負載阻抗 的英文怎麼說
中文拼音 [fùzǎizǔkàng]
負載阻抗
英文
load impedance- 負 : Ⅰ名詞1 (負擔) burden; load 2 (虧損) loss 3 (失敗) defeat Ⅱ動詞1 [書面語] (背) carry on th...
- 載 : 載Ⅰ名詞(年) year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
- 阻 : 動詞(阻擋; 阻礙) block; hinder; impede; obstruct
- 抗 : Ⅰ動詞1 (抵抗; 抵擋) resist; combat; fight 2 (拒絕; 抗拒) refuse; defy 3 (對等) contend with...
- 負載 : [電學] load
- 阻抗 : [電學] impedance
-
A high impedance coupling device will limit loading.
一個高阻抗的耦合裝置將限制負載。And the basis of microstrip is recalled. after this, we analyzed and computed several microstrip resonators with ads, making impedance match between the resonator and impatt diode
然後利用ads軟體對幾種微帶諧振器進行了分析和計算,使雪崩二極體的負載阻抗與其匹配。Great intermittent noise, wide variety of impendence along with the load and great attenuation of signals have restricted the further utilization of power line
但是,電力線通信通道存在間歇性噪聲大、阻抗隨負載變化大、信號衰減大等缺點,嚴重製約了它的有效利用。The exportation resistance of a device work device with what link after loading the resistance s the certain connections for should satisfying, in order to prevent mount to load the appearance produce the obvious influence. with each other connect to say to electronics equipments, for example after signal connect the enlarger, ex - class to connect class, only behind first - degree importation resistance before larger than first - degree exportation resistance 5 - 10 times are above, can think the resistance to match good ; connect the box come saying, electronics tube the machine should choose to use with for the enlarger its output to carry the mark to call the resistance the box for, but transistor enlarger then have noing this restrict, can take officing why resistance of equal or approximate box
一件器材的輸出阻抗和所連接的負載阻抗之間所應滿足的某種關系,以免接上負載后對器材本身的工作狀態產生明顯的影響。對電子設備互連來說,例如信號源連放大器,前級連后級,只要后一級的輸入阻抗大於前一級的輸出阻抗5 - 10倍以上,就可認為阻抗匹配良好對于放大器連接音箱來說,電子管機應選用與其輸出端標稱阻抗相等或接近的音箱,而晶體管放大器則無此限制,可以接任何阻抗的音箱。The results show that the electron mean drift velocity is affected by the cathode radius, the impedance of the load diode, the inner radius of vanes and the input voltage
結果表明電子平均漂移速度決定於陰極桿半徑、負載二極體阻抗、陽極慢波葉片內徑和輸入電壓。To explain this, we ' re going to avoid the idea of impedance ( which has resistive, capacitive and inductive components, some of which vary in effect by frequency, thus varying the actual loading ) and use pure resistance to describe the concept
為了便於解釋,我們準備暫時避免使用阻抗這一概念,因為它有電阻性、電容性和電感性成分,而其中一部分會隨著頻率的變化而變化,從而改變了實際的負載。If line length is half wave at a certain frequency and both the load resistance rt and source resistance rs are higher than the characteristic impedance zo, then both the voltages at input and at load are maximum at that frequency and both the voltages at input and at load are minimum at half of that frequency
負載端電阻及電源電阻均高於傳輸線特性阻抗情況下,當線長為某頻率波長之半波,則輸入端與負載端電壓在該頻率均為最高,在該頻率之半時則電壓均為最低。If line length is half wave at a certain frequency and the load resistance rt is lower while source resistance rs is higher than the characteristic impedance zo, then both the voltages at input and at load are minimum at that frequency and both the voltages at input and at load are maximum at half of that frequency
負載端電阻低於傳輸線特性阻抗及電源電阻高於傳輸線特性阻抗情況下,當線長為某頻率波長之半波,則輸入端與負載端電壓在該頻率均為最低,在該頻率之半時則電壓均為最高。Strain - gauge load cell or force transducer, minimum load impedance 320r
應變測壓元件或傳感器的最低負載阻抗為320r 。Pic simulations are performed to determine gap scaling in a high density pegs. comparisons of simulation results with simply theory results and experiment results, indicate that the pegs gap is always equal to the critical gap for magnetic insulted electron flow. it is important to note that, the vacuum electron flow to the anode causes current loss and the
另外,根據模擬結果還得到了兩個重要結論:電流損失是由真空漂移電子的出現所造成的,電流損失的大小與負載阻抗成近似正比關系;負載阻抗等於peos的流阻抗時,負載獲得功率最大。Allowable load impedance
允許的負載阻抗Beam loading impedance
射束負載阻抗Antenna load impedance
天線負載阻抗Technically, the damping factor is the specified load impedance ( in use, that ' d be the speaker system ) divided by the amplifier ' s output impedance
技術上,阻尼因子就是指定的負載阻抗(實踐中,也就是揚聲器系統)除以放大器的輸出阻抗。Technically, the damping factor is the specified load impedance ( in use, that ' d be the speaker system ) divided by the amplifier ' s [ i ] output impedance [ / i ]
技術上,阻尼因子就是指定的負載阻抗(實踐中,也就是揚聲器系統)除以放大器的輸出阻抗。A pulldown resistor to the negative rail will allow the output to approach that rail ( provided the load impedance is high enough, or is also grounded to that rail ), but only slowly
一個下拉電阻器將允許輸出迫近迫近該電源軌(所提供的負載阻抗足夠高,或負載也是接地的) ,但這樣速度較慢。We can also see that because damping factor is a ratio that requires the load impedance to compute, it must be stated against some known impedance to be meaningful
我們還可以看到因為阻尼因子是一個比率值,而且需要負載阻抗已知才能夠進行計算,所以阻尼因子必須和某一已知的阻抗同時具明才有意義。The current in the dac ’ s output can drive the load, and the structure can save a buffer consisted of operational amplifier, so the structure can achieve high speed with no close - loop and feedback in this circuit
該10位分段式電流舵型數模轉換器的輸出端可直接用電流輸出來驅動負載阻抗,省去運算放大器構成的輸出緩沖,整個電路中沒有形成閉環和反饋,因此這種電路結構可以達到很高的速度。The mechanical impedance analyzing method utilized, the mathematical formula for the input impedance and transformer ratio of ultrasonic horn are built up, some vibration performance of ultrasonic horns are discussed under different load impedance, the relationship and applicational conditions between the transformer ratio of ultrasonic horn and the radiational impedance are analyzed
採用機械阻抗分析方法,建立了超聲變幅器的輸入阻抗和變幅比的數學表達式,討論了不同負載阻抗下超聲變幅器的振動性能,分析了超聲變幅器的變幅比與換能器輻射阻抗之間的關系及應用條件。Power : put to say to, and the sum settle the power to is just valid index sign that evaluate the to put the function. it points within the scope of certain of the wave lose true, and the make longer a work can biggest power of the output s. enlarger while connecting into the box of the different resistance that exportation power can have different, usually the enlarger can mark clearly its sum to settle the exportation resistance ; for example a sum that set enlarger while loading a resistance to settle the exportation power to the, and load the resistance to may increase the the above. because the power there is method of various marks, some and illegal factory to can have intention to exaggerate the data, purchase or choose the hour to want with physically hear the to take in to distinct, comparison
它是指在一定的諧波失真范圍內,功放長期工作所能輸出的最大功率。放大器在接入不同阻抗的音箱時的輸出功率會有所不同,通常放大器會標明其額定輸出阻抗例如一臺放大器在負載音箱阻抗為時的額定輸出功率為,負載阻抗為時就可能增加到以上。因為功率有多種標法,某些不法廠商會有意誇大數據,購買或選配時要以實際聽音加以區別比較。分享友人