膜下原纖維 的英文怎麼說

中文拼音 [móxiàyuánxiānwéi]
膜下原纖維 英文
submembraneous fibril
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  • 下 : 下動詞1. （用在動詞后,表示由高處到低處） 2. （用在動詞后, 表示有空間, 能容納） 3. （用在動詞后, 表示動作的完成或結果）
  • 原 : Ⅰ形容詞1 （最初的; 原來的） primary; original; former 2 （沒有加工的） unprocessed; raw Ⅱ動詞（原...
  • 纖 : 纖形容詞（細小） fine; minute
  • 維 : Ⅰ動詞1 （連接） tie up; hold together; link 2 （保持; 保全） maintain; safeguard; preserve; keep ...
  • 纖維 : fibre; staple; filamentary
  1. The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine

    用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌：用xrd進行原料物相分析，及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度；用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性；用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化；用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試；採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定；用萊次偏光顯微鏡（ pm ）測試固體潤滑劑的硬度；用材料試驗機測試固體潤滑劑的抗壓強度等。
  2. Ultrastructurally, the outer membrane consisted of bundles of collagen fibrils and cellular elements such as fibroblasts, mast cells, migrating erythrocytes, platelets and eoslnophils

    在電鏡下血腫外膜可見成束狀之膠原纖維及一些細胞成份如纖維織母細胞、肥大細胞、移動性紅血球、血小板及嗜伊紅細胞。
  3. Cell adhesion to surface of the substrate is essential to development of the anchorage - dependent cells. only after adhering to surface followed by spreading can cells develop and proliferate. most synthetic polymers used as orthopaedic matrix substitute present hydrophobicity, which may correlates to the low degree of cell attachment. modification with cell adhesion protein / peptides can be benificial to the cell adhesion on polymers and then affect the cell proliferation and differentiation. cell attachment to substrate is primarily mediated by integrins, a widely expressed family of heterodimeric surface receptors. most extrcellular matrix proteins such as fibronectin, osteopontin, collagen type i, bone sialoprotein and vitronectin contain an arg - gly - asp ( rgd ) sequence which is specific to the fixation of cell membrane receptors like integrin. the main aim of this research is to measure, assess adhesion, proliferation of rabbit marrow stromal cells ( mscs ) on the polymers coated by fibronectin, collagen type i or biotie gen, which includes : ( 1 ) biologic characteristics of rabbit mscs were observed by two types of separating method in primary culture. ( 2 ) adhesion, proliferation and differentiation of mscs cultured on polymers coated with biotiegen were assessed. ( 3 ) also, adhesion, proliferation and differentiation of mscs were assessed on plga film or porous plga substrates coated with fibronectin, or collagen type i respectively. ( 4 ) bone formation was observed on the porous plga substrates coated with collagen type i in vivo. this research aims to give new way to make novel synthetic bone with cell adhesion and high bone induction capabilities

    因此將這些蛋白包被、固定到材料表面，觀察骨組織工程種子細胞mscs細胞的粘附、生長特性是本研究的中心環節，並從以下方面進行探討： （ 1 ）採用不同原代細胞分離方法，研究其對mscs細胞的生物學特性影響。 （ 2 ）檢測基因勝肽膠對mscs細胞粘附、增殖及分化的影響。 （ 3 ）分別採用型膠原及纖維粘連蛋白（ fibronectin ， fn ）包被聚乙醇酸-乳酸共聚物（ poly （ 1actide - co - glycolide ） ， plga ）膜及多孔塊型plga材料，觀察細胞在單層或三維培養狀態下，型膠原及fn對mscs細胞粘附、增殖及向成骨細胞分化效應及能力。
  4. It can be concluded that the performance differences between the plate membrane and the hollow fiber membrane can be attribute to difference of the stresses in the membranes when they were under pressure and the difference of the strain caused in the membrane, besides the possible reason that the surface curvature difference between a plate substrate and a hollow fiber one may cause structure difference in the dense functional layer when coating. the stresses in a hollow fiber composite membrane under an outside pressure are quite different from that in a plate one in that they exert on the hollow fiber in both the radial and circular directions, and the compress strain of the hollow fiber is thus much more complex, which may cause the top layer crinkle and a decreased salt rejection

    分析認為造成平板復合膜（ ）和中空纖維復合膜（ ）性能差異的主要原因，除了平板基膜與中空纖維基膜因表面曲率不同可能引起在塗覆時形成的緻密功能層結構上的差異之外，由於中空纖維膜受外壓時，膜內部承受的應力形式與平板膜不同，會同時在徑向（膜厚度方向）和環向（膜面內方向）兩個方向產生壓應力，因此，所發生的形變也較為復雜，可能造成表面復合層的起皺或脫落，引起脫鹽率下降。
  5. This trichrome stain of the stomach demonstrates intense blue staining in the submucosa from the collagen deposition

    胃三色染色顯示在黏膜下層膠原纖維沉積處染上深藍色。
  6. In order to improve the efficiency of alga - removing by conventional water treatment process and offer referential information to the development of integrative drinking water treatment equipments, this paper mainly studied the characteristics of ultra - filtration for the raw water, raw water which adding alum, effusion of sedimentation pond and water taken from a farm lake in xingsha town utilizing hydrophilic modified pan hollow fiber ultra - filtration membrane filters

    為了解決水廠傳統工藝除藻效率低下的問題，同時也為了給飲用水膜處理設備的開發提供可借鑒的數據資料，本文利用pan中空纖維膜分別對水廠原水、加礬后原水、沉澱池出水、星沙某農家樂池塘水進行了超濾試驗。
分享友人
分享到 Line

分享到臉書