連桿頭孔 的英文怎麼說
中文拼音 [liángǎntóukǒng]
連桿頭孔
英文
connecting rod eye-
In the simulation, the mpc technique of msc. nastran is used to simulate the mechanical behavior of contact between the interfaces of piston pin and bearing of small end, crankpin and big end bearing, connecting rod body and bearing cap ; also constraints are applied to the connecting rod reasonably
分析中採用了patran中的多點約束（ mpc ）技術，有效地模擬了活塞銷與小頭孔內表面、曲柄銷與大頭孔內表面以及連桿體與大頭蓋接觸面的力學接觸狀態，並對連桿進行合理的約束。The main popular theoretical method adopted to study end - plate connection is finite element technique under monotonic loading at present. this paper applies nonlinear ( material, geometry and contact ) finite element method to analyze the behaviors of connections under cyclic load at fist time. contact elements are set between end plate and column flange, screw cap and neighborhood plane, bolt bar and hole
對于端板連接的理論分析，目前國內外的研究主要局限在單向加載有限元分析范疇，本文首次採用三維非線性（包括材料、幾何與狀態非線性）有限元對端板連接進行了循環加載分析，端板與柱翼緣間、螺栓頭（帽）與相鄰板件間、螺栓桿與孔壁間都設置了反映邊界狀態的接觸單元。The problem of torque increase and drill fracture during the process of deep well drilling was analyzed, and a safety protection and control technique was introduced, where a torque sensor was fixed between drilling bar and motor axis, while an electromagnetic clutch was fixed in the transmission chain of feed system
摘要對深孔鉆削過程中出現扭矩增大及折斷鉆頭鉆桿問題進行了分析，介紹了一種鉆桿主軸與電機軸的連接中安裝扭矩傳感器，進給系統的傳動鏈中安裝電磁離合器的深孔鉆削安全保護與控制技術。
分享友人