連續電流模式 的英文怎麼說

中文拼音 [liándiànliúshì]
連續電流模式 英文
mode continuous current
  • : Ⅰ動詞1 (連接) link; join; connect 2 (連累) involve (in trouble); implicate 3 [方言] (縫) ...
  • : Ⅰ形容詞(連接不斷) continuous; successive Ⅱ動詞1 (接在原有的后頭) continue; extend; join 2 (...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : 模名詞1. (模子) mould; pattern; matrix 2. (姓氏) a surname
  • : 名詞1 (樣式) type; style 2 (格式) pattern; form 3 (儀式; 典禮) ceremony; ritual 4 (自然科...
  • 連續 : continuation; succession; series; continuity; continuing; running; continuous; successive; contin...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  • 模式 : model; mode; pattern; type; schema
  1. Depend on the comprehensive analysis and study of the structure, principle, and exterior characteristic of the motor, through the methods of system modeling and digital simulation analysis, two kind of control device that work for the low voltage ( lvdc ) and the high voltage ( hvdc ) in avigation are researched respectively. point to the control technique of close - loop speed stabilization at a limited adjustment speed range, we bring out the close - loop speed control method that using the rotor position sensor indirectly measure the speed of the motor

    在全面分析了稀土永磁無刷直動機的結構特點、工作原理、運行方以及外部特性的基礎上,通過系統建和數字擬分析,分別針對航空低壓直( lvdc )和高壓直( hvdc )兩種動機構用永磁無刷動機,在小范圍轉速調節下的閉環穩速控制技術進行了詳細理論研究,提出了利用轉子位置傳感器信號間接測量機轉速進行機轉速閉環穩速控制的策略。
  2. Design of current - mode filters based on electronically tunable doccii

    時間濾波器
  3. To avoid manual labor of chiseling - grossness, in the area of second - stage concrete construction, permanently non - removed metal molding boards nets are used as molding boards of first - stage concrete. substitution joints of reinforcing steel bars for traditional electric welding and usage of equipments for joints of reinforcing steel bars efficiently improve strength of junctions and rate of connecting reinforcing steel bars, and safety of construction and stability of quality, and greatly reduce cost. it ' s possible that three gorges project become top - ranking project in the world by study on systems engineering of high - strength concrete construction

    混凝土縫面處理採用高壓水沖毛技術,大大提高了施工工效,減少了倉面污染;板工程大量採用定型鋼板施工技術,提高了壩體混凝土成型質量和工程進度;在二期混凝土施工區域,為免除人工鑿毛勞動強度,採用永久性免拆金屬板網作為一期混凝土板;鋼筋接改進傳統的接方,採用大量採用鋼筋接頭機械接技術,有效提高了接頭強度和鋼筋接速度,施工安全性大大加強,質量穩定性有效提高,經濟成本大大降低;三峽二期工程持高強度混凝土施工系統工程的研究,使三峽工程成為名符其實的「世界一工程」成為可能;三峽二期工程混凝土溫控綜合技術的應用,有效降低了壩體混凝土溫度的產生;混凝土表面處理及裂縫處理技術的應用,提高了建築物的整體性和耐久性。
  4. The temperature range is - 30 ~ 80. the topology of the step - up dc / dc converters and its basic principle is first analyzed in this thesis. then based on the conventional pfm control scheme, a discrete pulse frequency modulation is presented and the state space average model related to the ccm ( continue current mode ) and dcm is established

    然後在傳統的脈沖頻率調制方的基礎上,分析了一種離散脈沖頻率調制方,並建立了這種調制方下升壓型dc / dc變換器在( ccm )工作( dcm )工作的狀態空間平均型。
  5. Current - mode continuous - time filters based on mocc

    時間濾波器
  6. Ogy method is applied to control the chaos exhibited by current - mode controlled boost dc - dc converter, as its chaotic regime has been established in this paper

    本文還使用參數微擾方法控制控制boost變換器在連續電流模式下產生的混沌行為。
  7. Based on the establishment of the mathematical model of the water - level controlling system, the boundary control equation of the stable domain of the continuous system and discrete system are found respectively, and the characteristic of stable domain of the two systems is analysed

    其目的是維持前池水位穩定,提高機組單位量出力,最大限度利用來水,從而提高站的經濟效益。在建立水位調節下調節系統數學型基礎之上,對、離散系統進行了穩定分析。
  8. Fully differential leapfrog - type current mode mocc - based filters

    時間雙積分器鏡濾波器設計
  9. From the view point of the whole topologies of current mode hfl inverters, two topologies of half - bridge and push - pull current mode hfl inverters are proposed, which are composed of four power switches. hfl inverters in discontinuous current mode ( dcm ) are extended to those in continuous current mode ( ccm )

    從完善路拓撲和降低成本的角度出發,本文提出了兩種結構的源高頻鏈逆變路,它們分別是由四個功率管組成的半橋和推挽雙向源高頻鏈單級逆變路,並將工作在的逆變路擴展到
  10. The components, working principle, advantages and defects of pwm power amplifier are introduced briefly in the dissertation. the working characteristics of h - bridge pwm power amplifier in double - polarity mode is analyzed qualitatively and qualitatively and the conclusion that fluctuant magnitude and continuousness of armature current are the essential parameters which can be used to evaluate pwm control modes

    論文簡要介紹pwm功率放大器的組成、工作原理、特點及存在問題;對常見h型雙極性pwm功率放大器的工作特性作了定性和定量的分析,指出了脈動量和與否是衡量pwm控制方案優劣的兩個本質參數。
  11. Become a kind of new electronics circuit - current - mode circuit. it is replacing the traditional design method of the voltage - mode in the high frequency high - speed signal processing realm 。 this thesis mainly discussed the modified second - generation current conveyors based on the current - mode kinds of new cuicuit components, they are stronger modified standard current - mode parts in fuctions on this foundation. mainly including the modified differential difference current conveyor ( mddccii ) 、 the fully balanced second generation current conveyor ( fbccii ) 、 ( full balances ) four - terminal floating nullor ( fbftfn ) and the current differencing buffered amplifier ( cdba ), they are all function very strong standard current - mode parts, they all can provide some circuit functions of better than general operation amplifier, because they have the voltage importation and the current importation, therefore use it since can carry out the voltage - mode signal processing circuit expediently, can also carry out the current - mode signal processing circuit expediently, and have to increase the benefit bandwidth to accumulate more widely than the voltage - mode, but have their advantages more according to the current - mode filter of the modified current conveyor, because it constitutes in brief, the filter wave function is stronger and they are better than in general use operation amplifier of many advantages, be easy to composing for example 、 high speed 、 frequency bandwidth 、 the power supply voltage requests low 、 consume small, the impedance is different from etc. advantages, otherwise they have biggish dynamic range, and flexible circuit synthesize, so they are the best active parts

    從第二代傳輸器ccii入手,重點研究了以下幾種改進型的第二代傳輸器:改進的差動差分傳輸器mddccii 、全平衡第二代傳輸器fbccii 、多輸出四端浮地零器ftfn 、全平衡四端浮地零器fbftfn 、差分緩沖放大器cdba的路結構及其型。然後在此基礎上系統地研究了基於這幾種改進型的第二代傳輸器的濾波器的設計方法,主要方法和結果如下:利用mddccii設計了差分時間低通、帶通濾波器;跳耦結構考爾低通濾波器;利用fbccii設計了帶通二階節濾波器及雙二階通用濾波器;設計了基於多輸出端ftfn的二階通用濾波器路;通過數字化開關選擇的基於fbftfn的通用濾波器;設計了基於最少個數緩沖放大器(兩個cdba )的多功能通用濾波器及其在非理想因素情況下分析。設計濾波器的主要方法是採用級聯設計、運算擬(信號圖法)和反饋設計(跳耦法) 。
  12. In the third chapter, a methodologies to realize second - order band - pass filter with which center frequency tuned in a wide range using mcdi ( multiple output current - mode differential integrator ), these two kinds of mcdi are composed of pmos and nmos input transistors respectively, lastly we compare these two integrators " merits and disadvantages

    第三章:提出了輸入級分別為pmos管、 nmos管的多輸出端全差分積分器,並由此構成了中心頻率可調的二階帶通濾波器,同時比較了二者的優缺點。
  13. Continuous conduction - ccm

  14. Its operation frequency is 1. 38mhz, with an integration of a power mosfet whose breakdown voltage is up to 50v. the allowable input voltage ranges from 2. 7v to 5. 5v and its output voltage can be programmed between - 2v and - 15v, additionally, the output current is in a 200ma range in typical application. to avoid the poor efficiency of the pwm control scheme at light load, a skip - cycle - mode operation is introduced that allows system ’ s efficient operation at the light load

    路工作頻率為1 . 38mhz ,內部集成耐壓50v的功率mosfet ,輸入壓范圍2 . 7v 5 . 5v ,輸出壓可在- 2v - 15v間可調,典型工作條件下輸出在200ma之內;同時,在輕負載下提供跳周期,具有很高的待機效率。
  15. First, the operational principle of the boost converter which includes continuous mode and discontinuous mode was analyzed as well as the basic theory about current mode and the circuit modulation which includes pulse width modulation ( pwm ) and pulse frequency modulation ( pfm )

    首先分析boost路的兩種工作,即連續電流模式和不連續電流模式,然後分析了目前應用比較廣泛的反饋控制,最後對頻率寬度調制( pwm )和頻率脈沖調制( pfm )進行了對比分析。
  16. This paper summarizes the design ways of active filter based on the current conveyors in detail, and three ways which can deduce current - mode continuous time filters from voltage - mode active filters

    全面歸納了基於傳送器的有源濾波器設計方法,研究了由有源rc濾波器導出使用傳送器( cc )的時間濾波器的三種不同的方
分享友人