軸突流 的英文怎麼說

中文拼音 [zhóuliú]
軸突流 英文
axonal flow
  • : 軸Ⅰ名詞1. (圓柱形的零件) axle; shaft 2. (對稱部分的直線) axis 3. (圓柱形的纏繞器物) roller; spool Ⅱ量詞(用於纏在軸上的線以及裝裱帶軸子的字畫)
  • : Ⅰ動詞1 (猛沖) dash forward; shoot out 2 (高於周圍) protrude; bulgeⅡ副詞(突然) abruptly; sud...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  1. Atp released from an axon was indeed triggering calcium influx into schwann cells

    釋出的atp的確引發了鈣離子入許旺氏細胞。
  2. Thus far we had confirmed that glia sense axon activity by taking in calcium

    至此我們確認了神經膠細胞是以鈣離子入細胞的方式感知的活動。
  3. ( 3 ) the most principal factors that influence the supersonic atomization process include the flow ratio of the gas - liquid metal ( gmr ) value, the flow of atomizing of gas and the range of the inverse vortex taper. the more of the value of three factors, the more advantage they are for the atomization and the more fine the powders are. ( 4 ) the produced powders are the best in efficient atomization efficiency, particle diameter, particle shape and dispersion when the solder alloy is zhl63a, atomizing medium is n2, the protrusion h = 6. 0mm, atomizing gas pressure p = 100mpa, over - heat temperature t = 167 ( t = 350 )

    研究結果表明: ( 1 )超音速霧化器的氣體場在導液管下端形成一個倒渦錐,在二維空間上呈對稱的雙峰分佈,負壓形成於這個倒渦錐內; ( 2 )修正後的霧化氣體速度公式可以滿足超音速霧化的要求; ( 3 )影響超音速霧化工藝最根本的因素有氣液質量率比( gmr )的大小、霧化氣體量和倒渦錐范圍,三個因素的值越大,對形成細粉越有利; ( 4 )在焊錫合金為zhl63a ,霧化介質微n _ 2 ,導液管出高度取h = 6 . 0mm ,霧化氣體壓力取p = 1 . 0mpa ,合金過熱度取t = 167 ( t = 350 )時,所制得的粉末在有效霧化率、顆粒球形度、粒度及其離散度三個方面綜合性能最好。
  4. Among them the flow pulse is more standing - out, which is the main reason of its not more widely used. because high flow pulse will lead to the worse of the smooth movement of hydraulic motor and pipe, also cause pressure pulse which lead to a high noise, and give the destructive damage to the axial, bearing, valve, the connect of pipe etc. how to make the flow pulse low has become the research of scholars of many country

    其中量脈動問題顯得尤其出,它嚴重製約著齒輪泵的應用,因為泵的量脈動大,不僅會使液壓缸運動的平穩性、液壓馬達回轉的均勻性性變差,而且會引起壓力脈動,進而使管道、閥門乃至整個系統振動(特別是在共振時) ,並發出很強的噪聲,這對承、管接頭及密封都有破壞性影響。
  5. In the proposed technique the bemf waveform of bldcm need to be measured in advance at first, through computer simulation and frame transformation, the optimum q - axis current command is achieved. in order to minimize the torque ripple, the d and 0 - axis current command should be zero. furthermore, through reference frame transformation from dqo - axis to abc - axis, we can get the optimum current command in static abc reference frame

    在這種控制方法中首先測量出電機的實際反電動勢波形,然後通過計算機擬合和坐標變換,求得產生恆定電磁轉矩所需的q,令i _ d ~ * = i _ 0 ~ * = 0 ,通過坐標變換,得到三相靜止坐標系a - b - c下的參考電i _ a ~ * , i _ b ~ * , i _ c ~ * ,利用電滯環控制來產生pwm信號,由於這種控制方法中電不會變,從而可以較好的抑制轉矩脈動。
  6. The mode competition is much improved. it may operated with a large electron beam radius, that means decreasing the space charge effects compared with a smaller radius beam with the same current, hence the rbwo may operated with a low axial guide magnetic field. besides, the rbwo with a sinusoidal corrugated coaxial structure is very easy to manufacture

    波紋內導體rbwo具有一些出優點:同結構中內導體的存在使系統的截止頻率顯著升高,使得系統尺寸可比普通波紋波導慢波系統大;具有很大的抑制模式競爭的能力和很高的功率容量;可以採用大半徑電子注,在工作電不變的情況下空間電荷效應大幅度降低,因而可以工作在低磁場狀態;此種慢波結構內導體上的波紋易於加工。
  7. In addition, whether and how the bl receptor photl regulate ca2 + - channels in the pm has not been investigated. in present study we aimed to identify ca2 + channels involved in bl signaling cascade. the patch clamp technique was applied to record the channels on the hypocotyl protoplasma of wild type and photoreceptor mutant of arabidopsis thaliana

    採用膜片鉗技術在擬南芥下胚原生質體質膜上記錄並鑒定到一種超極化激活的鈣離子通透性通道,對其特性分析發現photl - 5變體與野生型擬南芥的質膜鈣離子通透性通道電有顯著差異,該差異可能是二者對胞外鈣表現不同反應的原因。
分享友人