負載電路效率 的英文怎麼說

中文拼音 [fùzǎidiànlùxiàolǜ]
負載電路效率 英文
load circuit efficiency
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 效 : Ⅰ名詞（效果; 功用） effect; efficiency; result Ⅱ動詞1 （仿效） imitate; follow the example of 2 ...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 負載 : [電學] load
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  • 效率 : productiveness; efficiency; productivity; workpiece ratio
  1. Based on the study of transferring characteristics of the lcc - type resonant voltage, the parameter combinations, which make widths and magnitudes of voltage pulses of resonant network adjustable, arededucedo when the following requirements are met : fn > 3, k > 3 or cp / cs > 8, the above circuit is of natural voltage - stabilized characteristics, thus open - loop control method for bucking voltage is presented and the experimental results verify that the method is feasible.,

    實測整機在額定負載時效率達到88以上。在研究lcc諧振網路電壓傳輸特性的基礎上，推導出滿足可變寬度和幅度的諧振網路輸出電壓脈沖列的參數組合。設計f n 3 、 k 3或c _ p / c _ s 8時，諧振網路具有自然穩壓特性，因此本文提出並實驗驗證了一種整機為降電壓時的開環控制策略。
  2. The soft switching, phase - shifted pwm and bi - directional dc - dc converter hang together, depress circuit switching loss and noise effectively, which provide condition to increase switch frequency, efficiency and reduce size and weight for the converter ; at the same time, it is proved the converter can achieve zvs in larger load variation, and the converter has the virtue of structure compact, voltage and current stress small such as ordinary hard switch converter

    該變換器把軟開關技術和相移控制pwm技術以及雙向dc - dc變換器技術有機結合在一起，有效地降低了電路的開關損耗和開關噪聲，為變換器裝置提高開關頻率、效率以及降低尺寸及重量提供了良好的條件;同時，能拓寬零電壓開關的范圍，使變換器在較寬的負載變化范圍內都能實現軟開關。
  3. The methods that can efficiently suppress the disturbance on gate of switching component of the inverter - bridge are synthesized. a dual - inductor output filter is employed to improve electromagnetic interference ( emi ), due to turn - on or turn - off of the power switches of the inverter, which may be lead loads into trouble

    本文詳細論述了1kva25hz新型鐵路信號電源和2kva高頻在線式ups的設計和調試工作，總結了幾種能夠有效抑制逆變橋功率開關管門極干擾的措施，並且運用一種雙電感結構的輸出濾波器來改善由逆變器功率管在開關過程中產生的、影響負載設備正常工作的電磁干擾。
  4. The typical performance characteristics include : line and load transient response, efficiency, output voltage ripple, quiescent current, maximum load current, output voltage temperature characteristics and the short

    其中，整體模擬指標包括:晶元線性調整率和負載調整率、轉換效率、輸出電壓紋波、晶元靜態電流、最大負載電流、輸出電壓溫度特性及短路負載電流。
  5. The basic idea is that increasing the equivalent harmonic impedance of power network by valid control of active filter, in order to enhance the performance of passive filter and damp the resonance between the passive filter and the equivalent inductance of the power network

    無源支路在補償無功功率的同時還可以濾除因非線性負載產生的特徵諧波電流，為了抑制無源支路跟電網等效電感產生的諧振現象以及改善無源濾波器的濾波性能，系統中採用諧振注入式有源濾波拓撲。
  6. The test results demonstrate that this prototype has excellent comprehensive performances such as small bulk, lower weight, high efficiency, high steady precision, fast dynamic response, wide range input voltage, good output waveforms, strong over - load and short - circuit ability, and strong function with different nature load and three - phase unbalanced load

    試驗結果表明，該變流器具有體積重量小、變換效率高、靜態精度高、動態響應快、輸入電壓變化范圍寬、輸出波形質量高、過載與短路能力強、帶不同性質負載和帶三相不平衡負載的能力強等優良的綜合性能。
  7. It comes to a pulse skipping mode in a low load condition to decrease power loss and increase the operation efficency

    電路的另一個特點是在輕負載時進入跨周期調制模式以減小功耗並提高效率。
  8. At first, the development and fundamental of monolithic switching power supply are presented in this thesis. then a novel monolithic switching power supply circuit only with four terminals is analyzed at detail. it uses pulse skip modulation and current - mode topology

    論文研究了一種作為psoc原型電路的四端單片開關電源電路，此電路採用新型的跨周期調制模式，與傳統的脈寬調制模式相比，提高了輕負載下的工作效率;整體控制迴路採用電流峰值控制模式。
  9. Its operation frequency is 1. 38mhz, with an integration of a power mosfet whose breakdown voltage is up to 50v. the allowable input voltage ranges from 2. 7v to 5. 5v and its output voltage can be programmed between - 2v and - 15v, additionally, the output current is in a 200ma range in typical application. to avoid the poor efficiency of the pwm control scheme at light load, a skip - cycle - mode operation is introduced that allows system ’ s efficient operation at the light load

    該電路工作頻率為1 . 38mhz ，內部集成耐壓50v的功率mosfet ，輸入電壓范圍2 . 7v 5 . 5v ，輸出電壓可在- 2v - 15v間連續可調，典型工作條件下輸出電流在200ma之內;同時，在輕負載下提供跳周期模式，具有很高的待機效率。
  10. Different distribution of power loss can be worked out by mathcad software based on the formula reasoning. the result of calculation is consistent with that of the experiment, which proves that this method is right. it is pointed out through the analysis of calculating data that the key to improve efficiency at the same output power is to decrease the peak current and rms current of power switches or the on - resistance of mosfet and windings

    由推導可得損耗計算公式，利用數學計算軟體計算出電路輸出從空載到410w阻性負載時損耗分佈變化，該結果與實驗數據基本相吻合，證實了這種方法的正確性；通過對計算數據的分析，指出了進一步提高效率的關鍵在於輸出相同功率時降低功率管的電流峰值和有效值，減小繞組和mosfet的導通電阻。
  11. The typical performance characteristics include : load transient response, efficiency, output voltage ripple, output voltage vs. load current, switching waveform, and soft - start time. the simulation results indicate that the ic has achieved the expectation, both function target and electrical characteristics. although there are unavoidable disadvantages of the project, it is a worthwhile and valuable experience

    在完成系統原理分析、總體架構設計及子電路設計的基礎之上，還應用hspice對各個子電路和整體電路進行了模擬驗證，其中，整體模擬指標包括:軟啟動時間、瞬態響應時間、轉換效率、輸出電壓與負載的關系、輸出電壓紋波、開關波形。
分享友人
分享到 Line

分享到臉書