轉矩脈動 的英文怎麼說

中文拼音 [zhuǎnmàidòng]
轉矩脈動 英文
torque ripple
  • : 轉構詞成分。
  • : 名詞1. (畫直角或正方形、矩形用的曲尺) carpenter's square; square2. (法度; 規則) rules; regulations 3. [物理學] moment
  • : 脈名詞1. (動脈和靜脈的統稱) arteries and veins2. (脈搏的簡稱) pulse 3. (像血管的組織; 連貫成系統的東西) vein
  • 脈動 : [物理學] [天文學] pulsation; pulsing; pulse; ripple; impulsive motion; pulsating; panting; loping...
  1. Aiming at permanent brushless dc motor in mini - bev ( battery electric vehicle ) with torque ripple and violent noise during low speed running, the fuzzy control method is combined with slide mode control method to suppress the influence due to un - modeling parameters, and to ensure the robustness in the process of reaching slide mode plane

    摘要針對微型電車用永磁無別電轉矩脈動大、低速運行時噪聲明顯等主要問題,採用模糊控制和滑模控制相結合的方法,克服了未建模參數的影響,保證了滑模到達階段的魯棒性,同時抑制了轉矩脈動
  2. The experiment results indicate that this method is more effective in the brushless direct current motor ' s low speed torque ripple attenuation, and its more effective in improving system dynamic performance

    運行結果表明,此方案能有效地抑制無刷直流電機低速時的轉矩脈動,更好地改善系統的態性能。
  3. Compared with existing modulating method, torque ripple is greatly reduced by uniform modulating in one monocycle, increasing current slope of upcoming conducting phase instantaneously suppresses the torque ripple by 30 ’ during low speed with obviously lower initiating noise

    採用單周期內各功率管均衡調制的方式,不僅消除了反向電流,而且與其他調制方式相比,可使轉矩脈動較小。
  4. Torque ripple reduction in brushless dc motor drives using a buck converter

    變換器的無刷直流電機轉矩脈動抑制方法
  5. Two nonlinear simulation methods are designed by curve fitting method and anfis which seem simply and right in the simulation experiment. based on the model different control strategies also were realized in detail such as chopped current control ( ccc ), angular position control ( apc ), amplitude - change ccc and pi control. a simple torque sharing function ( tsf ) method and a tsf controller were designed which decreases torque ripple effectively

    文章中還建立一種基於模糊神經網路的非線性模型,並對比分析了三種方法,模擬中確定了電機的最優開通關斷角,在此基礎上實現了電流斬波控制、角度位置控制、變幅值電流斬波控制以及分段雙閉環pi控制,模擬結果表明,它實現了電機的正常運行,很好的抑止了電機轉矩脈動,同時有效地降低了噪聲。
  6. Secondly, the effects of the crest width of the back - emf waveform to the torque ripple in the 120 ? conduction mode are analyzed, among which the effects of the advance commutation angle to the torque ripple are quantificationally analyzed for the bldcm drives whose back - emf waveform crest width is less than 120 ?,

    其次分析了120導通方式下反電勢平頂寬度對轉矩脈動的影響,對于平頂寬度小於120電角的非理想梯形波反電勢,定量分析了換相超前角對換相轉矩脈動的影響。
  7. For the bldcm which has a pseudo - sinusoidal back - emf waveform, this dissertation presents a svpwm control method using six discrete position signals for minimizing the torque ripple. the main aspects for the implementation of this method are analyzed, including the initial orientation of the voltage vector, reasonable choice of the impedance angle and the advance commutation angle, and estimation of the successive rotor positions

    針對反電勢類似正弦的準正弦波反電勢無刷直流電機,本文提出一種基於六個離散位置信號的自同步svpwm (電壓空間矢量法)控制方法,用以削弱電磁轉矩脈動,分析了實現這種方法的主要控制環節,包括起時電壓空間矢量的初始定位,阻抗角與電流超前角的合理選擇以及連續子位置的估計等。
  8. The simulation results prove that this control technique can effectively minimize the torque ripple for the bldcm drives whose back - emf waveform crest width is less than 120

    模擬結果表明這種控制策略能有效地抑制反電勢平頂寬度小於120電角的無刷直流電機的換相轉矩脈動
  9. Furthermore, this dissertation also gives a comprehensive analysis and comparison to the torque ripple factor, torque - current ratio and other aspects for pseudo - sinusoidal emf bldcm drived by 120 conduction mode, 180 conduction mode and self - synchronous svpwm mode respectively. the simulation and the experimental results indicate that self - synchronous svpwm method is more effective for minimizing the torque ripple without any expense of the torque - current ratio when the crest width of the back - emf waveform is less than 107 electrical angles

    對準正弦波反電勢無刷直流電機在120導通方式、 180導通方式和自同步svpwm三種控制方式下的轉矩脈動系數、電流比等方面進行了全面的分析與比較,模擬研究和實驗結果表明,當反電勢的平頂寬度小於107電角時,採用自同步svpwm控制方法可以在不損失電流比的基礎上,更有效地抑制電磁轉矩脈動
  10. For the bldcm which has a general crest width of the back - emf waveform, two kinds of torque ripple conditions when drived by sine - wave current as well as by square - wave current are deduced based on the mathematical models. in addition, a comparison is carried out between these two conditions, which indicates that sinusoidal current driving is more favorable to minimizing the torque ripple when the crest width of the back - emf waveform is less than a certain value

    闡述了抑制齒槽措施對反電勢波形的影響,利用無刷直流電機的數學模型推導並比較了任意平頂寬度梯形波反電勢在正弦波和形波兩種電流驅下的電磁轉矩脈動情況,得出在梯形波平頂寬度減小到一定數值后採用正弦電流驅更有利於減小電磁轉矩脈動
  11. 3. with fourier decomposition, the main component of pulsating torque, torque ripple is studied. it can be determined that torque ripple is caused by harmonic order 6n under the usual common conditions

    3 、對造成轉矩脈動的主要成分紋波進行諧波分析,得出在一般假設情況下,無刷直流電機系統的紋波由電磁的6n次諧波造成的結論。
  12. The study has completed the design of two - phase inverter and made up of the two - phase inverter - motor system for experimental use it is a variable frequency adjustable speed system with a open - loop control of rotational speed, which consists of voltage - controlled oscillator circulating assign device inverter circuit and two - phase induction motor a accurate mathematical model is set based on the whole system, and simulator program of dynamic and steady condition is established, which is used to calculate the dynamic and steady performance by kron and symmetrical coordinate converter by simulator calculation and experimental research with specific parameter of the system, a comparison is made between predicted and experimental characteristics, experimental measurements are shown to compare closely with corresponding theoretical result it is compared with some variable frequency adjus table speed system comprising inverter and single - phase induction motor from the system efficiency torque pulsation and the effect of two - phase inverter capacitance based on the conclusion, harmonic cancellation pulse width modulation control of a two - phase inverter - fed induction - motor drive system is researched, which cancelled the low harmonic and improve the system performance

    通過對電機的kron變換和對稱分量變換,建立了系統較精確的數學模型,編制了系統態及穩態運行的模擬計算程序分別計算系統的態和穩態性能。通過對系統的具體參數進行了模擬運算和實驗研究,實驗和模擬結果進行比較,說明實驗和理論較為一致,並從系統效率、轉矩脈動及兩相逆變器電容的影響等方面與各種逆變器和單相異步電機組成的變頻調速系統加以比較。在此基礎上,對兩相逆變器供電-異步電機系統使用諧波抑制pwm控制進行了研究,由於減少了低次諧波,改善了系統性能。
  13. Analysis on commutation torque ripples of a pmbdc motor based on c - dump converter

    變換器供電的無刷直流電機換相轉矩脈動的分析
  14. Effectiveness of the proposed control method is verified through simulation

    模擬試驗證明所提出換相轉矩脈動抑制技術的有效性。
  15. An analysis and a compensation method for commutation torque ripple in trapezoidal bldc motor

    無刷直流電機換相轉矩脈動的分析及其補償方法
  16. Several strategies are shown in this thesis to minimize the torque ripple and achieve the performance. these strategies include dtc control of srm and a fuzzy - logic - based torque ripple reduction method for switched reluctance motors using a turn - off angle compensator approach. simulations show that these strategies can reduce the torque ripple

    本文介紹了能夠消除srm的轉矩脈動,提高srd性能的幾種新型控制策略,即srm的直接控制、基於模糊邏輯的關斷角_ ( off )的優化控制,並進行了模擬。
  17. Torque ripple minimization in permanent magnet synchronous motors based on neural networks

    基於神經網路的永磁同步電轉矩脈動補償
  18. Torque ripple minimization in direct torque control of a permanent magnet synchronous motor

    一種減少永磁同步電機轉矩脈動方法
  19. Finally, in order to reduce the torque ripple of srm the fuzzy - control system is established in which the torque - sharing current function is controlled to reduce torque ripple. at last the simulation results are given

    最後針對開關磁阻電機轉矩脈動較大的缺點,建立模糊控制系統,通過對?電流函數的控制來減小轉矩脈動,取得了較好的效果。
  20. A variable - speed dtc pmsm system is set up to verify the dtc theory in pmsm, that is to control the toque by controlling the torque angle of motor if the stator flux linkage keeps constant. this paper points out the function of the space voltage vector by which the torque angle can be changed according to the need of torque of the motor

    主要作了以下開創性的工作:系統地闡述了永磁同步電機直接控制理論,發展了原有的控制理論,明確了空間電壓零矢量在控制系統中的重要作用? ?保持電機輸出,減小轉矩脈動,據此提出了包括零矢量的新型控制方法。
分享友人