調節單元 的英文怎麼說
中文拼音 [diàojiédānyuán]
調節單元
英文
regulating unit-
The theories and design principles of each circuit of the spwm three - phase frequency inverter experiment unit are in detail introduced in this thesis. at the same time some experiment results are shown that include the output voltage and current waves when the load is in resistivity, inductivity or asynchronous motor
文中詳細介紹了spwm三相變頻實驗單元所包含的各電路環節的理論基礎及設計過程，並給出了調試結果，如負載為阻性、感性和異步電動機時，實驗單元輸出的電壓和電流波形。Carrier-gas and instrument-air regulators are located on a panel within the upper compartment.
該分析單元的上部還安有載氣調節器和儀表風調節器。Analyze and compare pid and vague, single neuron etc. control strategy, and combine with single neuron self adaptive gain, self adaptive right value and preventive integral saturation etc. control strategy. have improved single neuron control algorithm, may restrain efficiently to disturb, reduce broken arc and short circuit etc. phenomenon, make systematic control effect and robustness get to strengthen, also have certain application reference value for the design of the dc arc furnace
通過對pid 、模糊、單神經元等控制策略的分析比較，將單神經元增益與權值的自適應調節、抗積分飽和等控制策略相結合，改進了單神經元控制器演算法，可以有效抑制擾動，減少斷弧、短路等現象的發生，使系統的控制效果和魯棒性都得到增強，對電弧爐控制系統的設計也具有一定的應用參考價值。Ddz - series process electronic control system. controller
Ddz -系列電動單元組合儀表.調節器Ddz - 3 series process electronic control system - controller
Ddz -系列電動單元組合儀表調節器The control method was introduced and the hardware of the controller was designed. the controller uses the 89c52 and 89c2051 as the main control unit and produces the on and off and angle signal of each phase. combined with protecting signal and current chopping signal, it can control the igbt on and off
介紹了srd的控制方式和本系統所採用的控制策略，對控制器的硬體電路進行了設計，控制器以89c52和89c2051雙cpu為主控單元，採用模糊調節，發出相通斷信號和角度信號，並和電流、電壓等保護信號以及斬波信號相結合，實現對主功率元件的通斷控制。They are overview, vowels, consonants, syllable stress, rhythm, intonation, supplementary units
其中的主題有概論，母音，子音，音節重音，節奏，語調，補充單元。In chapter 5, the principle of molten carbonate fuel cell power system is introduced. the development of the system, such as the improvement of cell components including electrodes and electrolyte, the fuel processing, the heat recovery, the power conditioning and grid interconnection, the control system and the combine generation
第五章在簡要敘述了熔融碳酸鹽燃料電池發電系統原理后，從以下幾個方面對系統的開發進行了論證:單體元件（電極和電解質）性能的提高，燃料的處理，余熱利用，電力調節和並網，燃料電池/燃氣輪機/汽輪機聯合發電以及系統控制與優化。Safety requirements of unitary air conditioners
單元式空氣調節機.安全要求Unitary air conditioners
單元式空氣調節機There is difference frequency measurement requirement for every part of pid regulating, difference between dynamic quality and static quality in response time and accuracy. according to these, it use the interrupt functions and high - speed counter of the simens s7 - 200 plc cpu226 basic unit and some peripheral circuit to measure frequency ; in software designed, the procedure frame of hydraulic - turbine governor and disperse process of parallel pid are analyzed, an improved pid algorithm is adopted to realize a pid regulation mode with variable structure and parameters ; the mechanical liquid - pressure system of the hydraulic - turbine governor is with electric - hydraulic converter unit of step motor. according to the drive character of five phase of response step motor, a variable frequency regulated voltage driver unit is designed in order to realize interface between plc and driver of step motor
本文利用s7 - 200plc自身的特點設計了頻率測量單元，根據pid調節各個環節的特點，以及調速器動態特性、靜態特性對頻率測量的實時性和精度要求的不同，利用s7 - 200plc基本單元中內置的高速計數器以及相應的外圍放大整形、分頻電路，實現了水輪發電機組頻率的測量；在軟體上，對微機調速器的整個程序框架、並聯pid的離散化過程進行了分析，選用改進的pid演算法實現了變參數、變結構的pid調節模式；調速器的機械液壓隨動系統具有步進電機電液轉換元件，採用五相反應式步進電機，根據其驅動特性設計了變頻調壓驅動器，實現plc與步進電機驅動器之間數字介面。The object to study in this paper is the electric heat reservoir boiler, which is used to supply heat water and bask for the resident population. the use of the system define the character of the output medium with the lower request on quality and parameter, at the same time, it ask the boiler should has the higher character on the respect of the cost, reliability, economy, and so on. hence, the paper carefully design and study the system for the choice and design of the boiler core heating componet, the lay of the heat exchanger, the working status of the heat reservoir equipment, the adjustment and control mode of to supply heat water. the study work mainly include underside some contents, forexample : 1. to confirm the heat medium parameter to adapt the requirements of the most of the heating equipments and to design the instruction of the boiler and heat reservoir as simple as possible
圍繞上述原則，本文從電熱鍋爐核心加熱元件的選型及設計、換熱面的布置、蓄熱設備的運行工況、供熱的調節方式以及控制方法進行了較細致的研究和計算，具體研究工作有以下幾個方面： 1 .根據使用要求，確定適用於多數採暖設備的熱介質參數，設計在結構型式上盡可能簡單的鍋爐和蓄熱器； 2 .對製造加熱元件電熱管的各種材料進行了對比和分析、在結構尺寸上進行了仔細的分析和計算，根據實際使用條件給出合理的設計，使其具有較高的可靠性和使用壽命； 3 .對不同換熱面布置形式進行傳熱分析。The main contribution of this dissertation is summarized as follows : 1. through improving the choice of learning rate and implementing online adjustment of control plus, a simple and rapid single - nerve adaptive control method with learning ability is proposed, the effectiveness of which is proved by simulation
論文的主要工作如下： 1通過對學習速率選取的改進和控制增益的在線調節，提出了一種簡便而快速的具有學習能力的單神經元自適應控制方法，模擬結果驗證了其有效性。After analyzed the basic principle of optimized noise reduction on tyre pattern, summarized three approaches to noise reduction. the first is trying to reduce size of single block or socket to reduce noise amplitude on time domain, the second is to adjust stripes sorting order and their interlace value to avoid noise - made by every single block - peak values on time domain overlayed and the last is to adjust ratio of blocks and sockets, ratio of stripe interval and stripe sorting order to avoid noise periodical distribution and abnormal high peak values in some frequency strip
論文第四章分析了輪胎花紋優化降噪的基本原理，總結出三條降噪途徑：在允許范圍內盡量減小單個塊或槽的大小、刻刀槽軟化花紋塊來減小噪聲時域波幅度；調整節距排列順序、花紋條之間的錯位值，使各發聲單元發出的聲壓時域波形的同向峰值錯開，避免同向峰值疊加；調整花紋塊和槽比例、節距比例、節距排列順序，盡量避免周期性分佈，使輪胎所發出的噪聲趨于白噪化，避免某些頻段的異常高峰值。Analogue amplifiers are used to adapt the output signal of dms force transducers to digital displays or downstreamed controlling units
模擬放大器用於調節dms力傳感器的輸出信號，使它適應電子顯示或後接的控制單元。According to the engineering experiences obtained from the laying of a jointless track of high - speed communication line - line 3 in dalian city, this paper introduces in general the laying technology, particularly the long rail welding, the construction site welding, seamless track spreading and trak controller laying, and discusses problems often occuring in long rail wedling and seamless track laying
摘要根據大連市快速軌道交通3號線一次性鋪設碎石道床無縫線路的工程實踐，介紹了長鋼軌基地焊接、單元軌節的工地焊接；無縫線路鎖定和鋼軌伸縮調節器的鋪設等技術，並對長鋼軌焊接和無縫線路鋪設中應注意的問題進行了探討。Packaging - complete, filled transport packages and unit loads - conditioning for testing
包裝.滿裝的運輸包裝件和單元貨物.試驗狀態的調節Then, as the substitute of the traditional pi controller, neuron adaptive psd controller is used to alternate the velocity loop of dc driver system, simulation results show that the super - shoot in new system is small and the performance in the way of anti - disturbance and anti - time - varying parameters are higher than the traditional pi controller and robustness of the dc driver system improved greatly, in addition, through analysis of the character of the neuron adaptive psd controller, the paper presents a neural network self - tuning control method for dc driver system in which the diagonal recurrent neural network is used to identify the plant to calculate the plant ' s sensitivity for psd controllers simulation results indicate that excellent static dynamic target was got with this control method and the performance of the system is improved greatly,
然後，應用單神經元自適應psd控制器改造調速系統的轉速環，代替傳統pi調節方式的轉速控制器。模擬表明，新系統在超調、抗負載擾動和參數時變方面性能優于的傳統的pi控制方式，系統的魯棒性增強。在分析單神經元自適應psd控制器特性后，本文提出用對角遞歸神經網路辯識控制對象，為psd控制器提供靈敏度參數，從而構成一神經網路自校正控制方案。In this paper, the author divides the digital governor as speed control unit, drive unit, electronic execution unit. for above three parts, the author also makes principle emulating from structure and function and constructs the hotspot information chain with next class hotspot information chain of specific functions
本文將電子調速器分為轉速調節單元、驅動控制單元、電動執行單元，對這些功能單元從結構、功能上進行原理模擬，建立單元的熱點信息鏈與具體功能建立二次熱點信息鏈。Results show that the energy saving effect of tsous reached 12. 69 % when the temperature was self - operated by 1. 3 the tsous with the maximum pcm content of 67. 96 % were prepared through this work, the value accord with the theoric adsorption amount
建立了自調溫單元的滲出穩定性檢測以及調溫效果、節能效果的評價方法。經檢測，自調溫單元的調溫量為1 . 3時可節能12 . 69 。分享友人