輕載的 的英文怎麼說

中文拼音 [qīngzǎide]
輕載的 英文
low duty
  • : Ⅰ形容詞1 (重量小; 比重小) light 2 (數量少; 程度淺) small in number degree etc : 年紀很輕 be v...
  • : 載Ⅰ名詞(年) year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • : 4次方是 The fourth power of 2 is direction
  1. ; 1. the trend of the development of burden and light hanging basket in the cantalever construction of continuous rigid frame bridge has been prospected, the roof truss and cable - state composite hanging basket also has been designed by analyzing and comparing with other ones. 2

    對大跨度橋梁懸臂澆築施工各種形式掛籃施工工藝進行了比較和總結,對連續剛構橋懸臂澆築掛籃施工中重發展趨勢進行了展望,提出了一種用於解決重型懸臂澆築施工新型桁架斜拉式組合掛籃,並進行了可行性分析計算和設計。
  2. Choose two nodes on the edge of the structural to compare the results calculating by the finite element program midas, then we can draw a conclusion that these kinds of space truss systems is sensitive to the libration of the dynamic wind loads. to consider this factor is very necessary in the process of design, we will use the pulsant augmentation coefficient to realize it

    比較靜力風荷和動力風荷作用下有限元軟體計算結果,選取結構邊緣部分兩個節點,對比它們在兩種方法計算下最大位移計算結果。經過比較可以看出重量、頻率低、阻尼小柔性建築物對風荷橫向振動是很敏感,在進行工程設計時應該考慮這種因素,並可採用乘以風振系數等相應方法來加以體現。
  3. However, the efficiency of pwm at light load is low and the filter design of pfm is rather difficult due to the random characteristic of the frequency spectrum distribution

    採用相應調制方式ic品種繁多,各有千秋。但pwm在時效率較低,而pfm由於頻譜分佈隨機,不利於后續濾波器設計。
  4. The lightening design of vehicle should guarantee the strength, stiffness, mode and crashworthiness of the car body in the condition of raising train speed

    車體承結構量化,要保證車體強度、剛度、動態特性和耐碰撞性等滿足提速客車要求。
  5. Standard test method for dispensability of light - duty pressure - sensitive film tape

    壓敏膜帶非必需性標準試驗方法
  6. And also, the wear resistance at ambient temperature and of za27 alloyed with mn when lightly loaded is desirable but becomes worse at high temperature. the wear mechanism of the one mixed with both adhesive and abrasive wear under sliding friction conditions ( at high temperature )

    Si加入量為1 - 3時, za27合金磨損量最少,高溫摩擦性能最好;加入mn后, za27合金在低溫下耐磨性能較好,高溫耐磨性能不理想;在滑動摩擦條件下(高溫)磨損以粘著磨損和磨料磨損兩種方式共同存在。
  7. Controller can output four teams of light - load, half - load, and full - load and overload relay contact signal, and 010ma, 1010v or 010v analog signal

    可輸出滿四組繼電器觸點信號和010ma 1010v或010v模擬信號。
  8. In order to implement an energy - saving method which keeps iron loss equal to copper loss using variable - voltage in light load, induction motor parameter identification at any moment is a key problem

    對于調壓使銅損等於鐵損這一節能方法而言,在線辨識出電機參數是一個關鍵點。
  9. This paper studies the variable - voltage energy saving theory and its implementation for asynchronous motor with light load, compares several kinds of scheme of improving efficiency in detail and confirms the variable - voltage energy saving method, that is adjusting the input voltage by detecting the iron loss and copper loss of motor directly. in addition, the directness *, simpleness and availability of the method are verified by the emulational experimental results with simulink of the matlab. the circuit of the general inverter based on the tms320f240 dsp was used in this paper, and the practicable program was compiled

    本文分析了異步電動機時降壓節能運行原理,對幾種提高效率方案進行了比較,確定了通過直接檢測電動機鐵損和銅損來實時調節輸入電壓以達到高效節能目控制方法,應用matlab軟體對系統進行模擬,在基於tms320f240dsp通用型變頻器上編制了實用化程序,形成了完整樣機,對其進行了測試,並給出了試驗結果。
  10. Pwm converter has low efficiency at light loads and high amplitude harmonic. on the other hand, the control circuit and filter for pfm are much complex

    Pwm調制模式spic在下效率較低,控制脈沖諧波峰值較大; pfm控制電路較為復雜,后續濾波器設計困難。
  11. Dynamic presentation and discussion on the prospects of 21st century science fiction in chinese literature, guests will share their views on the " philosophical and literary element " in science fictions, relationship between literature and science in 21st century, science fantasy literature

    形式介紹與討論21世紀科幻文學發展前景,包括探討科幻文學中文以道、 21世紀文學與科學關系、科幻文學?
  12. Since kamen and vagena, many researchers have discussed it in theory and experiment method. the main content in this paper is to set forth the slamming press calculations in dnv rules, gl rules and lr rules and the requirements for slamming strengthened bow structure and some comparisons ; slamming strengthened bow structure design for a bulk is carried out using dnv rules, and comparisons among several design schemes is carried through when heavy loading draft status replaces light loading draft status in practice. the results from above have been applied in ship production ; it is significant for ship structure improvement latter to calculate slamming press with direct calculation method, and then to design bow structure with dnv rules

    本文主要內容是分別闡述dnv 、 gl 、 lr三種規范對底部砰擊壓力計算及底部砰擊加強結構設計一般要求並進行一些分析比較:用dnv規范對某型船( 27000t散貨船)進行具體底部砰擊加強結構設計,並就實際生產中產生吃水狀態改吃水狀態而出現幾種設計方案進行比較,其具體結果現已用於實際生產;用直接計演算法確定砰擊壓力,再用dnv規范進行底部結構設計,對於後續船改進均有指導意義。
  13. And the fuzzy control technology has been studied that reduce the stator terminal voltage to achieve higher power factor through testing power factor and using certain rules. the asynchronous motor intelligence operating control system plan design has been completed. simulation design and simulation experiment of the system has been carried on, and the simulation result indicated this intelligence control system has achieved the anticipated effect

    在分析電機功率因數角變化規律及功率因數角對晶閘管輸出電壓影響基礎上,提出了異步電動機在或空運行時通過檢測功率因數並經過一定規則降低定子端電壓來達到提高功率因數目模糊控制方法,完成了異步電動機節能運行控制系統軟硬體設計,並進行了系統模擬研究與實驗研究。
  14. The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced

    論文第二章首先簡單介紹了交流異步電動機變頻調速技術發展概況,在回顧電梯液壓控制系統節能技術基礎上,介紹了本課題研製「採用蓄能器液壓電梯變頻節能控制系統研究」基本原理,分析了動力系統在電梯轎廂上下行、重上下行等四種典型工況下基本工作狀態和工作方式;詳細地介紹了本課題節能系統液壓動力泵站結構設計和參數設計,重點研究了液壓動力泵站結構設計、液壓泵馬達可逆性問題及其選型設計計算、蓄能器迴路泄漏油損失機理研究及其補償裝置設計、蓄能器-泵馬達壓力能量轉換裝置設計、多功能集成控制閥組設計等內容;最後簡單介紹了本課題矢量控制變頻控制櫃外部附件電氣接線、計算機控制及數據採集系統硬體設計等內容。
  15. Standard specification for pressure - sensitive tape for light - duty packaging and general purpose masking

    包裝和一般遮蔽用途壓敏帶標準規范
  16. However, psm also have some disadvantages, for example, the output voltage ripple is large at light load and the system maybe produce radio frequency noise

    但psm也具有不可避免缺點:時輸出電壓紋波較大,且易引入音頻噪聲。
  17. The on - resistance of the synchronous rectifier is as low as 0. 4 ?. it has a very high efficiency even in the light load thanks to its low quiescent supply current

    整個晶元具有極低靜態電流,使得此晶元即使在輕載的時候也有很高效率。
  18. In the morning, not far from mikulino, where the wood ran close to the road, the cossacks of denisovs party had pounced on two french waggonloads of saddles, stuck in the mud, and had carried them off into the wood

    一早,才離開米庫林納村不遠,路邊就是森林,有兩輛車陷進泥里,車上是騎兵用馬鞍,傑尼索夫游擊隊易就截獲了這兩輛大車,然後把他們帶進林中。
  19. Through the loss model of lim, best efficiency control scheme is proposed based on the vector control, by which low efficiency of lim under light load or low speed is improved. the control scheme is proved effective through simulation under a specified speed - location curve

    通過建立電機損耗模型,在矢量控制基礎上設計了最優效率控制策略,解決了或低速運行時效率低下問題,通過指定速度位置曲線下模擬分析驗證了控制策略有效性。
  20. At one point early in the race the two tf106s ran close together on the circuit and jarno allowed ralf to pass so that he could take advantage of his car ' s lighter fuel load

    在比賽開始某個時間,兩輛tf106跑得很接近,而雅諾讓輕載的公主超越,以發揮公主油優勢。
分享友人