通信原理 的英文怎麼說

中文拼音 [tōngxìnyuánlǐ]
通信原理 英文
communication fundamentals
  • 通 : 通量詞（用於動作）
  • 原 : Ⅰ形容詞1 （最初的; 原來的） primary; original; former 2 （沒有加工的） unprocessed; raw Ⅱ動詞（原...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 通信 : communication; communicate by letter; correspond
  1. Abstract : in this paper, the significance of remote monitoring and fault diagnosis system for the pipe laying pump units in petroleum conveyance process is discussed. the communication principle and particular of remote monitoring and fault diagnosis system for pump units are analyzed. the hardware configuring and software algorithm of this system are constructed, and then, advantage and benefit out of this system are pointed out

    文摘:論述了原油輸運過程中的加壓泵機組遠程監測及故障診斷系統的意義，分析了輸油泵機組遠程監測及診斷系統的通信原理和特點，建立了實現該系統的硬體結構和軟體體系，最後說明了採用該系統的優勢。
  2. And the working principle and circuit makeup of the optical transceiver are analyzed in detail. secondly, according to the actual requirements, optical transmitter and optical receiver were designed into a small module to carry out low - rate optical transceiver. finally, fundamental parameters of the optical transceiver are tested under existing conditions

    本文在簡述光纖通信原理的基礎上，從最基礎的光有源器件工作原理、特性入手，重點闡述了光收發一體模塊電路結構以及工作原理，在此基礎上根據實際情況設計了光發送、接收電路，實現了低速率光收發一體模塊，並在現有條件下對該模塊進行了初步測試。
  3. According to the principle of spread spectrum communication, the anti - interference performance of the technology is discussed and the composition of power line spread spectrum communication is described. based on the spread spectrum technique, a method which is low cost, high communications quality and low bit error for power line carrier communication using single - chip software programming is proposed

    利用擴頻通信原理，分析擴頻通信的抗干擾特性，在此基礎上，闡述了電力線載波通信系統的基本結構，提出了一種利用軟體編程實現電力線載波擴頻通信的方法。該方法不增加硬體成本，即能達到提高通信質量、降低誤碼率的目的。
  4. Innovation in experiment teaching of communication principle

    通信原理實驗教學的改革
  5. The application of systemview software to communication principle experiment teaching

    軟體在通信原理實驗教學中的應用
  6. The design of computer simulation software of communication principles experiments using vc

    的通信原理實驗模擬軟體設計
  7. Application of computer simulation in communication principle experiment teaching

    計算機模擬技術在通信原理實驗教學中的應用
  8. On principle and theory of soliton communication in optical fibers

    光孤子通信原理與理論研究
  9. Analysis on network communication principle

    論網路通信原理
  10. Principle of communication technology

    通信原理與技術
  11. Paulraj a, et al. introduction to space - time wireless communications. cambridge : cambridge university press, 2003

    羅濤，樂光新.多天線無線通信原理與應用.北京郵電大學出版社， 2005年11月第1版，第4 ? 5章
  12. This paper mainly describes the principle of can and its characteristic, including the function of common - used chip, sja1000, produced by philips

    本文主要敘述了can總線網路通信原理和特點；及常用控制晶元- philips公司生產的sja1000的特點和功能。
  13. Chapter 2 explain the base of mathematics, the mode of system, the principle of communication and the principle of pn code, and go along analysis of mathematics

    第二章是擴展頻譜通信的數學基礎、系統模型、通信原理和偽隨機編碼原理，並進行了數學分析。
  14. First this chapter analyses the function of modem in theory, as well as communication principle of computer and modem. second designs program of serial communication using mscomm of vb 6. 0, by reason that mapbasic is the second development tool of mapinfo and a programmable language of developing map information applications, it is unable to directly read datas of serial port used by modem, unless by means of external program. finally using dde technology completes transmitting real - time orientation data between mapinfo and serial communication program of vb

    本章首先從理論上分析了modem功能及與計算機的通信原理；其次利用v86 . 0的通信控制項mscomm開發串列程序，由於mapbasic是mapinfo二次開發工具，是一種編制地圖信息應用程序的編程語言，不能直接讀取串列通訊埠數據，它必基於gsm網和pstn網的移動終端和遠程主機的實時數據通信系統的技術研究須藉助外部程序來完成與modem的串列通訊；最後利用ode技術來實現maplnfo與vb串列通信程序實時定位數據傳輸。
  15. In this paper, the structure and working principle of the system is studied, the principle of straight measured parameters, the mathematics model of the derived parameters and the discrimination of drilling states, as well as the principle of the hardware system designing are analyzed. also, the principle of long - distance data transmission is discussed ; meanwhile this system adopts gprs technology to transmit the datum of the drilling place. the software architecture, data flow, and the function model of the drilling states monitoring system are presented

    論文首先對系統的結構和工作原理進行了研究，分析了直測參數測量原理、派生參數和工況識別的數學模型及硬體系統設計原理，並對遠程數據通信原理進行了研究，系統首次採用gprs技術進行鉆井現場數據的遠程傳送；其次討論了現場監測系統的軟體體系結構、數據流程及功能模塊的設計；然後研究了異地監視系統的軟體體系結構，分析了幾種數據通信方法，並對解決系統實時性和生成歷史曲線的關鍵技術進行了深入的研究，最後對異地監視系統的功能模型進行了介紹。
  16. The design of vehicular - locating set is the primary content in this paper which is based on developing of gps / gsm supervising and dispatching system for vehicle. the vehicular - locating set ' s principle 、 features and hierarchy are disscused in detail, and the communication of the vehicular - locating set and supervise center is introduced emphatically. finally the technologies related to vehicle supervision and dispatch is forecast

    本論文以gps / gsm車輛監控調度系統的開發為基礎，以車載臺的設計為主要內容，詳細闡述車載臺的組成、定位原理，重點敘述了車載臺與監控中心的通信原理及實現方法，最後對車輛監控調度的相關技術作了展望。
  17. At last, the thesis studies the communication mode of pmac, including the analysis of the communication method between pmac and dpr, the communication method between pmac and host computer, and the analysis of the communication method between upper computers and lower computers, and the uses the visual c + + 6. 0 to exploit the upper computer software base the characters of communication methods

    最後對pmac的通信方式進行了分析，分析了pmac與dpr通信的方式， pmac與主機通信的方式，以及其上位機和下位機通信原理，並根據其通信方式特點利用visualc + + 6 . 0對五桿機構控制系統作了開發。
  18. Especially, we analyze the signals of the vsat system, including the network controlling signal and kinds of operation signals. we make use of serial communication to control demodulation terminials and use kinds of advanced technology such as multi - thread in windows 98 to improve the real - time performance

    總體上看，在信號分析過程中，我採用的對于帶偽隨機交織的卷積碼的分析方法是有一定獨創性的，其間涉及了很多數學知識和通信原理。
  19. The paper expatiates the characteristics and predominance of profibus, and analyses the protocol structure and communication principle in reference to the network structure of single master from the viewpoint of development and application. the solution is presented to realize profibus - dp, by the way of hardware and software realization

    本文系統全面地闡述了profibus現場總線的特點及其優勢，從開發與應用的角度，參考單主站profibus - dp網路的結構，詳細分析了profibus - dp的協議結構及通信原理，並在此基礎上給出了profibus - dp主站的硬體、軟體實現方法。
  20. The dissertation first analyzes the applied signification of pc communicating with dcs, then studies theory of interface ciu and methods of communication through it. the paper compares several identification methods and selects three methods based on ls, and discusses the methods to analyze the control system. at last, three functions above are synthesized into software

    論文分析pc機與分散控制系統通信，實現數據的延伸與共享所具有的實用意義；研究了計算機介面ciu的通信原理以及使用通信介面與系統進行通信的各種方案；深入學習系統辨識技術，採用基於最小二乘的三種經典方法對採集到的數據進行模型辨識；對系統分析方法進行了初步探討。
分享友人
分享到 Line

分享到臉書