芯棒拉拔 的英文怎麼說
中文拼音 [xīnbànglābá]
芯棒拉拔
英文
plug drawing- 芯 : 芯名詞1. （物體或器物的中心部分） core 2. （蛇的舌頭） snake's tongue
- 棒 : Ⅰ名詞（棍子） stick; staff; club; cudgel Ⅱ形容詞[口語] （強; 高; 好） strong; excellent; good
- 拉 : 拉構詞成分。
- 拔 : Ⅰ動詞1 （拉出; 抽出） pluck; pull out; pull up; draw; move 2 （吸出） draw; suck out 3 （選取 提...
- 拉拔 : [冶金學] draft; drawing拉拔力 pulling capacity; 拉拔模孔 draw hole; 拉拔強度 pull strength; 拉拔...
-
Abstract : this paper analyzes theoretically the effect of the reversed cone angle and length of the plug on restraint and elimination to the distortion of the internal spiral ribs, and put forth the design methods of the plug in drawing rifled tube
文摘:從理論上分析了芯棒倒錐角和芯棒長度對內螺旋凸筋形狀畸變的抑制和消除作用，提出了採用倒錐形等螺距芯棒拉拔內螺紋管時芯棒幾何參數的設計方法。The calculation results show that the stress distributing of the plug drawing tube is different because of different dies, the drawing force and pulling force are lager in arc die and the diameter and wall thickness are closer to the designing value in cone die
計算結果表明，不同的模具，芯拔管的應力分佈不同，弧形模成型的拔制力與芯棒后拉力較大，錐形模成型后鋼管的直徑與壁厚更接近設計值。In order to obtain the stress distributing rules of the forming process of short plug drawing tube and the differences of drawing force, pulling force and dimension precision under different dies, fe method was used and fe model of the plug drawing tube under different dies was built
摘要為了獲得不同的模具下短芯棒拔管成型過程中的應力分佈規律以及不同模具對短芯棒拔管拔制力、芯棒后拉力和尺寸精度的影響規律，利用有限元的方法，建立了不同模具下短芯棒拔管成型的有限元模型。
分享友人