腐蝕探針 的英文怎麼說

中文拼音 [fǔshítànzhēn]
腐蝕探針 英文
corrosion probe
  • 腐 : Ⅰ名詞（豆腐） bean curdⅡ動詞（腐爛; 變壞） decay Ⅲ形容詞（腐爛） rotten; corroded; putrid
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 探 : Ⅰ動詞1 （試圖發現） try to find out; explore; sound 2 （看望） call on; visit; see 3 （向前伸出）...
  • 針 : Ⅰ名詞1 （縫衣物用的工具） needle 2 （細長像針的東西） needle like things 3 （針劑） injection; sh...
  • 腐蝕 : 1 （通過化學作用使物體逐漸消損破壞） corrode; corrosion; corroding; deep etch; diabrosis; rot; ea...
  • 探針 : probe; sound; filling fork; feeler; explorer; probing pin; touch needle; wire probe
  1. And it investigates the appearance condition ( including joint, crack, eroding, corrosion, braking pole device rupture, crane - girder ' s gnawing railway and so on ) of the whole crane - girder system on the spot, at the same time, it also actually examines the stress of the beam, chemical ingredient, distortion and railway excursion, etc. through sampling, and based on the actually examined results, it checks and calculates the carrying capacity of crane - girder system. then, based on the investigating on the spot and the calculated result, it discusses the mechanism of fatigue failure of the upper part of welded steel crane - girder, analyses the reason of steel crane - girder in the high - frequency emerging the fatigue crack, institutes the strengthened method of damaged steel crane - girder of accurate packing up workshop of the primary mill plant. finally, it presents some advice and suggestions for the repairing and strengthening method of fatigue crack of upper part of steel crane - girder in the high - frequency

    針對包鋼初軋廠精整車間鋼吊車樑上部區域出現裂縫這一問題，本文首先綜述了國內外關于焊接鋼吊車樑上部區域疲勞裂縫的研究現狀；其次對整個吊車梁系統的外觀情況（包括連接、裂縫、腐蝕、銹蝕、制動桿件斷裂、吊車啃軌等）進行了現場調查，抽樣實測了梁的應力、化學成分、變形及軌道偏移等，根據實測結果，對吊車梁系統的承載能力進行了驗算；然後，根據現場調查及計算結果，探討了焊接鋼吊車樑上部區域疲勞破壞的機理，分析了重級工作制鋼吊車梁出現疲勞裂縫的原因，制定了初軋廠精整車間破損鋼吊車梁的加固方案；最後就重級工作制鋼吊車樑上部區域出現疲勞裂縫的修復與加固方案提出了一些意見和建議。
  2. The method of electron probe micro analysis as corrosive layer on ferrous metals of ship

    船舶黑色金屬腐蝕層的電子探針分析方法
  3. Aiming at the serious corrosion problems of equipment, pipeline, production well, and scaling problems of transporting line in block guangbei of bamianhe oilfield, the main mechanisms and causes of corrosion and scaling have been investigated through analyzing and determining water quality, composition of scaling and corrosion products, which have provided theoretic support for further solving the problems of corrosion and scaling in block guangbei

    摘要針對八面河油田廣北區塊設備、管線、油井的嚴重腐蝕及輸油管線的結垢問題，通過水質、垢物及腐蝕產物的分析與測定，分析與探討了腐蝕結垢的原理和主要原因，為進一步解決廣北區的腐蝕結垢問題提供了理論依據。
  4. In this paper, reinforced concrete beams with different water / cement ratios and defects were used to study corrosion of the effect on the beam behavior

    摘要本研究針對不同的混凝土梁試體，探討其腐蝕后之力學行為。
  5. By means of chemical etching, microscope observation, eelectron probe x - ray micro - analyzer ( epma ), the micro - distribution of c acceptor defect in lec si - gaas wafer is investigated, the results show that there is serious influence of the density and distribution of dislocations on the distribution of c impurity in wafer

    本文通過ab腐蝕、 koh腐蝕，金相顯微鏡觀察，透射電鏡能譜分析，電子探針x射線微區分析，研究了液封直拉法生長的非摻半絕緣砷化鎵（ lec ， si - gaas ）單晶中碳的微區分佈。
分享友人
分享到 Line

分享到臉書