical models of project system have been established, and simulation has been done on the simulink enviroment of matlab software kits. the simulation focus on the effects of main parameters on the dynamic characteristics of speed control system, and the main parameters include viscosity damp coefficient and friction torque of electrical motor shaft, internal leakage coefficient of pump / motor of hydraulic circuits, gas volume of pressure accumulator, viscosity damp coefficient of cylinder piston and different running building floors, etc. at last, theoretical research effects of the flow and pressure pulsation of pump / motor on car speed and oil volume leakage theory are discussed. the fourth chapter of this thesis concerns the research on the key items about hydraulic power control system according to the ens 1 - 2 and other hydraulic elevator standards

    論文第三章針對組成系統的各個模塊進行了機理建模，並且通過matlab軟體中的simulink圖形化模擬環境進行了本課題系統的模擬研究，主要針對影響系統特性的主要參數變化，動態分析系統的輸出特性，在上下行工況中，分析了電機軸系粘性阻尼系數、軸系摩擦力矩、主迴路蓄能器迴路液壓泵馬達內泄漏系數、蓄能器氣體容積、液壓缸柱塞粘性阻尼摩擦系數以及不同運行樓層工況等參數對系統特性的影響；最後對軸向柱塞泵馬達的流量壓力脈動對電梯轎廂速度的影響和蓄能器內油液體積損失機理進行了理論研究。
  19. In chapter 3, the pressure pulse under the two situations of the system with and without damper is discussed at the basic of analyzing the flow rate pulse. then the conclusion that the system has filtering effect is drew after adding a damper in it, but its serious in power wastage because of adding a damper

    第三章，在分析液壓泵流量脈動的基礎上，討論並對比了系統加與不加阻尼兩種情況下各自的壓力脈動，得出系統中加一個阻尼后，具有一定的濾波作用，但是當流量較大時，由於阻尼的存在，系統功率損失比較嚴重。
  20. Finally finding that there are two reasons that cause vibration of pipe and noise. the one is the vibration of pump which transfers to pipe and stimulates the vibration of pipe. the second is the stimulating frequency of pulsating water is coherent with the natural frequency of pipe

    最後得出管道的振動主要是由於兩個原因，一是泵的機械振動傳遞給管道，引起管道的振動；二是由於水流的脈動激勵頻率與系統的固有頻率相吻合，引起管道的共振發聲。
分享友人
分享到 Line

分享到臉書