軸系吊架 的英文怎麼說

中文拼音 [zhóudiàojià]
軸系吊架 英文
shafting hanger
  • : 軸Ⅰ名詞1. (圓柱形的零件) axle; shaft 2. (對稱部分的直線) axis 3. (圓柱形的纏繞器物) roller; spool Ⅱ量詞(用於纏在軸上的線以及裝裱帶軸子的字畫)
  • : 系動詞(打結; 扣) tie; fasten; do up; button up
  • : hangsuspend
  • : Ⅰ名詞1 (用來放置東西或支撐物體等的東西; 架子) frame; rack; shelf; stand 2 (毆打; 爭吵) fight;...
  1. Fsb series fluoroplastic alloy pump is composed of pump body, impeller, back cover, seal, support, pump shaft, bearing, coupling, fasten bolt, nut and base plate

    Fsb列氟塑料合金泵由泵體、葉輪,后蓋,密封性,支,泵承,連器,緊螺栓,螺母,底板組成。
  2. Based on practical project of inspecting, appraising and reinforcing a main heavy factory building, especially its steel crane girder system, of the second steel mill belonging to taiyuan steel & iron corporation, whose technology renovation leads to increase tonnage of many heavy cranes and vertical load of frame - bent structure, first the structure and its members were investigated, inspected, calculated and analyzed, and their reliability was appraised respectively and the strengthening projects or the measures to remedy were given. then, in accordance with the requirement to strengthen the girders under non - stop production, the feasibility of strengthening the crane girders by adding steel diagonal braces underneath the existing girders has been studied by inspecting and evaluating the strengthening effect of the crane girders and comparing with other reinforcing scheme

    本文結合太鋼(集團)有限公司第二煉鋼廠主廠房由於生產工藝改造要求,加大多臺重型車噸位及bc跨( 1 ) ( 8 )線框排各層豎向(設備)荷載后,對廠房結構,尤其鋼車梁統進行檢測鑒定與加固設計的實際工程,首先對廠房結構進行了現場調研、技術檢查、測試以及內力和承載能力的計算與分析(考慮抗震) ,並根據檢測、計算與分析結果,對廠房結構、構件的可靠性進行了評定,並綜合提出鑒定結論和加固處理建議。
  3. Its mast can be installed in inclination according to the requirement of construction the angle between the axis of mast and vertical line should be 10, while the floor of cage always remains level

    列升降機無對重,導按施工需要而傾斜安裝導線與鉛垂線夾角10 ,但籠地板始終與水平面平行。
  4. The curve of arch rib, rib section bending, splice of rib sections, seperator of tube, bracing plates, bracing system, meeting of arch, concrete pumping, hangers, tie - rods, the tower of the cable crane and the guy ropes, technical specifications of cfst arch bridge are discussed

    對鋼管混凝土拱橋的拱線選用、鋼管節段彎制、節段拼接、管內分隔倉、綴板設計、聯結繫統、合龍設計及其細節、管內混凝土的泵送、桿、桿、纜索機與扣索塔、技術規范等12個問題進行了探討。
分享友人