腐蝕疲勞 的英文怎麼說

中文拼音 [fǔshípíláo]
腐蝕疲勞 英文
corrosion fatigue cracking
  • 腐 : Ⅰ名詞（豆腐） bean curdⅡ動詞（腐爛; 變壞） decay Ⅲ形容詞（腐爛） rotten; corroded; putrid
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 疲 : 形容詞（疲乏; 勞累） tired; weary; exhausted
  • 勞 : Ⅰ動詞1 （勞動） work; labour 2 （煩勞） put sb to the trouble of; trouble sb with sth : 勞您費心...
  • 腐蝕 : 1 （通過化學作用使物體逐漸消損破壞） corrode; corrosion; corroding; deep etch; diabrosis; rot; ea...
  • 疲勞 : 1. （疲乏勞累） tired; fatigued; weary; become fagged 2. （機能或反應能力減弱） fatigue; strain 3. [物理學] fatigue
  1. In addition to, the fatigue crack between web and upper flange of welded steel crane beam on heavy duty service was discussed, and based on long - term observation and research, the author classified fatigue crack into bearing type and middle type crack along the horizontal direction. the causation, distributive law and mechanism of the crack were analyzed, and the precautions to take and the measures to remedy crack were presented. the main defacts including damage, crack, erosion and aging in structures, especially in concrete structure were introduced ; the defact mechanism was analyzed and the precautions to take were also given

    另外，作者對重級工作制焊接鋼吊車梁腹板與上翼緣連接焊縫的縱向水平疲勞裂縫進行了長期的觀察和研究，根據疲勞裂縫產生的不同機理，將其分為支點裂縫和肋間裂縫，並討論了兩類裂縫產生的原因、分佈規律、機理以及防治的措施；對工程中經常遇到的結構構件，尤其混凝土構件的幾種主要病害（損傷、裂縫、腐蝕與老化）進行了機理分析並提出了防治措施。
  2. Corrosion endurance limit

    腐蝕疲勞極限
  3. The corrosion resistance of aluminum alloys is improved by anodic oxidation, if the fatigue behaviors are taken into account, the behaviors of aluminum alloys by sulfuric acid anodizing is better than by chromic acid anodizing

    陽極氧化是提高鋁合金耐蝕能力的常用方法，如果從疲勞性能的角度考慮，經硫酸陽極氧化的鋁合金腐蝕疲勞性能比鉻酸陽極氧化的更好一些。
  4. Furthermore, the supposition of galvanic couple is drawn into the procedure of corrosion fatigue crack growth of aluminum alloys, the relation of couple current vs loading time is determined with electrochemical methods. a formula in the theory is deduced which expresses the stress corrosion crack growth rate of lc4cs aluminum alloy, the results of mathematical modeling preferably correspond with examination

    再將「耦合作用」的猜想，引入鋁合金的腐蝕疲勞裂紋擴展過程中，用電化學的方法測定耦合電流與加載時間的關系，並從理論上導出lc4cs鋁合金應力腐蝕裂紋擴展速率的數學表達式，數學模擬的結果與實驗值具有較好的一致性。
  5. Corrosion fatigue limit

    腐蝕疲勞極限
  6. Matals - rotating bar bending corrosion fatigue testing

    金屬旋轉彎曲腐蝕疲勞試驗方法
  7. Corrosion of metal and alloys - corrosion fatigue testing - cycles to failure testing

    金屬和合金的腐蝕.腐蝕疲勞試驗.失效試驗周期
  8. Corrosion of metals and alloys - corrosion fatigue testing - part 1 : cycles to failure testing

    金屬與合金的腐蝕.腐蝕疲勞試驗.第1部分:失效試驗周期
  9. Approximate calculation of crack propagation rate of metal corrosion fatigue

    金屬腐蝕疲勞裂紋擴展速率的近似計算
  10. Generator testing system based on serial communication for platforms

    基於隨機采樣法的液壓腐蝕疲勞試驗測控系統
  11. The formation of 3. 5 % nacl solution is almost similar to that of 3. 5 % nacl thin electrolyte layer, just the mass transfer rate of the oxygen in the layer is more quicker than in the solution ? the test shows that the crack growth rate of wet - corrosion fatigue of lc4cs aluminum alloy in the layer is quicker than in the solution, and also shows that morphology of fatigue fracture in the layer is evidently distinguished from in the solution

    3 . 5 nacl溶液和3 . 5 nacl薄液層的化學組成幾乎完全相同，只是薄液層中氧的傳質速率較快。實驗結果顯示了在薄液層中， lc4cs鋁合金的濕腐蝕疲勞裂紋擴展速率，大於在3 . 5 nacl溶液中的速率。實驗還發現其疲勞斷口的形貌，也與3 . 5 nacl溶液中的有明顯區別。
  12. Metals - rotating bar bending corrosion fatigue testing

    金屬旋轉彎曲腐蝕疲勞試驗方法
  13. Considered local damage due to steels corrosion, fatigue, prestressing loses, whole bridge incline and distortion, this paper studies damage diagnosis technique of the cable - stayed bridge and determines the location and size of damages for yonghe cable - stayed bridge, which has been used after 15 years

    針對鋼筋腐蝕、疲勞、預應力鬆弛、橋梁整體傾斜或變形所引起的斜拉橋局部破損，本文以使用15年後的永和斜拉橋為研究對象，對大型斜拉橋破損診斷技術進行研究，對永和斜拉橋破損位置進行定位、對其破損程度進行評價。
  14. Research on fatigue curves for pre - corroded aircraft structures

    飛機結構預腐蝕疲勞曲線研究
  15. The composition and modality of the environment medium play an important role in the crack growth of corrosion fatigue

    環境介質的組成、形態是影響腐蝕疲勞裂紋擴展的重要因素。
  16. Study on evaluation of a c structure corrosion fatigue life

    飛機結構腐蝕疲勞壽命預估工程方法研究
  17. Corrosive fatigue of structures with dimple holes under spectrum loading

    飛機譜載下鋁合金鍃窩孔結構腐蝕疲勞研究
  18. Corrosion of metal and alloys - corrosion fatigue testing - crack propagation testing using precracked specimens

    金屬合合金的腐蝕.腐蝕疲勞試驗.採用預開裂樣品的裂紋擴展試驗
  19. Corrosion of metals and alloys - corrosion fatigue testing - part 2 : crack propagation testing using precracked specimens

    金屬與合金的腐蝕.腐蝕疲勞試驗.第2部分:使用預裂紋樣品的裂紋擴展試驗
  20. Standard practice for corrosion fatigue testing of metallic implant materials

    金屬植入物腐蝕疲勞試驗的標準操作規程
分享友人
分享到 Line

分享到臉書