膠體比值 的英文怎麼說
中文拼音 [jiāotǐbǐzhí]
膠體比值
英文
colloidal fraction-
Our study results indicated : on light adaptation, the ratios of the density of the gold particles in the rhabdom to that in the cytoplasm in macrobrachium rosenbergi photoreceptor cell in high calcium solution, physiological solution and low calcium solution was 21 / 6 、 1
結果顯示:光適應組，在高鈣溶液、生理溶液和低鈣溶液中細胞質與感桿束中膠體金密度的比值是21 / 6 、 17 / 8和13 / 14 。When nals was used as the collector in the process, the optimal conditions were the ph of feed solution 5. 0 - 6. 0, air flow rate 100ml / min, the liquid column depths 20cm, the surfactant concentration determined by its cmc and feed concentration. under this condition, the 3 can be above 20. also, the optimal ph ( 5. 0 ) was calculated theoretically for the recovery of the cu ( ii )
對以十二烷基硫酸鈉為捕集劑的泡沫吸附分離過程的工藝參數進行了研究，並得出本分離系統所確定的最佳工藝參數為： ph5 . 0 6 . 0 ，氣體流量100ml min ，液位高度20cm ，最佳表面活性劑濃度由其臨界膠束濃度和原料液濃度確定，此時（濃縮比）可達20以上；同時還從理論上推算出泡沫吸附分離銅的最佳ph值范圍為5 . 0左右。The effect of amorphous hydrated ruo _ 2 power production is discussed here, including : selection and ratio of solvent, selection and concentration of precipitator, terminal ph of titration and anneal temperature and time of colloid. research indicated that terminal ph and anneal temperature are the most important influence factors on physical and electrochemical properties of amorphous hydrated ruo _ 2 power
討論了超細氧化釕粉體的制備影響因素，包括:溶劑選擇和配比、沉澱劑選擇和濃度、滴定終點ph值以及焙燒溫度和時間對氧化釕粉體粒度分佈及電化學的影響，研究表明:沉澱終點ph值以及膠體焙燒溫度對粉體物理和電化學性能影響較大。Based on the continuous damage theory, considering the shear effect, the high - order shearing, flexural and in - plane deformation coupling model is built ; through the nonlinear fem analysis of rc beams strengthened with frp, the damage theory and damage course is researched ; compared with experiment results, it shows that the model is effective ; the fem analysis software is prepared to provide simple and effective method for the engineering application ; using the soft the frp strengthened beams before and after damage is modeled so as to provide the theory base for engineering application
摘要基於連續損傷理論，考慮膠層的剪切效應，建立frp加固鋼筋混凝土梁的高階剪切彎曲及面內變形耦合模型，編制了有限元分析的軟體，進行非線性有限元分析；通過與已有的試驗結果進行對比，證明該模型的簡單，有效性；利用該軟體對未加固混凝土梁，初始進行加固的混凝土梁以及最大拉應變達到極限值時進行加固的混凝土梁等幾種情況進行數值模擬。And the value drop to the lowest at ph = 0. 8. as the increase of heat treatment temperature, the pore size distribution peak of sio2 microspheres is very narrow, meanwhile the specific surface area is the smallest before 160 c. the polymer template is removed at 350 c, so the pore structure of sio2 particles has a big change which involve the increase of specific surface area and the broaden of pore size distribution peak. with the continuous raise of temperature the sio2 network will shrink little, as a result the average pore size will decrease, but the specific surface area has no obvious change
結果發現：二氧化硅膠體顆粒均勻分佈於脲醛聚合物網路中，煅燒去除有機模板后微球表面變粗糙，而粒徑沒有明顯變化； ph值較小時，復合微球中聚合物含量較大，而ph值較大時，得到復合微球結構鬆散，因此熱處理后的二氧化硅微球孔容及平均孔徑都較大，而在ph = 0 . 8時，得到最小值；武漢理工大學碩士學位論文隨著熱處理溫度的變化，小於160時，空分佈較窄，而比表面積較小，在350時，由於有機模板的去除，微球孔結構發生突變，比表面積明顯增大，而孔徑分佈變寬，溫度繼續升高時，二氧化硅網路發生收縮，平均孔徑變小而比表面積由於有機炭化物的完全去除沒有太大變化;微球中的微孔在熱處理過程中處于平衡狀態，分佈沒有太大變化。The oxygen sensing properties of the membranes have been studied, the results indicate that the membranes with ru ( phen ) 3cl2 have better oxygen - sensitivity than those with ru ( bpy ) 3cl2, and the membranes with the formamide content of 16 % ( v / v ) and ru ( phen ) 3cl2 content of 2. 10g / l in the precursor mixture have the best structure and quality. the fiber optic gas oxygen sensor with this sensing membrane has a detection limit of 5ppm, a response time of less than 30s, excellent reproducibility and stability. ( 2 ) a new kind of organically modified oxygen - sensitive membrane based on fluorescence quenching was prepared by sol - gel method, using dds and teos as the mixed precursor, rufchenbcla as the indicator
實驗證明：該類敏感膜的tan _ 0 tan值與氧氣濃度存在良好的線性關系；包埋ru （ phen ） _ 3cl _ 2的凝膠膜的氧敏感性相對較好；當甲酰胺為16體積比含量， ru （ phen ） _ 3cl _ 2在前驅體中濃度為2 . 10g l時，制備的敏感膜結構和性能最佳；對氣態氧檢測時，該敏感膜的響應時間小於30秒，檢測下限為5ppm ，具有較好的重復性和穩定性。The objective of this study was to synthesize microcapsules containing a composite phase change materials for application in indoor wall controlling temperature, which would save energy and make comfort indoors. three microcapsulation methods have been applied to preparation micropcms
採用復合凝聚法，以明膠-阿拉伯樹膠為壁材，在水相體系中通過控制ph值和物料比，制得相變儲熱微膠囊。分享友人